Search results for "Sorptivity"

showing 10 items of 51 documents

3,3?,5,5?-Tetramethylbenzidme for the colorimetric determination of manganese in water

1998

Manganese can be determined by colorimetry with previous oxidation of Mn(II) in a strong basic medium, using 3,3′,5,5′-tetramethylbenzidine as a chromogenic reagent. The molar absorptivity of the reaction product is 3.4 × 104 mol−1l cm−1l, the detection limit 3 ng/ml, the RSD (0.5 mg/l,n = 8) 0.9% and the calibration range (1-cm cells) 0.02–0.8 mg/1 V(V), Cr(VI) and Co(II) are the most significant interferences. The new method was compared with an AAS procedure (air-acetylene flame) with previous solvent extraction and also with a colorimetric method for the determination of manganese in sea and drinking water.

Detection limitchemistryStereochemistryChromogenicReagentchemistry.chemical_elementSeawaterManganeseMolar absorptivityColorimetryAnalytical ChemistryReaction productNuclear chemistryMikrochimica Acta
researchProduct

Field testing parameter sensitivity of the two-term infiltration equation using differentiated linearization

2003

Knowledge of soil hydraulic conductivity in the vadose zone is important in many agronomic, engineering and environmental areas. Transient tension infiltrometer experiments can be used to estimate the hydraulic conductivity, K0, corresponding to a given pressure head by the single-test (TST) method that uses the coefficients C1 and C2 of the two-term infiltration equation. The “Differentiated Linearization” (DL) method has been proposed to estimate these coefficients when a layer of contact material is used for the experiment. A field test of the DL and TST methods was conducted on a sandy loam and a clay soil. Eliminating the early-time influence of the contact layer was easy when the sorp…

Capillary actionSorptivitySoil hydraulic conductivitySoil SciencePressure headInfiltration (hydrology)Hydraulic conductivitytension infiltrometerLoamVadose zoneSettore AGR/08 - Idraulica Agraria E Sistemazioni Idraulico-ForestaliInfiltrometerGeotechnical engineeringMathematics
researchProduct

Novel biomass fly ash-based geopolymeric mortars using lime slaker grits as aggregate for applications in construction: Influence of granulometry and…

2019

Abstract This work discusses the influence of the aggregate granulometry and the binder/aggregate ratio on the engineering properties of novel green geopolymeric mortars. Two wastes generated by a Portuguese Kraft pulp industry are employed to manufacture the material: lime slaker grits (used as aggregate) and biomass fly ash (to partially replace the metakaolin − 70 wt% substitution). The novel geopolymeric mortars could find innovative applications as sustainable construction materials. The studied mix design foresees the use of several grits granulometric ranges and ratios binder/aggregate to discuss workability, water sorptivity, and mechanical performance of the novel mortars. To date,…

Sorptivity0211 other engineering and technologiesSettore ICAR/10 - Architettura Tecnica020101 civil engineering02 engineering and technologyRaw materialengineering.materialGritGeopolymer0201 civil engineering021105 building & constructionGeneral Materials ScienceMetakaolinCivil and Structural EngineeringLimebusiness.industryBiomass fly ashBuilding and ConstructionConstruction materialMasonryPulp and paper industryMortarKraft processFly ashengineeringEnvironmental scienceMortarbusinessPaper-pulp industry
researchProduct

On Infiltration and Infiltration Characteristic Times

2022

In his seminal paper on the solution of the infiltration equation, Philip (1969), https://doi.org/10.1016/b978-1-4831-9936-8.50010-6 proposed a gravity time, tgrav, to estimate practical convergence time and the time domain validity of his infinite time series expansion, TSE, for describing the transient state. The parameter tgrav refers to a point in time where infiltration is dominated equally by capillarity and gravity as derived from the first two (dominant) terms of the TSE. Evidence suggests that applicability of the truncated two-term equation of Philip has a time limit requiring higher-order TSE terms to better describe the infiltration process for times exceeding that limit. Since …

Science & TechnologyEROSIONsorptivityHYDRAULIC CONDUCTIVITYINFILTROMETERInfiltrationEnvironmental Sciences & EcologyPARAMETERSSOILMODELPhysical SciencesLimnology[SDE]Environmental Sciencesddc:550Water ResourcesEQUATIONSettore AGR/08 - Idraulica Agraria E Sistemazioni Idraulico-ForestaliWATERsteady statetime domain validityMarine & Freshwater BiologyLife Sciences & Biomedicinehydraulic conductivityEnvironmental SciencesWater Science and Technology
researchProduct

Experimental Investigations and Ab Initio Studies of Tellurium(II) Dithiolates, Te(SR)2

1999

The reaction between Te(O(i)Pr)(4) and HSR offers a new and effective route to tellurium dithiolates, Te(SR)(2). Te(S(i)Pr)(2) (1) and Te(S(t)Bu)(2) (2) are stable compounds whereas Te(SPh)(2) (3) slowly decomposes at room temperature to give Te and Ph(2)S(2). IR spectra of 1-3 and ab initio calculations (HF/3-21G(d) and MP2 with double-zeta polarization effective core potential basis set) show nu(as)(Te-S) and nu(s)(Te-S) to be around 340 and 380 cm(-)(1), respectively. UV spectra exhibit similar lambda(max) (346-348 nm) for all three compounds, with the greater extinction coefficient of 3 accounting for its different and more intense color. Analysis of the molecular orbitals of the model …

ChemistryAb initiochemistry.chemical_elementInfrared spectroscopyMolar absorptivityInorganic ChemistryAb initio quantum chemistry methodsComputational chemistryPhysical chemistryMolecular orbitalIrradiationPhysical and Theoretical ChemistryTelluriumBasis setInorganic Chemistry
researchProduct

Dithienopyrrolobenzothiadiazole-based organic dyes for efficient dye-sensitized solar cells

2014

Four novel D–π–A metal-free organic dyes DTP1–4 containing a dithienopyrrolobenzothiadiazole (DTPBT) unit were synthesized and applied in dye-sensitized solar cells, where DTPBT was employed as a π-spacer for the first time. The photophysical, electrochemical and photovoltaic properties of the dyes were systematically investigated. The dyes DTP1–4 showed broad absorption spectra and high molar extinction coefficient, resulting in high light harvesting efficiency. In addition, the impacts of donors and the thiophene unit as an additional π-spacer were also studied. The results showed that the dye DTP4 with triphenylamine as the donor exhibited better photovoltaic performance than DTP1–3 with…

Materials scienceAbsorption spectroscopyRenewable Energy Sustainability and the EnvironmentPhotovoltaic systemEnergy conversion efficiencyGeneral ChemistryMolar absorptivityPhotochemistryTriphenylaminechemistry.chemical_compoundDye-sensitized solar cellchemistryPhenothiazineThiopheneGeneral Materials ScienceJ. Mater. Chem. A
researchProduct

Innovative Recycling of Lime Slaker Grits from Paper-Pulp Industry Reused as Aggregate in Ambient Cured Biomass Fly Ash-Based Geopolymers for Sustain…

2019

Lime slaker grits and biomass fly ash are solid wastes produced by the Kraft paper-pulp industry that are commonly disposed of in landfill. However, recent studies and European regulations discourage such disposal practices. This work investigates an alternative and innovative way to recycle and reuse these wastes in the production of green geopolymeric mortars intended for application in the construction industry. Here, biomass fly ash was used as the main source of alumino-silicate in the binder precursor (70 wt.% substitution to metakaolin), and grits (ranging from 1&ndash

constructionSorptivitygeopolymer concrete020209 energyGeography Planning and Developmentlcsh:TJ807-830lcsh:Renewable energy sourcesSettore ICAR/10 - Architettura Tecnica02 engineering and technology010501 environmental sciencesManagement Monitoring Policy and LawReuseengineering.materialrecyclinglime slaker grit01 natural sciences0202 electrical engineering electronic engineering information engineeringMetakaolinbiomass fly ashlcsh:Environmental sciences0105 earth and related environmental sciencesLimelcsh:GE1-350Waste managementRenewable Energy Sustainability and the Environmentlime slaker gritslcsh:Environmental effects of industries and plantspaper-pulp industryCompressive strengthlcsh:TD194-195Fly ashengineeringEnvironmental scienceMortarKraft paperSustainability
researchProduct

2012

Abstract. One of the major uncertainties in the understanding of Earth's climate system is the interaction between solar radiation and aerosols in the atmosphere. Aerosols exposed to high humidity will change their chemical, physical, and optical properties due to their increased water content. To model hydrated aerosols, atmospheric chemistry and climate models often use the volume weighted mixing rule to predict the complex refractive index (RI) of aerosols when they interact with high relative humidity, and, in general, assume homogeneous mixing. This study explores the validity of these assumptions. A humidified cavity ring down aerosol spectrometer (CRD-AS) and a tandem hygroscopic DMA…

Atmospheric Science010504 meteorology & atmospheric sciencesbusiness.industryChemistryScatteringMie scatteringAnalytical chemistry010501 environmental sciencesMolar absorptivity01 natural sciencesAerosolOptics13. Climate actionExtinction (optical mineralogy)Differential mobility analyzerRelative humiditybusinessMixing (physics)0105 earth and related environmental sciencesAtmospheric Chemistry and Physics
researchProduct

Changes in soil hydrodynamic parameters during intermittent rainfall following tillage

2023

The changes in the soil hydrodynamic properties following soil tillage were investigated in rainfall simulation trials of intermittent rain at the Masse experimental station (Soil Erosion LABoratory, SERLAB) in central Italy. The experiments were designed to build a database as representative as possible of situations that may occur in nature. The data collected during the experiments were used to determine the saturated soil hydraulic conductivity, Ks, the soil sorptivity at the antecedent soil–water matric potential Ψi, S, and the flow-weighted mean pore size at Ψi, λm. It was also verified if the energy content of total rainfall after tillage explained the short-term temporal variability…

Soil porosity SorptivityHydraulic conductivity Infiltration process Soil sealingHydraulic conductivitySoil sealingSoil porositySorptivityHydraulicSorptivitySettore AGR/08 - Idraulica Agraria E Sistemazioni Idraulico-ForestaliInfiltration processconductivityInfiltration proceEarth-Surface Processes
researchProduct

Dithienopyrrolobenzotriazole-based organic dyes with high molar extinction coefficient for efficient dye-sensitized solar cells

2016

Abstract Four novel organic dyes DT1-DT4 containing a dithienopyrrolobenzotriazole unit were synthesized and applied in dye sensitized solar cells, where dithienopyrrolobenzotriazole moiety was introduced as a π-spacer for the first time. The four dyes exhibited good light harvesting efficiency with high molar extinction coefficients and broad spectral response. The influence of the different electron donor on the photovoltaic performance was evaluated. The effects of the linear and branched alkyl chains in the π-bridge on the photophysical, electrochemical and photovoltaic performance were systemically investigated. The results show that branched alkyl chains are better than linear alkyl c…

chemistry.chemical_classificationOrganic solar cellProcess Chemistry and TechnologyGeneral Chemical EngineeringElectron donor02 engineering and technologyHybrid solar cellMolar absorptivity010402 general chemistry021001 nanoscience & nanotechnologyPhotochemistry01 natural sciences0104 chemical scienceslaw.inventionchemistry.chemical_compoundDye-sensitized solar cellchemistrylawSolar cellMoiety0210 nano-technologyAlkylDyes and Pigments
researchProduct