Search results for "THERMOLUMINESCENCE"
showing 10 items of 85 documents
Study of the glow curves of TLD exposed to thermal neutrons.
2007
The glow curves of thermoluminescent dosimeters (TLD600, TLD700 and MCP), exposed to a mixed field of thermal neutrons and gamma photons are analysed. The fluence values of thermal neutrons used, comparable with those used in radiotherapy, allow one to define the reliability of the TLDs, in particular the most sensitive MCP, in this radiation field and to get information on the dose absorbed values. The glow curves obtained have been deconvoluted using general order kinetics and the observed differences for the different LET components have been analysed. In particular, the ratio of the n(0) parameter of two different peaks seems to allow to discriminate the different contributions of neutr…
Optical studies of Y3(Al,Ga)5O12:Ce3+,Cr3+,Nd3+ nano-phosphors obtained by the Pechini method
2019
The Y-3(Al,Ga)(5)O-12:Ce3+,Cr3+,Nd3+ (YAGG) nano-phosphors with homogeneous particle-size distribution, low aggregation and average crystalline size of about 65 nm were obtained using a modified Pechini method. Only slight aggregation of the crystallites occurs after post-annealing at 1100 degrees C. The intense Ce3+ bands in the excitation spectra of the Ce3+,Cr3+,Nd3+ co-doped materials monitoring the Cr3+ emission at 690 nm indicate energy transfer from Ce(3+ )to Cr3+. Weak Nd3+ lines are observed, as well. In addition, the emission of Nd3+ at 1060 nm with excitation of Ce3+ and Cr3+ confirms the Ce3+/Cr3+ to Nd3+ energy transfer. The short average luminescence decay times for the Ce3+ e…
The additive dose method for dose estimation in irradiated oregano by thermoluminescence technique
2009
The ionizing radiation treatment of food is nowadays a worldwide recognized tool for food preservation, provided that proper and validated identification methods are available and used. The thermoluminescence (TL) technique is one of the physical methods recommended by the European Committee for Standardization to distinguish irradiated from not irradiated samples, for food containing silicate minerals as contaminants, such as spices and aromatic herbs, which are among the most frequently irradiated foods. The experimental results presented in this work show that, at least up to the highest tested doses (2 kGy), it is possible to set up a procedure to estimate the actual dose in the irradia…
Magnetron sputtering fabrication of α-Al2O3:Cr powders and their thermoluminescence properties
2018
The authors gratefully acknowledge the financial support for this work from research grant ERA.NET RUS Plus Nr.609556.
Statistical methods for determining components non-liniarities, from thermoluminescent devices
2016
Thermoluminescent (TLD) dosimeters enjoy wide usage due to low cost and simplicity of use. They have however large errors at high doses in mixed-radiation fields, where non-linear effects occur. Algorithms based on the Akaike criterion [1] are presented for determining the maximal (physically meaningful) polynomial order with which the non-linearities are modeled. This depends on the number of points existing on a curve and on the points' errors.
Neutron–gamma mixed field measurements by means of MCP–TLD600 dosimeter pair
2007
Abstract In this paper, we compared the TL response of three types of thermoluminescence dosimeters, TLD600 (6LiF:Mg,Ti), TLD700 (7LiF:Mg,Ti) and MCP (LiF:Mg,Cu,P) after exposure to a n–γ mixed field in the fluence range of radiotherapeutic applications. Since a dosimeter pair is required to discriminate the two components of the mixed field, we analyzed the ability of each dosimeter pair to provide the fluence value in the mixed field. At this aim we performed a 60Co–γ calibration and a neutron calibration for all three dosimeter types. Finally, a blind test was performed in order to analyze the accuracy of each dosimeter pair and we found that in this mixed field the fluence value obtaine…
Thermoluminescence response of sodalime glass irradiated with proton and neutron beams
2012
In the research field of emergency dosimeters to be used in case of accidental radiation exposure of the population, watch glass has been considered as a possible fortuitous dosimetric material. This paper reports on results obtained by thermoluminescence of glass samples exposed to neutron and proton beams. Thermoluminescent glow curves have been analyzed for each irradiation studying the modifications induced by the irradiation as a function of proton dose or neutron fluence. The glow curve in a specific temperature range has been used as dosimetric parameter. The thermoluminescence response of samples exposed to protons has been found to be linear in the dose range between 2 and 20 Gy an…
Basic study of influence of radiation defects on tritium release processes from lithium silicates
1997
The radiolysis of Li2SiO3 and Li4SiO4 was studied using the chemical scavengers method (CSM), thermoluminescence, lyoluminescence, electron spin resonance and spectrometric methods. The influence of the absorbed dose and many another parameters such as: irradiation conditions, sample preparation conditions and concentration of impurities on the accumulation rate of each type RD and RP were studied. Several possibilities for reducing the radiolysis of silicates were discussed. It has been found that tritium localization on the surface and in grains proceed by two different mechanisms. Tritium thermoextraction from the surface proceeds as chemidesorption of tritiated water, but from the bulk …
Luminescence and photo-thermally stimulated defect creation processes inPbWO4:Mo,La,Y (PWO III) crystals
2015
Photoluminescence, thermally stimulated luminescence and electron spin resonance are studied for a PbWO4 crystal grown by the Czochralski method at Bogoroditsk Technical Chemical Plant, Russia from the melt with a precise tuning of the stoichiometry and co-doped with La3+, Y3+, and Mo6+ ions. Photo-thermally stimulated processes of electron and hole centers creation under selective UV irradiation of the crystal in the 3.5–5.0 eV energy range and 85–205 K temperature range are clarified and the optically created electron and hole centers are identified. The electrons in this crystal are found to be mainly trapped at the (MoO4)2− groups as well as at the (WO4)2– groups located close to single…
Photosensitivity of silica glass with germanium studied by photoinduced of thermally stimulated luminescence with vacuum ultraviolet radiation
2003
Photosensitivity of the germanium-doped silica was studied through kinetics of recombination of the created defects in isothermal and thermally stimulated luminescence (TSL) regimes. The main observed luminescence contains bands mainly due to Ge oxygen deficient center. The maximum of photosensitivity corresponds to the high-energy part of the 7.6 eV band. The growth of TSL intensity is almost linear for the case of excitation through monochromatic light and growth with saturation in the case of excitation with white light. The efficiency of formation of TSL peaks increases with an increase of the temperature. The result was explained as multi-step process of photochemical dissociation and …