Search results for "Wetting"
showing 10 items of 235 documents
First-order and tricritical wetting transitions in the two-dimensional Ising model caused by interfacial pinning at a defect line
2014
We present a study of the critical behavior of the Blume-Capel model with three spin states (S=±1,0) confined between parallel walls separated by a distance L where competitive surface magnetic fields act. By properly choosing the crystal field (D), which regulates the density of nonmagnetic species (S=0), such that those impurities are excluded from the bulk (where D=) except in the middle of the sample [where DM(L/2)≠], we are able to control the presence of a defect line in the middle of the sample and study its influence on the interface between domains of different spin orientations. So essentially we study an Ising model with a defect line but, unlike previous work where defect lines …
Kinetics of phase separation in thin films: simulations for the diffusive case.
2005
We study the diffusion-driven kinetics of phase separation of a symmetric binary mixture (AB), confined in a thin-film geometry between two parallel walls. We consider cases where (a) both walls preferentially attract the same component (A), and (b) one wall attracts A and the other wall attracts B (with the same strength). We focus on the interplay of phase separation and wetting at the walls, which is referred to as {\it surface-directed spinodal decomposition} (SDSD). The formation of SDSD waves at the two surfaces, with wave-vectors oriented perpendicular to them, often results in a metastable layered state (also referred to as ``stratified morphology''). This state is reminiscent of th…
Reactive surface coatings based on polysilsesquioxanes: universal method toward light-responsive surfaces.
2011
Reactive surface coatings were used as an ideal precursor coating for the fabrication of three different photoswitchable surface coatings in parallel. Different light-responsive moieties, such as azobenzene, salicylideneaniline, and spiropyran, were immobilized on glass, polycarbonate, and steel surfaces. Independent from the underlying substrate, wettability could be switched reversibly by UV irradiation. The maximum switching range was obtained after functionalization of the reactive coating with spiropyran, resulting in a contact angle difference between the two isomeric states of almost 30°.
Towards Laser-Textured Antibacterial Surfaces
2018
AbstractEscherichia coli and Staphylococcus aureus bacterial retention on mirror-polished and ultrashort pulse laser-textured surfaces is quantified with a new approach based on ISO standards for measurement of antibacterial performance. It is shown that both wettability and surface morphology influence antibacterial behavior, with neither superhydrophobicity nor low surface roughness alone sufficient for reducing initial retention of either tested cell type. Surface structures comprising spikes, laser-induced periodic surface structures (LIPSS) and nano-pillars are produced with 1030 nm wavelength 350 fs laser pulses of energy 19.1 μJ, 1.01 μJ and 1.46 μJ, respectively. SEM analysis, optic…
Volumetric Behaviour of Lime Treated High Plasticity Clay Subjected to Suction Controlled Drying and Wetting Cycles
2017
The paper presents some experimental results collected on samples recovered from an experimental embankment obtained by compacting a lime-treated clay. Samples were collected soon after the in situ compaction and they were cured in controlled environmental conditions for at least 18 months. Mercury intrusion porosimetry tests (MIP) were carried out on freeze-dried specimens to characterize the microstructure of the material. In order to assess the durability of the improved material, laboratory tests focused on the effects of cyclic variations of the degree of saturation on the water retention properties and the volumetric behaviour of the stabilized clay. Collected results show that the li…
Stress path dependence of hydromechanical behaviour of compacted scaly clay in wetting and drying suction controlled oedometer tests at constant vert…
2008
The results are presented of an experimental programme devoted to investigating the volumetric strain and water ratio (volume of water to volume of solids) evolution of a compacted scaly clay stressed by wetting and drying cycles in suction-controlled oedometer tests. The stress paths applied included loading and unloading cycles at constant matric suction and suction controlled wetting-drying cycles at constant vertical net stress. The test results show that during wetting and drying cycles the samples experienced irreversible shrinkage or swelling strains depending on the stress path applied. Irreversible water ratio increases were always observed in these cycles. However, a quasi-reversi…
Volume change behaviour of a compacted scaly clay during cyclic suction changes
2010
The research presented in this paper focuses on the investigation and modelling of the volume change response of compacted tectonised clay samples subjected to several wetting and drying cycles in controlled-suction oedometers. Oedometer tests were carried out under different values of constant vertical net stress, and wetting and drying cycles were performed varying applied matric suction between 10 and 800 kPa. The investigation was complemented with a study of the material microstructure to support the interpretation of the overall mechanical response. At a microscopic level, the material is characterized by different types of particle assemblages, scales, and clay aggregates. One of th…
Anisotropic Volumetric Response of Shales upon Suction Changes
2016
Anisotropic fabric and volumetric response to suction changes represent two main features of shales, which are involved in several engineering applications. However, a comprehensive understanding of the interaction between these two aspects is still missing. The present work aims to provide a detailed analysis of the coupling between the water retention capacity of shales and their anisotropic behaviour through an advanced experimental methodology. Among the various tested facies of the Opalinus Clay Shale (Mont Terri, Switzerland), the results from the shaly facies are presented in this study. The behaviour of the material is characterized by swelling and shrinkage respectively upon wettin…
Anisotropic volumetric behaviour of Opalinus clay shale upon suction variation
2016
Opalinus clay shale is under consideration to serve as the host geomaterial for the underground storage of nuclear waste in Switzerland. Water retention behaviour and anisotropic behaviour represent two main features of this geomaterial; however, a comprehensive understanding of the interaction between these two features is still lacking. This paper aims to provide a detailed experimental analysis of the coupling between the water retention capacity and the anisotropic behaviour of two facies (shaly and sandy) of the Opalinus clay shale. The response of the tested geomaterials is characterised by an unequal swelling and shrinkage response in directions parallel and perpendicular to the bed…
Surface Effects on Block Copolymer Melts Above the Order-Disorder Transition: Linear Theory of Equilibrium Properties and the Kinetics of Surface-Ind…
1997
A phenomenological theory is developed for static and dynamic aspects ofsurface- induced ordering of symmetrical block copolymers taking fluctuation corrections into account, but, considering conditions where the bulk block copolymer melt is still disordered, and a lin- earized version of the resulting Ginzburg-Landau type equation suffices. Both the semi-infinite geometry and symmetrical films of thickness 2L are treated, applying the same boundary con- ditions as used previously for a treatment of wetting in polymer blends, assuming short range surface forces and a long Wavelength approximation. For the static order parameter profile in thin film geometry, We derive an oscillatory converg…