Search results for "Volt"
showing 10 items of 2187 documents
Economic evaluation of PV system for EV charging stations: Comparison between matching maximum orientation and storage system employment
2016
This article addresses the problem of the choice of a generation system to be implemented to reduce the impact of charging electric vehicles at University. Based on the behaviour of the student population, it is identified the electrical load. Two possible solutions are evaluated in order to manage the peak load: an orientation of the panels in order to increase the power at defined time and the use of storage system. The main strength and weakness points of two systems are investigated by taking into account the Levelized Cost of Energy.
Service restoration in compensated distribution networks using a hybrid genetic algorithm
1998
In this paper a genetic algorithm (GA) based approach to the service restoration (SR) problem in automated distribution networks is presented. Normal operation within the network comprises both automatic reconfiguration and compensation so as to reduce power losses, allow load balancing and improve the voltage profile. In the restorative state, the reconfiguration is performed together with compensation, taking mainly into account the load supply requirement and secondarily, the losses reduction requirement. After a general discussion on the restoration problem together with a short review of recent papers on the topic, a solution strategy is proposed. Then, a short account about classical …
Economic analysis on dynamic photovoltaic systems in new Italian “feed in tariffs” context
2013
Dynamic photovoltaic generators, based on the application of solar-trackers, are able to give an increment to the electric energy production from solar source. Their realization and maintenance costs are certainly higher than those of fixed ones. In this paper the Authors propose a method to estimate the increment of electrical energy generation that must be guaranteed by a dynamic photovoltaic generator, so as its realization could be more favorable with respect to that of a fixed generator one with the same rated power. This method, developed by means of classical economic indexes like the Pay-Back-Period and the Net Present Value, takes in to account the economic incentives for the PV sy…
An efficient analytical approach for obtaining a five parameters model of photovoltaic modules using only reference data
2013
Exploiting the equivalent one-diode circuit of a photovoltaic (PV) module, this paper proposes a novel and fully analytical model to predict the electrical performance upon solar irradiance intensity and PV module temperature. The model refers essentially to an equivalent circuit governed by five parameters and the extraction of them permits to describe the current–voltage curve of the PV panel and consequently permits to assess the energy output of PV modules. The proposed model extracts the five characteristic parameters using only exact analytical relationship and tabular data always available such as short-circuit current, open circuit voltage and the Maximum Power Point (MPP). The diff…
Photovoltaic based active generator: Energy control system using stateflow analysis
2015
At present, most of the grid connected photovoltaic (PV) systems are operating at maximum power points and injecting power in uncontrolled way. Thus, active generator will be a good solution to support instantaneous power balance, frequency control and maintaining the power quality with controllable power injection. This new mode of active generator needs innovative power management. The new proposed energy control system for active generator might help to manage the energy within the micro-grid environment. In this work, the focus is to manage the energy among the PV based active generator, load and interconnected grid and energy controller architecture for that purpose is presented. It co…
Performance evaluation of directly photovoltaic powered DC PM (direct current permanent magnet) motor – propeller thrust system
2013
Photovoltaic (PV) powered directly coupled electro-mechanical system has wide applications (e.g. PV powered cooling fans in green houses, PV water pumping system, solar vehicles). The objective of this work is to analyse the operation of directly PV powered DC PM (direct current permanent magnet) motor – propeller system for selection of motor parameters. The performance of such system mainly depends on the incident solar radiation, operating cell temperature, DC motor and propeller load parameters. It is observed that the operating points of the PV DC PM motor – propeller system matches very closely with the maximum power points (MPPs) of the PV array, if the DC PM motor – propeller parame…
A new modified Inc-Cond MPPT technique and its testing in a whole PV simulator under PSC
2015
In this paper a new modified Inc-Cond MPPT technique able to lead PV plants to work in the real MPP (Maximum Power Point) under PSC (Partial Shading Condition) is proposed. The new Inc-Cond MPPT technique working principle is fully explained, discussed and then successfully tested in a whole and reliable PV simulator conceived and set-up by the Authors in order to test and compare several new MPPT algorithms. The simulation results show that the proposed Inc-Cond MPPT technique is able to successfully lead the PV plant to work in the real MPP both in the cases of instantaneous and gradual changing of shading and of temperature conditions.
Standard testing of photovoltaic modules for use in renewable energy education
2015
A photovoltaic laboratory exercise has been devised and used in the educational curriculum of the Renewable Energy Programme at the University of Jyväskylä. The purpose of the experimental tasks is to give students of renewable energy a good understanding of standard testing procedures used in industry for characterising photovoltaic modules and to provide practical skills in sizing simple photovoltaic installations. Herein the experimental set-up, basic theory and measurement procedure are described. The experimental apparatus is simple to assemble and uses both standard laboratory equipment and recycled components. From the experimental results, the tested PV cell had a maximum efficiency…
Photovoltaic plant array reconfiguration: Design of a new device
2014
An efficient strategy to improve unequally irradiated PV plants performances is based on the reconfiguration of the connections between the modules. In this paper, an algorithm, for this purpose conceived, is presented. Moreover, the design, realization and finally also the set up of a new reconfiguration system device is fully shown and discussed. The algorithm conceived simulates several possible series-parallel connections under varying irradiation conditions, and determines the optimal modules connection in order to get the maximum output power. In this way, the reconfiguration system may set up the reconfiguration strategy. The reconfiguration system prototype set up, basically consist…
Mathematical modelling of an inverter-based distributed generator
2016
In this paper, a modeling approach of a three phase power inverter based on an electrostatic synchronous machine is presented. By the proposed approach, any inverter-based distributed generator in a microgrid can be replaced by an equivalent electrostatic machine. This paper aims to promote the use of the proposed modeling approach in the analysis of microgrid stability. Thanks to the proposed modeling approach, transient performances of on-grid operation of converter-based distributed generators could be easily analyzed by multi-machine models. Parameters of the equivalent synchronous electrostatic machine model are derived to achieve equivalence with the inverter model. Small signal model…