Search results for "Subcooling"
showing 5 items of 5 documents
On the effects of the Double-Walled Tubes lay-out on the DEMO WCLL breeding blanket module thermal behavior
2019
Abstract The EU-DEMO Water-Cooled Lithium Lead Breeding Blanket (WCLL BB) concept foresees liquid Pb-15.7Li eutectic alloy as breeder and neutron multiplier, whereas pressurized subcooled water as coolant, with operative conditions typical of the PWR fission reactors (temperature in the range of 295–328 °C and pressure of 15.5 MPa). The cooling down of the BB is guaranteed by means of two separated cooling circuits: the one consisted in square channels housed within the complex of Side Walls and First Wall, and the one composed of a set of Double-Walled Tubes (DWTs) submerged in the Breeding Zone (BZ) and deputed to remove heat power therein generated. A parametric thermal study has been ca…
Parametric study of the influence of double-walled tubes layout on the DEMO WCLL breeding blanket thermal performances
2020
Abstract Within the framework of the EUROfusion activities regarding the EU-DEMO Breeding Blanket (BB) concept, the University of Palermo is long-time involved, in close cooperation with ENEA, in the design of the Water Cooled Lithium Lead (WCLL) BB, that is one of the two concepts under consideration for the DEMO reactor. It is mainly characterized by a liquid lithium-lead eutectic alloy acting as breeder and neutron multiplier, as well as by subcooled pressurized water flowing as coolant under PWR-like conditions (pressure of 15.5 MPa and inlet/outlet temperatures of 295 °C/328 °C). A research campaign has been recently carried out to study the potential influence of the Breeding Zone coo…
Analysis of steady state thermal-hydraulic behaviour of the DEMO Divertor cassette body cooling circuit
2017
Abstract Within the framework of the Work Package DIV 1 – “Divertor Cassette Design and Integration” of the EUROfusion action, a research campaign has been jointly carried out by ENEA and University of Palermo to investigate the thermal-hydraulic performances of the DEMO divertor cassette cooling system. A comparative evaluation study has been performed considering the two different options under consideration for the divertor cassette body coolant, namely subcooled pressurized water and helium. The research activity has been carried out following a theoretical-computational approach based on the finite volume method and adopting a qualified Computational Fluid-Dynamic (CFD) code. CFD analy…
A Photographic study of subcooled flow boiling burnout at high heat flux and velocity
2007
Abstract The present paper reports the results of a visualization study of the burnout in subcooled flow boiling of water, with square cross section annular geometry (formed by a central heater rod contained in a duct characterized by a square cross section). The coolant velocity is in the range 3–10 m/s. High speed movies of flow pattern in subcooled flow boiling of water from the onset of nucleate boiling up to physical burnout of the heater are recorded. From video images (single frames taken with a stroboscope light and an exposure time of 1 μs), the following general behaviour of vapour bubbles was observed: when the rate of bubble generation is increasing, with bubbles growing in the …
Rewetting of a hot vertical surface by liquid sprays
2005
Hot surfaces rewetting interests several technological fields. A very important application is in nuclear reactors technology, where it governs the cooling of overheated fuel elements during hypothesized loss of coolant accidents (LOCAs). This phenomenon is also important in many normal processes and accidental situations taking place in conventional processes. For example when the integrity of metallic containers, filled by toxic or dangerous substances, is endangered by a hypothetical fire. The rewetting consists in the re-establishment of coolant in contact with metallic surfaces become dried due to high temperature. To this end cold liquid is injected on these surfaces via sprays or other …