Search results for "TTR"

Currents Distribution During a Fault in an MV Network: Methods and Measurements

2016

When a single line to ground fault happens on the MV side of a HV/MV system, only a small portion of the fault current is injected into the ground by the ground-grid of the faulty substation. In fact the fault current is distributed between grounding electrodes and MV cables sheaths. In systems with isolated neutral or with resonant earthing this may be sufficient to provide safety from electric shock. Experimental measurements were performed on a real MV distribution network: a real single line to ground fault was made and fault currents were measured in the faulty substation and in four neighboring substations. In this paper the problem of fault current distribution is introduced, the tes…

Magnons at low excitations: Observation of incoherent coupling to a bath of two-level systems

2019

Collective magnetic excitation modes, magnons, can be coherently coupled to microwave photons in the single excitation limit. This allows for access to quantum properties of magnons and opens up a range of applications in quantum information processing, with the intrinsic magnon linewidth representing the coherence time of a quantum resonator. Our measurement system consists of a yttrium iron garnet (YIG) sphere and a three-dimensional (3D) microwave cavity at temperatures and excitation powers typical for superconducting quantum circuit experiments. We perform spectroscopic measurements to determine the limiting factor of magnon coherence at these experimental conditions. Using the input-o…

Partial Discharge on-line measures in cable's EPR insulation

2004

In this paper, an experimental study, carried out on an operating MV cable, is presented. The aim is to identify, locate and characterize defects in the cable's EPR (ethylene-propylene copolymer rubber) insulation. Direct partial discharge measurements have been compared to those obtained by high frequency electromagnetic field measures. The latter have been carried out using a sensor which does not require any galvanic connection with the system under test and that performs an intrinsic localization of the defect. Moreover, an analysis of an MV cable junction has been carried out using the same tools.

The role of yttrium and titanium during the development of ODS ferritic steels obtained through the STARS route: TEM and XAS study

2018

Abstract Oxide Dispersion Strengthened Ferritic Steels (ODS FS) are candidate materials for structural components in future fusion reactors. Their high strength and creep resistance at elevated temperatures and their good resistance to neutron radiation damage is obtained through extremely fine microstructures containing a high density of nanometric precipitates, generally yttrium and titanium oxides. This work shows transmission electron microscopy (TEM) and extended X-ray absorption fine structure (EXAFS) characterization of Fe-14Cr-2W-0.3Ti-0.24Y ODS FS obtained by the STARS route (Surface Treatment of gas Atomized powder followed by Reactive Synthesis), an alternative method to obtain O…

Computer-aided analysis and design procedure for rotating induction machine magnetic circuits and windings

2018

The aim of this study is to present a new, accurate, and user-friendly software procedure for the analysis and rapid design of rotating induction machine windings, considering both the electric and the magnetic specifications of the machine itself. This procedure is a valid aid for quick first stage design without the necessity of using finite element method (FEM)-based design procedures. FEM can be used in a second design phase in order to refine the first stage results. The design procedure is hereafter outlined and some examples show its capability.

Experimental Validation of Maximum Constant Boost Control and Switching Frequency Optimal for three-phase Quasi-Z-Source Converters

2020

This paper presents a modified modulation scheme for quasi-Z-Source converters, based on the Maximum Constant Boost Control (MCBC) concept and Switching Frequency Optimal (SFO) as reference signal. The effectiveness of the proposed technique is validated by comparing the obtained results (in terms of AC harmonic content and voltage stress) with those carried out from traditional modulation schemes. For this reason, a test bench has been assembled and the benefits of the SFO MCBC modulation scheme have been valuated.

FPGA-based concurrent watchdog for real-time control systems

2003

A straightforward and efficient implementation of a custom concurrent watchdog processor for real-time control systems is presented. Emphasis is given to the techniques used for on-line checking the main processor activity without adding overhead, and to the advantages of a field programmable gate array implementation.

Causal and Non-Causal Frequency Domain Assessment of Spontaneous Baroreflex Sensitivity after Myocardial Infarction

2020

Acute myocardial infarction (AMI) is thought to alter the baroreflex control of arterial pressure. We tested this hypothesis investigating the changes of the cardiovascular response after AMI in comparison with young and old healthy controls studied at rest and during head-up tilt, using causal and non-causal frequency domain measures of the baroreflex sensitivity. Our results indicate: (i) the importance of using a causal approach that takes into account not only feedback but also feedforward effects in the study of interactions between the heart period and the arterial pressure; (ii) the compromised capacity of baroreceptors to control SAP fluctuations in post-AMI patients, both at rest a…

Vanhempien lastensa koulumenestystä koskevat kausaaliattribuutiot lapsen siirtyessä esikoulusta kouluun : muutos, pysyvyys ja taustalla vaikuttavat t…

2002

DEVELOPMENT ANALYSIS OF SMART DISTRIBUTION GRIDS IN PRESENCE OF DISTRIBUTED GENERATION

The integration of distributed generation (DG) units in power distribution network has become increasingly attractive multi-faceted paradigm as economic and environmental factors drive new technologies to be more efficient and less polluting than their earlier counterparts. The installation of DGs impacts critically on the planning and operating characteristics of the distribution network. Type, location, number and capacity of DG are essential factors for studying the effect of DGs on the system behavior. Some possibilities to handle grid planning and operating issues are addressed in this thesis. Firstly, the effect of DG on the power losses of a distribution network is introduced and the…