Search results for "WASTE"
showing 10 items of 2580 documents
Effects of storage on characteristics and hygienic quality of digestates from four co-digestion concepts of manure and biowaste.
2007
This study evaluated the effects of storage in northern winter conditions (5 degrees C) on the characteristics and nutrients separation of digestates from co-digestion of manure and biowaste as well as the hygienic quality of the digestates after digestion and storage. During 3-11 months' storage average nitrogen losses and reductions of total solids (TS) and volatile solids (VS) were 0-15%. With some exceptions, soluble chemical oxygen demand (SCOD) had increased slightly (from approximately 6.5 to approximately 7.5g/l) after 3 months' storage, while after 9-11 months' it had decreased from 8.3-11 to 5.6-8.4g/l. The concentrations of P(tot) and PO4-P in the separated liquid fractions decre…
Sewage sludge acidogenic fermentation for organic resource recovery towards carbon neutrality: an experimental survey testing the headspace influence
2022
Volatile fatty acids (VFAs) produced by acidogenic digestion of sewage sludge are very interesting bio-products which can contribute to carbon neutrality of wastewater treatment plants. Studies on the production of VFAs from sewage sludge from fermenters with membrane are limited. In view of above, VFAs from a fermenter pilot plant equipped with a membrane bioreactor and fed with real sewage sludge has been monitored. The effect of headspace volume (HdV) on VFA production was studied for the first time to elucidate the optimal operation conditions. Specifically, three fermenter HdV values (namely, 20, 40 and 60% of the total volume) have been investigated. Results revealed that the HdV of 2…
Two-stage anaerobic digestion of tomato, cucumber, common reed and grass silage in leach-bed reactors and upflow anaerobic sludge blanket reactors
2010
Abstract Anaerobic digestion of tomato, cucumber, common reed and grass silage was studied in four separate two-stage reactor configuration consisting of leach bed reactor (LBR) and upflow anaerobic sludge blanket reactor (UASB). LBR studies showed that COD solubilization for cucumber and grass silage was higher (50%) than tomato (35%) and common reed (15%). Results also showed that 31–39% of initial TKN present in tomato and cucumber was solubilized in the leachates and 47–54% of the solubilized TKN was converted to NH4-N. The corresponding values for common reed and grass silage were 38–50% and 18–36%, respectively. Biomethanation of the leachates in UASB reactors resulted in methane yiel…
An integral approach to sludge handling in a WWTP operated for EBPR aiming phosphorus recovery: simulation of alternatives, LCA and LCC analyses
2020
[EN] As phosphorus is a non-renewable resource mainly used to produce fertilizers and helps to provide food all over the world, the proper management of its reserves is a global concern since it is expected to become scarcer in the near future. In this work we assessed two different sludge line configurations aiming for P extraction and recovery before anaerobic digestion and compared them with the classical configuration. This study has been performed by simulation with the model BNRM2 integrated in the software package DESASS 7.1. Configuration 1 was based on the production of a PO4-enriched stream from sludge via elutriation in the primary thickeners, while Configuration 2 was based on t…
Trace metals supplementation in anaerobic membrane bioreactors treating highly saline phenolic wastewater
2017
Biomass requires trace metals (TM) for maintaining its growth and activity. This study aimed to determine the effect of TM supplementation and partitioning on the specific methanogenic activity (SMA), with a focus on cobalt and tungsten, during the start-up of two lab-scale Anaerobic Membrane Bioreactors (AnMBRs) treating saline phenolic wastewater. The TM partitioning revealed a strong accumulation of sodium in the biomass matrix and a wash-out of the majority of TM in the reactors, which led to an SMA decrease and a low COD removal of about 30%. The SMA exhibits a maximum at about 6 g Na+ L−1 and nearly complete inhibition at 34 g Na+ L−1. The dose of 0.5 mg L−1 of tungsten increases the …
Multivariate Correlation between Analytical Data for Various Organics Dissolved during Autohydrolysis of Silver Birch (Betula pendula) Chips and Trea…
2014
Autohydrolysis pre-treatments were performed for the production of hemicellulose-rich autohydrolysates from silver birch (Betula pendula) chips prior to chemical pulping. Pre-treatment conditions were varied with respect to time (from 30 to 120 min) and temperature (130 and 150 °C), covering a P-factor range from 10 to 238. Hydrolysates were analyzed in terms of carbohydrates, lignin, volatile organic acids, and furanoic compounds. The analytical data were subjected to various chemometric techniques to establish the relationships between dissolved organic components, hardwood and softwood used in the experiments, and applied pre-treatment conditions. Using this method, differences between t…
Biological soil crusts determine soil properties and salt dynamics under arid climatic condition in Qara Qir, Iran
2020
Biological soil crusts are a thin layer within the soil system but strongly determine the infiltration, runoff and water and solute movement. Little is known about the role of biological soil crusts on soil solute dynamics in arid ecosystems and the objective of this paper is to determine in Qara Qir rangeland how biological soil crusts control the water and salt distribution along the soil profile. Rainfall simulation experiments were carried out at five locations, and measurements of the soil at 0-5, 5-10, 10-20, 20-30, 30-50 and 50-80 cm depth were done before, 48 h and 21 days after the rainfall simulations. Soil particle size distribution, bulk density, water content, organic carbon an…
Extractability of metals and ecotoxicity of soils from two old wood impregnation sites in Finland
2003
Abstract Four metal-contaminated soil samples were classified using physical methods, extracted by selective extraction procedures and analyzed for chemical concentrations. De-ionized water, 0.01 mol/l barium chloride, 1 mol/l ammonium acetate and concentrated nitric acid were used as extraction solutions. Ecotoxicity of water extracts and soil samples was analyzed in order to describe the bioavailability of the contaminants. Samples from old wood impregnation plants contained high amounts of As, Cu, Cr and Zn, which originated from chromated copper arsenate, ammoniacal copper–zinc arsenate, and ammoniacal copper quaternary compound. Total As concentrations of the heavily contaminated sampl…
Sulphate Removal from Water by Carbon Residue from Biomass Gasification: Effect of Chemical Modification Methods on Sulphate Removal Efficiency
2016
Sulphate removal from mine water is a problem because traditional chemical precipitation does not remove all sulphates. In addition, it creates lime sediment as a secondary waste. Therefore, an inexpensive and environmental-friendly sulphate removal method is needed in addition to precipitation. In this study, carbon residues from a wood gasification process were repurposed as precursors to a suitable sorbent for SO42- ion removal. The raw material was modified using ZnCl2, BaCl2, CaCl2, FeCl3, or FeCl2. Carbon residues modified with FeCl3 were selected for further consideration because the removal efficiency toward sulphate was the highest. Batch sorption experiments were performed to eval…
The preparation and evaluation of core-shell magnetic dummy-template molecularly imprinted polymers for preliminary recognition of the low-mass polyb…
2020
Abstract The design, preparation process, binding abilities, morphological characteristic and prospective field of application of dummy-template magnetic molecularly imprinted polymer (DMMIP) for preliminary recognition of the selected low-mass polybrominated diphenyl ethers (PBDE-47 and PBDE-99) from aquatic environment were investigated. The surface of iron oxide (Fe3O4) nanopowder (50–100 nm particles size) was modified with tetraethoxysilane and next prepared Fe3O4@SiO2 particles were dispersed in anhydrous toluene functionalized by (3-aminopropyl)triethoxysilane. Finally, MIPs' thin film layer on the surface of Fe3O4@SiO2@NH2 was formed in acetonitrile as a solvent solution, using ethy…