Search results for "UART"

2018

Abstract. Sediments containing gas hydrate dispersed in the pore space are known to show a characteristic seismic anomaly which is a high attenuation along with increasing seismic velocities. Currently, this observation cannot be fully explained albeit squirt-flow type mechanisms on the microscale have been speculated to be the cause. Recent major findings from in situ experiments, using the gas in excess and water in excess formation method, and coupled with high-resolution synchrotron-based X-ray micro-tomography, have revealed the systematic presence of thin water films between the quartz grains and the encrusting hydrate. The data obtained from these experiments underwent an image proce…

Textural-chemical changes and deformation conditions registered by phyllosilicates in a fault zone (Pic de Port Vieux thrust, Pyrenees)

2017

International audience; Synkinematic phyllosilicates in fault zones can be used to deduce the deformation mechanisms and the conditions of fault activity, as their chemical composition, crystal structure and texture can record the different stages of deformation and fluid-rock interactions. The Pic de Port Vieux, a second-order thrust related to the major Gavarnie thrust in the southern central part of the Pyrenees Axial Zone, juxtaposes Triassic pelites of the hanging wall and Cretaceous limestones of the footwall. In order to investigate the mineralogical and geochemical changes and constrain the deformation conditions of thrusting, characterization of phyllosilicates was performed along …

Impact of Coseismic Frictional Melting on Particle Size, Shape Distribution and Chemistry of Experimentally-Generated Pseudotachylite

2020

In natural friction melts, or pseudotachylites, clast textures and glass compositions can influence the frictional behavior of faults hosting pseudotachylites, and are, in turn, sensitive to the processes involved in pseudotachylite formation. Quantification of these parameters in situations where the host rock composition and formation conditions are well-constrained, such as analogue experiments, may yield calibrations that can be employed in analysis of natural pseudotachylites. In this paper, we experimentally-generated pseudotachylites in granitoid rocks (tonalite and Westerly granite) at Pconf= 40 MPa and slip rates of ∼0.1 m s−1, comparable to the conditions under which natural pseud…

Not only flint: Levallois on quartzite and limestone at Abrigo de la Quebrada (Valencia, Spain): Implications for neandertal Behavior

2016

This paper investigates the application of the Levallois technique to the knapping of nonflint raw materials (limestone and quartzite) in the upper levels of the Abrigo de la Quebrada rockshelter (Chelva, Valencia, Spain). Besides highlighting the significant flexibility that characterized Neandertal behavior, such an application is of singular interest because goodquality flint—lacking fissures and impurities and presenting a compact and homogeneous texture—is abundant in the site’s immediate vicinity. In other assemblages, the scarcity or poor quality of flint often suffices to explain the recourse to alternatives, but in these Quebrada levels raw material choice must be primarily determi…

An aeolian or a glaciolacustrine record? A case study from Mieļupīte, Middle Gauja Lowland, northeast Latvia

2017

Abstract In the Middle Gauja Lowland, northeast Latvia, dunes are distributed over a vast glaciolacustrine plain that formed during the retreat of the Fennoscandian ice sheet. Such a direct contact between aeolian and glaciolacustrine sediments can be used to infer depositional settings and decipher to what extent these sediments bear an aeolian component. Our proxies, although preliminary, reveal a limited range of variation in grain-size parameters, a significant presence of quartz grains with silica precipitation and matt-surface grains of various rounding degrees and massive structure combined with horizontal lamination. These are indicative of periglacial-aeolian depositional condition…

Electron Paramagnetic Resonance and petrographic analysis for dating Mesolithic and Neolithic pottery from Al Khiday (Sudan)

2016

Abstract Electron Paramagnetic Resonance (EPR) dating, like luminescence techniques, is based on the time-dependent accumulation of trapped charges at mineral defect centres. However, Fe(III) ions prevent the common Continuous Wave (CW-EPR) approach for dating pottery, which always contains iron. The Pulsed method (ED-EPR) allowed this limitation to be overcome, with recording of radiation-induced defect signals, as shown by increased signal intensity after artificial irradiation of samples. The method was applied to studying Mesolithic and Neolithic pottery from Al Khiday (Central Sudan), characterized by quartz-rich tempers and coming from dated contexts. As the occurrence of a natural ED…

Initial quartz OSL and dust mass accumulation rate investigation of the Kisiljevo loess sequence in north-eastern Serbia

2020

The thick and apparently continuous loess-palaeosol sequences in the Vojvodina region of northern Serbia are recognized and well understood as some of the oldest and most complete terrestrial European palaeoclimatic archives. By contrast, there are few published records for loess profiles from other regions in Serbia. Here we address this knowledge gap by investigating an 8 m thick loess sequence exposed near the village of Kisiljevo in north eastern Serbia, describing the pedostratigraphy and environmental magnetic signatures in detail and placing these within a chronologic framework using quartz optically stimulated luminescence (OSL) on the 4-11 and 63-90 μm size fractions. Our result…

Quartz OSL dating of late quaternary Chinese and Serbian loess: A cross Eurasian comparison of dust mass accumulation rates

2019

© 2018 Elsevier Ltd and INQUA. Reconstructing dust Mass Accumulation Rate (MAR) from loess deposits is critical to understanding past atmospheric mineral dust activity and requires accurate independent age models from loess deposits across Europe and Asia. Previous correlations of loess in Europe and China have tended to focus on multi-millennial timescales, with no detailed examination of dust MAR at the two ends of the Eurasian loess belt on shorter, sub-orbital scales. Here we present a detailed quartz optically stimulated luminescence (OSL) chronology from the Serbian Titel Loess Plateau (Veliki Surduk loess core) and the Chinese Loess Plateau (Lingtai section). The luminescence ages pa…

Shape, size, and quantity of ingested external abrasives influence dental microwear texture formation in guinea pigs

2020

Food processing wears down teeth, thus affecting tooth functionality and evolutionary success. Other than intrinsic silica phytoliths, extrinsic mineral dust/grit adhering to plants causes tooth wear in mammalian herbivores. Dental microwear texture analysis (DMTA) is widely applied to infer diet from microscopic dental wear traces. The relationship between external abrasives and dental microwear texture (DMT) formation remains elusive. Feeding experiments with sheep have shown negligible effects of dust-laden grass and browse, suggesting that intrinsic properties of plants are more important. Here, we explore the effect of clay- to sand-sized mineral abrasives (quartz, volcanic ash, loess,…

A conspectus of the genus Cherleria (Minuartia s.l., Caryophyllaceae)

2017

Abstract: Minuartia s.l. (Caryophyllaceae) is polyphyletic, with its species belonging to eleven major clades, all of which have been recognized at the generic rank. Cherleria is one of these segregate genera, based on the Linnaean species Cherleria sedoides. Its centre of diversity is on the Balkan Peninsula, but species also occur in the European and North American high mountains and in the Arctic. The species of Cherleria show ecological, especially substrate, differentiation and multiple colonisations of alpine habitats. We make new combinations for the 17 (of 20) taxa in Cherleria that do not yet have Cherleria names and provide a key to all species of the genus. Citation: Moore A. J. …