Search results for "Structural engineering"
showing 10 items of 1998 documents
Unexplored alternative use of calcareous sludge from the paper-pulp industry in green geopolymer construction materials
2020
Abstract Calcareous sludge is an alkaline waste produced by the paper pulp industry that is commonly disposed of in land-fill. However, recent studies and the European regulations discourage such practice. This work investigates an alternative and innovative way to recycle and reuse this waste, as filler, in the production of green geopolymeric mortars intended for applications in construction. This is the first time that this calcareous sludge is used to produce novel waste-based materials, in both construction and geopolymer technology. The novel alkali-activated mortar also uses biomass fly ash – another slightly investigated waste stream – to substitute the metakaolin (70 wt% substituti…
Practical Calculation Models for Column Footing and Comparison with Experimental Data
2017
In this paper, a simplified calculation model for the prediction of the load-carrying capacity of an RC column footing with a square cross section is presented. A detailed background of available experimental data and existing models for the prediction of the load-carrying capacity of slender and deep footings is presented. Cases of flexural failure and punching shear failures for slender footing and concrete strut crushing and tie yielding in deep members are analyzed. The aim of the paper is to propose a simple design formula for slender and deep footing verified by available experimental data and in agreement with other existing expressions. Expressions of the maximum mechanical ratio of…
Comparison of fully non-stationary artificial accelerogram generation methods in reproducing seismicity at a given site
2020
Abstract Seismic input modelling is a crucial step when Non-Linear Time-History Analyses (NLTHAs) are performed, the seismic response of structures being highly responsive to the input employed. When natural accelerograms able to represent local seismicity are not available, the use of generated accelerograms is an efficient solution for input modelling. The aim of the present paper is to compare four methods for generating fully non-stationary artificial accelerograms on the basis of a target spectrum, identified using seven recorded accelerograms registered in the neighbourhood of the construction site during a single event, assumed as target accelerograms. For each method, seven accelero…
Strategies of Identification of a Base-Isolated Hospital Building by Coupled Quasi-Static and Snap-Back Tests
2020
In this paper, the description of a series of quasi-static pushing tests and dynamic snap-back tests is proposed, involving the base-isolated emergency building of the Palermo university hospital. The base isolation system is characterized by a set of double-curved friction pendulum isolators placed on the top of the columns of the underground level, characteristics that cannot be found in the experimental studies available in the literature. The aim of the work was to investigate the static and dynamic properties of the building in question and comparing the in-situ results with the characteristics assigned during the design process and to assess the level of agreement. Static lateral push…
A Mechanical Approach for Evaluating the Distribution of Confinement Pressure in FRP-Wrapped Rectangular Columns
2019
In recent decades, fiber reinforced polymer (FRP) wrapping has become a common technique to retrofit reinforced concrete (RC) columns. Numerous research works have sought to verify analytically and experimentally its effectiveness in terms of enhancement of axial load bearing capacity and ductility. These studies highlighted that in the case of sharp-cornered sections, the maximum allowable confinement pressure is limited by premature failure at corners and, consequently, stress in the FRP, as well as the distribution of the confinement pressure, is not uniform. The prediction of this phenomenon is not straightforward, and existing theoretical studies propose complex numerical simulations, …
Making sense of crises: the implications of information asymmetries for resilience and social justice in disaster-ridden communities
2017
New information and communication technologies (ICT) have enabled communities to collect and share information and tap into a network of peers in unprecedented ways. For more than a decade, informa...
Removal of Hexavalent Chromium from Aqueous Solutions Using Biopolymers
2018
AbstractTwo biopolymers were prepared by reaction of chestnut and quebracho tannins with gelatin extracted from untanned hide wastes. Obtained biopolymers were evaluated as adsorbents for removing ...
Water retention and swelling behaviour of granular bentonites for application in Geosynthetic Clay Liner (GCL) systems
2016
Geosynthetic Clay Liner (GCL) systems are used as efficient hydraulic barriers in landfills for the disposal of hazardous municipal wastes. Along with geotextiles, bentonite materials are chosen as one of the primary components of GCLs due to their high retention, adsorption, and swelling capacities. GCLs are manufactured using bentonites at a high total suction and hydrated through the uptake of liquid from the subsoil and the confined material as soon as they are installed. Bentonites may exhibit considerable volume change upon wetting. Depending on the confinement stress, the void ratio may significantly increase with a decrease in suction, particularly at higher degrees of saturation. T…
Modelling load-transmission mechanisms in axially loaded RC columns retrofitted with steel jackets
2018
The use of steel jacketing technique is a common practice for retrofitting existing reinforced concrete (RC) columns, as it allows increasing load-carrying capacity and ductility of the member. When the external jacket has no-end connections – i.e. the jacket is indirectly loaded- the load sustained by the column is transferred from the inner RC core to the external jacket through shear stresses along the contact surface. The assessment of this mechanism is quite complex, due to the marked non-linear behaviour of constituent materials and to the calibration of a proper shear stress-relative slip constitutive law of the concrete-to-steel interface. In this paper, a step-by-step analytical ap…
Experimental study of a naturally weathered stiff clay
2016
Studying the shear strength of a naturally weathered clay is important to understand rain-induced slope failures in weathered soils. However, experimental studies on naturally weathered soils are limited. The paper focuses on the laboratory experimental investigation carried out to analyse the shear strength of a naturally weathered stiff clay that can be found in unsaturated conditions in situ. This has an important practical relevance in the evaluation of the stability conditions of natural slopes at clay outcrops. Different experimental techniques of suction measurement were used to obtain the soil-water retention curve of the clay over a wide range of suctions. Scanning electronic micr…