Search results for "Technology"

Physical properties and microstructure characteristics of (1–x)BaTiO3–xCaTiO3 systems

2018

The study investigates the microstructure, thermal and mechanical properties of (1–x)BaTiO3–xCaTiO3 ((1–x)BT–xCT)) (x = 0.01, 0.04, 0.08) samples. The BT–CT system to be tested was formed as a soli...

Spark Plasma Sintering à partir de poudres mécaniquement activées : compréhension des transitions de phase au cours d'un frittage réactif

2007

International audience; À " basse température " (entre 400 et 600 ◦C), l'oxydation de MoSi2 entraîne sa désintégration en poudre (phénomène de " peste "). De récents travaux ont montré que l'utilisation de MoSi2 dense et nano-organisé permettrait de ralentir ce phénomène de " peste ". Le défi de produire des matériaux denses et nano-organisés peut être relevé par le frittage " flash " réactif sous champ électrique à partir des poudres mécaniquement activées (Mechanically-Activated Spark Plasma Sintering, MASPS). Le contrôle de la composition et de la microstructure du composé intermétallique MoSi2 nécessite de déterminer les paramètres du frittage SPS (température, rampe de montée en tempér…

Electrical transport in lead-free (Na0.5Bi0.5)1–xSrxTiO3 ceramics (x = 0, 0.01 and 0.02)

2017

Lead-free (Na0.5Bi0.5)1xSrxTiO3 (x = 0, 0.01 and 0.02) ceramics were manufactured through a solid-state mixed oxide method and their ac (σac) and dc (σdc) electric conductivity were studied. It is ...

Ab initio calculations of CaZrO3, BaZrO3, PbTiO3 and SrTiO3 (001), (011) and (111) surfaces as well as their (001) interfaces

2019

We carried out ab initio calculations for technologically important ABO3 perovskites, like, CaZrO3, BaZrO3, PbTiO3 and SrTiO3, their (001), (011) and (111) surfaces as well as (001) interfaces. For...

MeV-energy Xe ion-induced damage in LiF: The contribution of electronic and nuclear stopping mechanisms

2016

The contribution of electronic and nuclear damage mechanisms in the modification of structure and micromechanical properties of LiF crystals irradiated with 52, 224, and 450 MeV Xe ions at fluences 1010–1014 ions cm−2 has been studied. The ion-induced formation of dislocations and hardening in LiF at fluences above 1010 ions cm−2 has been observed. The depth profiles of nanoindentation show a joint contribution of electronic excitation and nuclear (impact) mechanisms to the ion-induced hardening. The electronic excitation mechanism dominates in the major part of the ion range while the impact mechanism prevails in a narrow zone at the end of the ion range. The efficiency of hardening produc…

Space charge accumulation in undersea HVDC cables as function of heat exchange conditions at the boundaries – water-air interface

2020

Transmission lines with undersea HVDC cables are an interesting technological solution for the supply of electrical energy to islands. The accumulation of space charge inside the dielectric layer of a HVDC cable is one of the most important element to consider in its design and during operation. The formation of space charge is due to various factors including the high dependence on the temperature of the electrical conductivity of the insulation and the establishment of a thermal gradient under load conditions. This research is focused on the space charge accumulation phenomenon around a section of a HVDC cable half dipped in water and half in air. Due to the high difference in thermal con…

Electromagnetic and Thermal Modelling for Calculating Ageing Rate of Distribution Transformers

2018

Prediction of the lifetime for transformers is very important for maintenance and asset management. Finite element analysis was performed on a 5 MVA distribution transformers with aluminium foil-type windings and voltage rating 6600 V/23000 V. Electromagnetic modelling is implemented on the full three-phase transformer to calculate distributed losses, taking the skin effect into account. To reduce the computational burden, the distributed losses in one phase are used to analyse temperature rise in one phase of the transformer. The temperature rise results were used to determine the ageing rate of the transformer. Further, the influence of ambient temperature and cooling on the temperature r…

Contributed Review: Review of thermal methods for space charge measurement.

2016

The space charge accumulation phenomenon has garnered great interest over the last two decades because of the increased use of direct current in high voltage electrical systems. In this context, a significant relevance has been achieved by the thermal methods, used for solid dielectrics. This paper presents a review of this non-destructive measurement system used for the measurement of space charge. The thermal pulse method, the thermal step method, and the laser intensity modulation method are described. For each configuration, the principle of operation, the thicknesses analyzed, and the spatial resolution are described, reporting also the main related applications

The effect of curing conditions on the electrical properties of an epoxy resin

2016

Ab Initio Modeling of Y and O Solute Atom Interaction in Small Clusters within the bcc Iron Lattice

2018

This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the Euroatom research and training programme 2014–2018 under grant agreement No 633053. The authors are indebted to A. Möslang and P. V. Vladimirov for stimulating discussions. The views and opinions expressed herein do not necessarily reflect those of the European Commission.