Search results for "Voltage source"

Voltage Source Multilevel Inverters With Reduced Device Count: Topological Review and Novel Comparative Factors

2021

Multilevel inverters (MLIs) have gained increasing interest for advanced energy-conversion systems due to their features of high-quality produced waveforms, modularity, transformerless operation, voltage, and current scalability, and fault-tolerant operation. However, these merits usually come with the cost of a high number of components. Over the past few years, proposing new MLIs with a lower component count has been one of the most active topics in power electronics. The first aim of this article is to update and summarize the recently developed multilevel topologies with a reduced component count, based on their advantages, disadvantages, construction, and specific applications. Within …

A battery-based, low-noise voltage source.

2010

A highly stable, low-noise voltage source was designed to improve the stability of the electrode bias voltages of a Penning trap. To avoid excess noise and ground loops, the voltage source is completely independent of the public electric network and uses a 12 V car battery to generate output voltages of +/-15 and +/-5 V. First, the dc supply voltage is converted into ac-voltage and gets amplified. Afterwards, the signal is rectified, filtered, and regulated to the desired output value. Each channel can deliver up to 1.5 A. The current as well as the battery voltage and the output voltages can be read out via a universal serial bus (USB) connection for monitoring purposes. With the presented…

INVERTER-BASED DISTRIBUTED GENERATORS, MODELING AND CONTROL

In the last few years, electrical power generation is moving from a centralized generation towards distributed generation including on-site Renewable Energy Sources (RESs). In order to overcome RES related issues, as intermittent and fluctuating power, storage elements are included in the on-site generation system. The interaction between distributed generator (DG) units including RES, storage and front-end power converters should be carefully modeled in order to analyze the power system stability. An accurate modeling of DGs is required. In this thesis, a new modeling approach has been proposed for the inverter-based DGs based on the concept of electrostatic synchronous machines. Detailed …

Grid-Forming Converters in Weak Grids – The Case of a Mediterranean Island

2019

The existing power network of a Mediterranean island is used as test bed for the study of grid-forming converter dynamics in weak grid conditions. The control scheme adopted for the converter falls in the category of the so called virtual synchronous machines (VSM). Particular attention is committed to the interaction between the converter controls and the synchronous machines dynamics. Time delays typically associated to measurements and filters are considered in the study, and included in the system model with a specific mathematical approach. Time-domain simulations show the occurrence of oscillatory instability in the system, with VSM and synchronous machines swinging against each other…

A reexamination of voltage distortion for classical carrier-based vs B-Spline modulation of three-phase Voltage Sources Inverters

2015

Voltage waveform improvement has been the object of several investigations for many years and a manifold of different solutions have been proposed to reduce the harmonic content in Voltage Source Inverters (VSI) power application. In many cases this improvements have been obtained by modifying the reference voltage modulating signal. The recent introduction of cardinal B-spline functions, used as carrier signals, has given rise to a new modulation technique whose main characteristic is a lower value of the Total Harmonic Distortion (THD). After the discussion on the B-Spline modulation principle and on its computational effort, a performance comparisons is carried out by means of Total Harm…

Power dispatching of active generators using droop control in grid connected micro-grid

2014

Masteroppgave i fornybar energi ENE 500 Universitetet i Agder 2014 Renewable energy promises a green energy future for the world. However, many technical problems still have to be solved. Almost all renewable energy sources require power electronic converters for power processing and therefore inverter control systems and power dispatching strategies are significant in renewable energy applications. The existing electricity grid architecture is based on centralized power generations while most renewable power generations are distributed and connected to lower or medium voltage networks. Some of important renewable energy resources such as solar and wind power are intermittent in nature. Thi…

Experimental test of the performances of a photovoltaic modules model

2015

In this paper, a measurement-based modeling technique for PV panels oriented to power electronics design is proposed. The proposed modelling approach aims at an accurate modeling of the whole PV curve and not only around a few remarkable points. The proposed approach is based on an experimental characterization of the module under test. In fact, the incompleteness of manufacturers' data and the knowledge of physical parameters are the main source of inaccuracy in existing modelling approaches. The proposed approach is applied to a four lumped parameters model of a Conergy E215P solar module. Tests are performed under natural light. The parameter identification procedure is described in deta…

Decoupled control scheme of grid-connected split-source inverters

2017

Grid-connected power conversion systems for renewable energy sources must fulfill several requirements, e.g., the high efficiency, the reduced cost and complexity, and, quite often, the boost capabilities that is usually achieved using a front-end dc–dc boost converter before the inversion stage, leading to a two-stage architecture. Meanwhile, single-stage power conversion systems, which perform the boosting operation within the inversion one, offer some potential advantages, in terms of reducing the complexity and the volume of the whole system. Among several proposed options, the split-source inverter (SSI) has been recently proposed by Abdelhakim et al. as an alternative option with some…