Search results for "Ultrasonics"

Cluster issue on Heusler compounds and devices

2009

Modeling and Experimental Verification of Ultrasound Transmission in Electro Insulation Oil

2012

A verification study of ultrasound transmission numerical simulation results with experiment results is presented in this paper. The work considers a model of a transformer tank which is filled with electro insulating oil. In the experiment, performed under laboratory conditions, an ultrasound wave is generated by a piezoelectric transducer that is fixed in the centre of the tank and measured by another transducer mounted inside the tank at three distances: 10, 20 and 30 cm from the sound source. The transducer is able to measure and generate acoustic waves in the ultrasound frequency band up to 1 MHz. The simulation considers numerical calculation of acoustic pressure distribution inside t…

Swift-ion-induced hardening and reduction of dislocation mobility in LiF crystals

2008

Ion-induced change in Vickers hardness and arm length of dislocation rosettes created by indentation on the (1 0 0) face of LiF crystals was studied. The irradiations were performed using swift U, Bi and Ni ions with a specific energy of 11 MeV per nucleon at fluences between 106 and 1013 ions cm−2. Remarkable effects of the ion-induced hardening and reduction of dislocation arm length were observed above the threshold fluences of about 109–1010 ions cm−2 and 106–107 ions cm−2, respectively. The products of track core damage and aggregates of single defects in the halo of overlapping tracks are responsible for the effects. The results are analysed using the Orowan's model of dislocation imp…

Exchange bias in epitaxial Mn2Au (0 0 1)/Fe (0 0 1) bilayers

2019

Grain size effect and local disorder in polycrystalline relaxors via scanning probe microscopy

2007

Local piezoresponse of individual grains in polycrystalline Pb0.9125La0.0975(Zr0.65Ti0.35)0.976O3 (PLZT 9.75/65/35) relaxor ceramics is studied using the scanning probe microscopy (SPM) technique. The observed piezoelectric contrast consisting of irregular (labyrinth-type) polarization patterns is attributed to the compositional disorder and consequent charge imbalance caused by high La concentration. A measure of this disorder, the polarization correlation length ξ, is directly determined using an autocorrelation analysis function implemented in the SPM software. The analysis of the obtained images shows that ξ taken at the scale ~200 nm varies as a function of the position inside the grai…

Epitaxial Mn2Au thin films for antiferromagnetic spintronics

2015

Mn2Au is one of the few candidate materials for antiferromagnetic spintronics requiring ordered metals with a high Neel-temperature and strong spin–orbit coupling. We report the preparation of epitaxial Mn2Au thin films by rf-sputtering. Structural characterization by x-ray and electron diffraction demonstrates a high degree of atomic order and the temperature dependence of the resistivity is typical for a good metal. The magnetic properties of the samples are studied by the investigation of Mn2Au/Fe bilayers. Exchange bias effects are observed, which present strong evidence for antiferromagnetic order in the Mn2Au thin films. Small domains of 500 nm are visualized in the exchange coupled F…

Influence of plasma chemistry on impurity incorporation in AlN prepared by plasma enhanced atomic layer deposition

2013

Impurities in aluminum nitride films prepared by plasma enhanced atomic layer deposition using NH3-, N2/H2- and N2-based plasmas are investigated by combining time-of-flight elastic recoil detection analysis (ERDA) and Fourier transform infrared spectroscopy. Different atomistic growth mechanisms are found to exist between the plasma chemistries. N2-plasma is shown as not suitable for the low-temperature deposition of AlN. Films deposited by NH3- and N2/H2-based processes are nitrogen rich and heavily hydrogenated. Carbon impurities exist at higher concentrations for the N2/H2-processes. The discovery of nitrile groups in the films indicates that carbon impurities can be partially attribute…

VUV irradiance measurement of a 2.45 GHz microwave-driven hydrogen discharge

2015

Absolute values of VUV-emission of a 2.45 GHz microwave-driven hydrogen discharge are reported. The measurements were performed with a robust and straightforward method based on a photodiode and optical filters. It was found that the volumetric photon emission rate in the VUV-range (80-250 nm) is $10^{16}$-$10^{17}$ 1/cm$^3$s, which corresponds to approximately 8% dissipation of injected microwave power by VUV photon emission. The volumetric emission of characteristic emission bands was utilized to diagnostics of molecular plasma processes including volumetric rates of ionization, dissociation and excitation to high vibrational levels and metastable states. The estimated reaction rates impl…

Heusler compounds as ternary intermetallic nanoparticles: Co2FeGa

2009

This work describes the preparation of ternary nanoparticles based on the Heusler compound Co2FeGa. Nanoparticles with sizes of about 20?nm were synthesized by reducing a methanol impregnated mixture of CoCl2 ? 6H2O, Fe(NO3)3 ? 9H2O and Ga(NO3)3 ? xH2O after loading on fumed silica. The dried samples were heated under pure H2 gas at 900??C. The obtained nanoparticles?embedded in silica?were investigated by means of x-ray diffraction (XRD), transmission electron microscopy, temperature dependent magnetometry and M??bauer spectroscopy. All methods clearly revealed the Heusler-type L21 structure of the nanoparticles. In particular, anomalous XRD data demonstrate the correct composition in addi…

Measuring guided waves in long bones: Modeling and experiments in free and immersed plates

2005

Guided waves, consistent with the A0 Lamb mode, have previously been observed in bone phantoms and human long bones. Reported velocity measurements relied on line fitting of the observed wave fronts. Such an approach has limited ability to assess dispersion and is affected by interference by other wave modes. For a more robust identification of modes and determination of phase velocities, signal processing techniques using the fast Fourier transform (FFT) were investigated. The limitations of FFT because of spatial resolution were addressed to improve the precision of the measured modes. An inversion scheme was developed for determining the plate thickness from the measured velocity. Experi…