Search results for "WAVELENGTH"
showing 10 items of 741 documents
Enhanced photorefractive properties of Bi-doped Sn2P2S6
2008
International audience; Enhanced photorefractive properties of tin hypothiodiphosphate (Sn2P2S6) crystals as a result of Bi doping are presented. These new crystals were obtained by the vapor-transport technique using stoichiometric Sn2P2S6 composition with an additional amount of Bi up to 0.5 mol. % in the initial compound. The bandgap edges of the obtained crystals are located at ~750 nm and shift toward the red wavelengths with increasing Bi concentration. Sn2P2S6:Bi crystals are found to exhibit larger two-beam coupling gain coefficients (up to 17 cm−1 at a wavelength of 854 nm) as compared to (i) pure Sn2P2S6 (2.5 cm−1 at 854 nm), (ii) Sn2P2S6 crystals modified by the growth conditions…
Transient photoresponse and incident power dependence of high-efficiency germanium quantum dot photodetectors
2012
We report a systematic study of time-resolved and power-dependent photoresponse in high-efficiency germanium quantum dot photodetectors (Ge-QD PDs), with internal quantum efficiencies greater than 100 over a broad wavelength, reverse bias, and incident power range. Turn-on and turn-off response times (τ on and τ off) are shown to depend on series resistance, bias, optical power, and thickness (W QD) of the Ge-QD layer, with measured τ off values down to ∼40 ns. Two different photoconduction regimes are observed at low and high reverse bias, with a transition around -3 V. A transient current overshoot phenomenon is also observed, which depends on bias and illumination power. © 2012 American …
Photostimulated luminescence properties of neutron image plates
2016
Abstract The luminescence properties of two commercial neutron-sensitive image-plates based on Gd 2 O 3 -doped BaFBr:Eu 2 + storage phosphors are examined. These are white Fuji plates and blue Fuji plates (BAS-ND) with Gd 2 O 3 content by weight of 34% and 50%, respectively. Both plates show two maxima in the photostimulation spectrum near 500 nm and 600 nm, with the ratio of the peak responses ( I 600 nm / I 500 nm ) 1.39 and 0.53 for the white and blue plates respectively. The optimum wavelengths for photostimulation for the two phosphors are therefore different. The response of the blue plate is only 25% that of the white plate, if each is stimulated at its optimum wavelength.
Wavelength-Gated Adaptation of Hydrogel Properties via Photo-Dynamic Multivalency in Associative Star Polymers.
2020
Abstract Responsive materials, such as switchable hydrogels, have been largely engineered for maximum changes between two states. In contrast, adaptive systems target distinct functional plateaus between these maxima. Here, we demonstrate how the photostationary state (PSS) of an E/Z‐arylazopyrazole photoswitch can be tuned by the incident wavelength across a wide color spectrum, and how this behavior can be exploited to engineer the photo‐dynamic mechanical properties of hydrogels based on multivalent photoswitchable interactions. We show that these hydrogels adapt to the wavelength‐dependent PSS and the number of arylazopyrazole units by programmable relationships. Hence, our material des…
SiPMs coated with TPB: coating protocol and characterization for NEXT
2012
[EN] Silicon photomultipliers (SiPM) are the photon detectors chosen for the tracking readout in NEXT, a neutrinoless \bb decay experiment which uses a high pressure gaseous xenon time projection chamber (TPC). The reconstruction of event track and topology in this gaseous detector is a key handle for background rejection. Among the commercially available sensors that can be used for tracking, SiPMs offer important advantages, mainly high gain, ruggedness, cost-effectiveness and radio-purity. Their main drawback, however, is their non sensitivity in the emission spectrum of the xenon scintillation (peak at 175 nm). This is overcome by coating these sensors with the organic wavelength shifte…
Buckling of a coating strip of finite width bonded to elastic half-space
2008
AbstractA solution for buckling of a stiff strip of finite width bonded to a compliant elastic half-space and subjected to uniform axial compression is presented. Approximate semi-analytical and finite element solutions are obtained and compared with a two-dimensional case of a plate on elastic foundation. The comparison demonstrates that the two-dimensional solution can be applied to predict the buckling wavelength and critical compressive strain when the width of the strip is equal to or larger than the buckling wavelength. For narrow strips, the wavelength is smaller and critical strain is higher than that of a plate on foundation.
Tunable Dual-Wavelength Thulium-Doped Fiber Laser Based on FBGs and a Hi-Bi FOLM
2017
A tunable dual-wavelength thulium doped fiber laser is demonstrated experimentally. For the first time for the 2- $\mu \text{m}$ wavelength band we propose the independent tuning of the generated laser lines based on fiber Bragg gratings and the use of a Hi-Bi fiber optic loop mirror for the fine adjustment of the cavity losses to obtain stable dual-wavelength operation. Dual-wavelength laser generation with the laser lines separation in the range from 0.3 to 6.5 nm is obtained. The laser emission exhibits an optical signal-to-noise ratio better than 56 dB. Improved stability with output power fluctuations less than 1 dB is observed in dual-wavelength generation with equal power of lines.
Near-field characterization of Bragg mirrors engraved in surface plasmon waveguides
2004
International audience; Surface plasmon waveguides (SPW's) are metal ridges featuring widths in the micrometer range and thicknesses of a few tens of nanometers. A focused ion beam has been used to carve microscatterers into gold SPW's and the near-field distributions around these microstructures are observed by means of photon scanning tunneling microscopy (PSTM). On the basis of near-field images, we show that a finite length periodic arrangement of narrow slits can reflect a surface plasmon mode propagating along a SPW. The reflection efficiency of the micrograting is found to depend upon the number of slits, the period of the grating, and the incident wavelength. The optimum reflection …
Thermo-optic control of dielectric-loaded plasmonic Mach-Zehnder interferometers and directional coupler switches
2012
We report detailed experimental studies of compact fiber-coupled dielectric-loaded plasmonic waveguide components-Mach-Zehnder interferometers (MZIs) and directional couplers (DCs)-whose operation at telecom wavelengths is controlled via the thermo-optic effect by electrically heating the gold stripe of dielectric-loaded plasmonic waveguides. The effect of the gaps isolating the heated part of the waveguide from the rest of the structure was examined showing the presence of a Fabry-Perot cavity in this MZI arm. Wavelength-dependent modulation is demonstrated with MZI-based components, and wavelength dependent low power (similar to 0.92 mW) rerouting is achieved with DC switches. Furthermore…
Some considerations on the transmissivity of trirefringent metamaterials
2016
Nonlocal effects in metal–dielectric (MD) periodic nanostructures may typically be observed when the plasmonic particles and gaps are on the scale of a few tens of nanometers, enabling under certain conditions (succinctly for epsilon near zero) a collimated beam to split into three refracted signals. We developed a method for precisely evaluating the categorized transmissivity in an air/trirefringent metamaterial interface, which uses a fast one-dimensional Fourier transform and finite element solvers of Maxwell’s equations. In periodic arrays of MD nanofilms, it is proved a tunable transmissivity switch of the multirefracted beams under varying angle of incidence and wavelength, while keep…