Search results for "Voltage"
showing 4 items of 934 documents
The ALICE experiment at the CERN LHC
2008
Journal of Instrumentation 3(08), S08002 (2008). doi:10.1088/1748-0221/3/08/S08002
Electrical conductivity of glass fiber-reinforced plastic with nanomodified matrix for damage diagnostic
2021
The electrical conductivity of glass fiber-reinforced plastic (GFRP) with epoxy matrix modified by multiwall carbon nanotubes (MWCNT) was studied. The electrical conductivity of nanomodified lamina and multi-layered GFRP was investigated on several levels using a structural approach. Components of the electrical conductivity tensor for unidirectional-reinforced monolayer were calculated similarly as in micromechanics using the conductivity of the nanomodified matrix. The electrical conductivity of multilayer composite was calculated using laminate theory and compared with values measured experimentally for various fiber orientation angles. Calculated and experimental data were in good agree…
Experimental Validation of Maximum Constant Boost Control and Switching Frequency Optimal for three-phase Quasi-Z-Source Converters
2020
This paper presents a modified modulation scheme for quasi-Z-Source converters, based on the Maximum Constant Boost Control (MCBC) concept and Switching Frequency Optimal (SFO) as reference signal. The effectiveness of the proposed technique is validated by comparing the obtained results (in terms of AC harmonic content and voltage stress) with those carried out from traditional modulation schemes. For this reason, a test bench has been assembled and the benefits of the SFO MCBC modulation scheme have been valuated.
Decoupled control scheme of grid-connected split-source inverters
2017
Grid-connected power conversion systems for renewable energy sources must fulfill several requirements, e.g., the high efficiency, the reduced cost and complexity, and, quite often, the boost capabilities that is usually achieved using a front-end dc–dc boost converter before the inversion stage, leading to a two-stage architecture. Meanwhile, single-stage power conversion systems, which perform the boosting operation within the inversion one, offer some potential advantages, in terms of reducing the complexity and the volume of the whole system. Among several proposed options, the split-source inverter (SSI) has been recently proposed by Abdelhakim et al. as an alternative option with some…