Search results for "Thermal"
showing 10 items of 3576 documents
Low-temperature Zr mobility: An in-situ synchrotron-radiation XRF study of the effect of radiation damage in zircon on the element release in $H_{2}O…
2006
The release of Zr, U, and Pb from nearly metamict zircon and its recrystallized analog and of Zr from fully crystalline and slightly radiation-damaged zircon in H 2 O + HCl ± SiO 2 fluids was investigated in situ at temperatures between 200 and 500 °C using a hydrothermal diamond-anvil cell and time-resolved synchrotron-radiation XRF analyses. Dissolution of nearly metamict zircon proceeded much faster than that of zircon with little or no radiation damage and resulted in a 1.5 to 2 log units higher Zr molality in 6 to 7 m HCl fluids. Extensive recrystallization of the almost fully amorphous material started at 260 to 300 °C in H 2 O + HCl, and at about 360 °C if quartz was added, and was c…
Role of Water During Crystallization of Amorphous Cobalt Phosphate Nanoparticles
2016
The transformation of amorphous precursors into crystalline solids and the associated mechanisms are still poorly understood. We illuminate the formation and reactivity of an amorphous cobalt phosphate hydrate precursor and the role of water for its crystallization process. Amorphous cobalt phosphate hydrate nanoparticles (ACP) with diameters of ∼20 nm were prepared in the absence of additives from aqueous solutions at low concentrations and with short reaction times. To avoid the kinetically controlled transformation of metastable ACP into crystalline Co3(PO4)2 × 8 H2O (CPO) its separation must be fast. The crystallinity of ACP could be controlled through the temperature during precipitati…
Complex formation of copper( ), nickel( ) and zinc( ) with ethylophosphonoacetohydroxamic acid: solution speciation, synthesis and structural charac…
2019
We present herein the thermodynamic and X-ray characterisation of a novel ethyl phosphonohydroxamic acid-based Cu( ) metallacrown, predominating in solution in a broad pH range.
Hydrothermal growth mechanism of SnO2 nanorods in aqueous HCl
2018
Abstract Rutile-type nanorods of SnO2 were obtained in a one-pot hydrothermal synthesis starting from SnCl4·5H2O and HCl in a temperature range between 200 and 240°C. Although the nanorods are polydisperse, the average length of the nanorods could be adjusted from 13 to 65 nm by varying of the reaction temperature. The resulting anisotropic nanocrystals were characterized using powder X-ray diffraction (PXRD), (high resolution-) transmission electron microscopy (HR-TEM), and selected area electron diffraction (SAED). The particle growth proceeds via a dissolution-recrystallization process with soluble [SnCl5(H2O)]− intermediates, as confirmed by PXRD, Raman spectroscopy, and magic angle spi…
Extended Investigation of the Aqueous Self-Assembling Behavior of a Newly Designed Fluorinated Surfactant
2009
The physicochemical behavior of the newly synthesized fluorinated 5-hydroxyamino-3-perfluoroheptyl-1,2,4-oxadiazin-6-one (PFHO) surfactant was investigated. Thermal analysis showed that the pure surfactant is thermally stable under an inert atmosphere to 135 degrees C, which is several degrees higher than the melting point (99 degrees C). PFHO is rather active at the water/air interface where it assumes a standing up configuration. It exhibits an enhanced self-assembling behavior; accordingly, the critical micellar concentrations at some temperatures are 2 orders of magnitude lower than those of a similar surfactant having the same phobicity, such as sodium perfluorooctanoate. Even in the d…
Solubilization of an Organic Solute in Aqueous Solutions of Unimeric Block Copolymers and Their Mixtures with Monomeric Surfactant: Volume, Surface T…
2008
The ability of aqueous systems, formed by unimeric copolymers and their mixtures with a monomeric surfactant, in solubilizing large quantities of 1-nitropropane (PrNO2) was explored. The copolymers are F68 and L64, which differ for the hydrophilicity, and the surfactant is sodium dodecanoate. For a better understanding of the mechanism of solubilization, thermodynamic (volume and differential scanning calorimetry), spectroscopy (steady-state fluorescence), viscosity, and interfacial investigations were carried out. PrNO2 causes the micellization of the unimeric copolymer, and the required amount of PrNO2 depends on the composition, the copolymer nature, and the temperature. Large quantities…
Influence of Physical Treatments on the Potato Starch Granules Micro- and Ultrastructure
2012
In this research, potato starch was subjected to ph ysical treatments in order to analyse the changes at the micro- and ultrastructural levels an d finally to identify the optimal conditions for disintegrating the starch granules. For the analysi s, 10% aqueous solutions of potato starch were treated with a) microwaves; b) heat and c) heat com bined with ultrasounds. For each treatment type, the duration was 5 minutes, excepting the microwave treatment, where the time was 1 and 5 minutes; heat power varied from 180W to 900W at the tests with microwave, temperature varied between 65 o C and 100 o C in the thermal experiments and at the thermal ana lysis combined with ultrasounds temperature …
GROWTH AND PHOTOELECTROCHEMICAL BEHAVIOUR OF ELECTRODEPOSITED ZnO THIN FILMS FOR SOLAR CELLS
2012
Thin zinc oxide films were deposited potentiostatically from zinc nitrate aqueous solutions on ITO substrates. The influence of experimental parameters (temperature, electrolyte concentration, deposition potential) on structure and morphology of films was investigated. Deposited films were generally polycrystalline in structure, even if growth according to preferential planes occurs in certain conditions. The effect of thermal treatments in air at 150 and 350 °C was also studied. In some cases, Cl species were incorporated into deposit by adding zinc chloride to the electrolyte. A photoelectrochemical investigation, performed in neutral solution before and after thermal treatment, gives mor…
Expanding the atrane route: Generalized surfactant-free synthesis of mesoporous nanoparticulated xerogels
2008
Abstract A diversity of silica-based and non-silica nanoparticulated mesoporous xerogels have been synthesized from aqueous solution using a surfactant-free strategy, and starting from molecular atrane complexes as precursors. This approach constitutes an extension of the “atrane route” previously described for the surfactant-assisted synthesis of mesoporous materials, and allows us to unify the multiplicity of protocols described for the preparation of conventional xerogels. In fact, we have used exactly the same preparative conditions for obtaining all the compositions reported here. The xerogels synthesized in this way include pure silica (UVM-11), aluminosilicates and titanosilicates (M…
Structural Characterization of Zirconia Nanoparticles Prepared by Microwave-Hydrothermal Synthesis
2009
Nanocrystalline zirconia powders have been prepared by microwave-hydrothermal synthesis starting from aqueous solution of ZrOCl2·8H2O. Results of investigations on the aqueous suspension stability of the washed zirconia nanopowders by dynamic light scattering showed that the suspension, constituted by superaggregates of nanoparticles (131 ± 10 nm), was stable up to 15 days. Nanopowders were investigated by means of transmission electron microscopy and small angle x-ray scattering measurements which proved that the zirconia nanopowder is constituted by small primary nanoparticles of ca. 8 nm that agglomerate forming bigger aggregates of 50 ± 1 nm.