Search results for "Volta"
showing 10 items of 2055 documents
A measurement setup for electric bicycles powered from renewable energy sources
2014
In this paper a measurement system for a pedalassist rickshaw is described. It has been designed and realized with the purpose of a deep analysis of operating time, range and general performance of the prototype vehicle. The three-wheel velocipede under test, developed in the SDES laboratory of the University of Palermo, is equipped with two battery packs, and a photovoltaic panel which is used to recharge one of the packs at a time. To further improve the autonomy of this mean, a fuel cell will be added as a power source, whose consequent improvement in performance could be easily investigated by the presented measurement setup. An Arduino board has been employed to receive and store all c…
A 9-level three-phase multilevel converter with harmonic mitigation and integrated battery balancing
2019
In this paper, a 9 level three-phase multilevel converter with a harmonic mitigation control method and an integrated battery balancing algorithm for automotive purpose is proposed. Each level of the converter is composed by a buck-boost converter and an h-bridge in cascaded connection. The control algorithm is implemented to achieve the harmonic mitigation on the output voltage waveform and to maintain the battery input voltages balanced. The design and operation of the system is described, and simulation study is reported using Matlab/Simulink platform.
Techno-economic evaluation of PV based institutional smart micro-grid under energy pricing dynamics
2020
Abstract The solar photovoltaic (PV) system with battery energy storage have a lot of potential to provide reliable and cost-effective electricity and to contribute in micro-grid operation. However, the operational performance of such type of micro-grid system depends on many factors (e.g. techno-economic sizing, energy management among the sources, market energy prices dynamics, energy dispatch strategies, etc.). In this paper, a typical Indian institutional energy system has considered for techno-economic performance evaluation for operating as a smart micro-grid under market energy pricing dynamics. The institutional energy system has integrated PV, battery storage and DG for operating a…
Adaptive energy management strategy for sustainable voltage control of PV-hydro-battery integrated DC microgrid
2021
Abstract DC microgrid has relatively more advantages of power quality, not requirement of reactive power, higher operational efficiency compare to AC microgrid. DC microgrid can facilitate effective integration of distributed clean energy resources and efficient solution for providing electricity to remote areas (e.g. North Eastern States of India). Recently, India has commissioned small hydro, solar PV and battery storage integrated DC microgrids (MGs) to meet the locally increasing load demand of northeastern states. The sudden change in solar insolation during the load power dynamics can cause unbalanced power flow in such isolated MGs. Due to the slow response time of small hydro power …
Battery technologies for electric vehicles
2017
This chapter gives a brief overview of the following types of vehicles: battery electric vehicle (BEV), plug-in hybrid electric vehicle (PHEV), and hybrid electric vehicle (HEV). It then provides a comprehensive summary of the electrochemical energy storage including Ni-MH battery, Li-ion battery, and advanced rechargeable battery. Battery chemistry is explained in a detailed manner including an abbreviated modelling approach. Also, the issues of battery-charging method, management, and monitoring are addressed. The chapter concludes with a discussion on battery cell voltage balancing and temperature monitoring in addition to the battery state-of-charge (SOC) estimation.
Modeling and experimenting the thermal behavior of a lithium-ion battery on a electric vehicle
2018
This paper deals with an electro thermal model of a lithium-ion battery for hybrid and electric vehicles. It was developed to study the behavior of lithium-ion battery key parameters. The thermal model, under Matlab/Simulink, is capable of predicting the voltage, current, State of Charge and temperature of the battery. Thereafter, the thermal behavior of the battery was studied under different operating conditions. The results of the simulation were compared with experimental measurements carried out by thermocouples and thermal camera on a test bench. Finally, the model has been validated on the NOAO electric vehicle.
An integrated energy simulation and life cycle assessment to measure the operational and embodied energy of a Mediterranean net zero energy building
2022
Abstract Net Zero Energy Buildings can play a key role in reducing the energy use, greenhouse gas emissions and the use of natural resources associated to the built environment. It is widely recognized that in low energy building a shift in relevance may occur from the operational to the embodied impacts. However, building performance assessment focus mostly on the operational phase and on primary energy consumption. This study aims to assess the energy and environmental impacts of a residential net zero energy building expanding the analysis to the full life cycle and to a wide range of environmental impact categories. The methodological approach integrates a non-steady state building ener…
Battery capacity estimation for building-integrated photovoltaic system: Design study of a Southern Norway ZEB house
2017
Building-integrated Photovoltaic system (BIPV) with energy storage (ES) can help in reducing the peak demand as well as overcoming the intermittency of the load and PV production. In Southern Norway, a Smart Village Skarpnes is developed for zero energy buildings (ZEBs). In this Smart Village, five houses are built with BIPV system. Its important to estimate the appropriate battery sizing with consideration of local PV production and load profile taking into account the battery characteristics with minimization of the annual electricity bill. In this study, real operational results of house (C6) from the Skarpnes Smart Village is used for estimating the capacity of battery energy storage fo…
Battery Capacity Estimation for Building Integrated Photovoltaic System: Design Study for Different Geographical Location(s)
2017
Abstract Building Integrated Photovoltaic system (BIPV) with energy storage (ES) can help in reducing the peak demand, improving the power quality and control dispatching of the power. Adding a proper size of battery ES to the grid-connected PV system could reduce the overall investment cost as well as reducing the grid-dependency. A typical battery energy storage capacity is going to be determined by considering the real-time operational (PV production as well as load consumption) data. In this study, real-time operational data of a residential load (C6 house) with BIPV system located Southern Norway as well as institutional load (Teri university) with BIPV located in New Delhi, India are …
An energy autonomous and battery-free measurement system for ambient light power with time domain readout
2021
Abstract Internet of Things (IoT) provides more and more adequate infrastructures for many applications and advanced services. This context promotes the ability to satisfy the growing demand for innovative measuring systems, increasingly popular with intelligent nodes, totally wireless, easy to install that require the least possible maintenance. This paper aims to contribute to the state-of-the-art with an energy-autonomous and battery-free measurement platform designed to measure the ambient light power when its level exceeds the Limit of Detection (LoD) threshold. The proposed system consists of a single photovoltaic transducer to harvest energy and simultaneously detect ambient light. T…