Search results for "Waveguides"
showing 10 items of 64 documents
Phased laser diode array permits selective excitation of ultrasonic guided waves in coated bone-mimicking tubes
2017
This paper validates simulation predictions, which state that specific modes could be enhanced in quantitative ultrasonic bone testing. Tunable selection of ultrasonic guided wave excitation is useful in non-destructive testing since it permits the mediation of energy into diagnostically useful modes while reducing the energy mediated into disturbing contributions. For instance, it is often challenging to distinguish and extract the useful modes from ultrasound signals measured in bone covered by a soft tissue. We show that a laser diode array can selectively excite ultrasound in bone mimicking phantoms. A fiber-coupled diode array (4 elements) illuminated two solid tubes (2-3mm wall thickn…
Generalized Thru-Reflect-Line Calibration Technique for the Measurement of Multimodal Radiating Waveguides
2017
The objective of this letter is to extend the use of the generalized thru-reflect-line measurement technique to the case of a radiating multimodal rectangular waveguide aperture. Although this radiating aperture has been carefully studied from a theoretical point of view, the relevant experimental characterization has been limited to the case where the feeding waveguide is monomodal. In addition to theory, we also present experimental results that agree quite well with full-wave simulations, thereby fully validating the measurement technique.
Terahertz four-wire waveguides for broadband signal processing and multiplexing
2022
In this work, we introduce a versatile metal-wire waveguide geometry, namely a four-wire waveguide, which is capable of sustaining two independent and orthogonally polarized fundamental modes, thus acting as a broadband polarization-division multiplexer. By integrating multiscale-structured grooves into the wires of such a waveguide, we demonstrate the independent manipulation of polarization-division terahertz signals.
Multi-line NIR-RGB emission in Nd:LiNbO3 RPE optical waveguides
2007
Simultaneous generation of four spectral emission lines has been achieved in Nd-doped lithium niobate reverse proton exchange optical waveguide cavities. Using a pump at 800 nm, the four lines were found and they are due to lasing at 1.3735 combined with parametric conversion at 0.687, 0.574 and 0.4 mum.
Ultraviolet quasi-phase-matched second harmonic generation in surface periodically poled lithium niobate optical waveguides
2007
The compatibility of low concentration (alpha-phase) proton exchange channel waveguides with electric field surface periodic poling of congruent lithium niobate (SPPLN) crystals has been experimentally demonstrated. With such waveguides, we obtained ultraviolet second harmonic generation (SHG) by first order quasi-phase-matching (QPM), a result made possible by the fabrication, on Z-cut LN crystals, of periodic structures with a pitch down to 750 nm. Nonlinear copropagating QPM-SHG measurements have been carried out on such structures. The pump source was a Ti:sapphire laser with a tunability range of 700-980 nm and a 40 GHz linewidth. We have measured UV continuous wave light at 390 nm by …
Cantor-like fractal photonic crystal waveguides
2005
Abstract We propose a new class of one-dimensional (1D) photonic waveguides: the fractal photonic crystal waveguides (FPCWs). These structures are photonic crystal waveguides (PCWs) etched with fratal distribution of grooves such as Cantor bars. The transmission properties of the FPCWs are investigated and compared with those of the conventional 1D PCWs. It is shown that the FPCW transmission spectrum has self-similarity properties associated with the fractal distribution of grooves. Furthermore, FPCWs exhibit sharp localized transmissions peaks that are approximately equidistant inside the photonic band gap.
Efficient Design of Waveguide Manifold Multiplexers Based on Low-Order EM Distributed Models
2015
In this paper, a new systematic technique to design manifold-coupled multiplexers in waveguide technology is proposed. The new technique uses generalized low-order electromagnetic (EM) distributed models, which constitute a half-way point between the fast, but imprecise, analytical models, and the more accurate, but costly, full-wave EM models. The method can be applied to contiguous and noncontiguous channel multiplexers, in both E-plane or H-plane configurations. This paper covers the complete design procedure for manifold multiplexers, starting from the required specifications and finishing with the physical dimensions. After explaining the general design technique for multiplexers with …
Telecom-compatible, affordable and scalable quantum technologies
2022
The realistic implementation of quantum architectures relies on the development of scalable, resource-efficient platforms that are compatible with CMOS technologies as well as fiber networks. This work demonstrates novel schemes utilized for time-/frequency-bin entanglement generation and processing by leveraging existing telecommunications and integrated photonics infrastructures.
Spatial Solitons in Quadratic 2D Nonlinear Photonic Crystals
2007
We report on the first investigations into parametric solitary-wave formation in 2D nonlinear photonic crystals and present experimental results obtained in an hexagonally poled LiNbO3 waveguide designed for twin-beam second harmonic generation at telecom wavelengths.
Modelling leaky photonic wires: a mode solver comparison
2006
We present results from a mode solver comparison held within the framework of the European COST P11 project. The structure modelled is a high-index contrast photonic wire in silicon-oninsulator subject to substrate leakage. The methods compared are both in-house developed and commercial, and range from effective index and perturbation methods, over finite-element and finite-difference codes, beam propagation methods, to film mode matching methods and plane wave expansion methods.