Search results for "Width"
showing 10 items of 690 documents
High-Energy pulse profile of the Transient X-ray Pulsar SAX J2103.5+4545
2005
In two recent INTEGRAL papers, Lutovinov et al. (2003) and Blay et al. (2004) report a timing and spectral analysis of the transient Be/X-ray pulsar SAX J2103.5+4545 at high energies (5--200 keV). In this work we present for the first time a study of the pulse profile at energies above 20 keV using INTEGRAL data. The spin-pulse profile shows a prominent (with a duty cycle of 14%) and broad (with a FWHM of ~ 51 s) peak and a secondary peak which becomes more evident above 20 keV. The pulsed fraction increases with energy from ~ 45% at 5--40 keV to ~ 80% at 40--80 keV. The morphology of the pulse profile also changes as a function of energy, consistent with variations in the spectral componen…
Analysis of femtosecond Raman-induced polarization spectroscopy (RIPS) in N2 and CO2 by fitting and scaling laws
2000
Raman-induced polarization spectroscopy (RIPS) experiments were conducted at room temperature and pressures below 2 atm in pure N2 and CO2. Both homodyne and optically heterodyne detection were used. Calculations of the signal as a function of the pump–probe delay were performed taking into account the pulse duration of the laser, the rotational dependence of the dephasing rates and the small instantaneous electronic Kerr effect. The observed decay and shape of the rotational quantum beats are in good agreement with the calculations. Several sets of linewidth coefficients corresponding to the diagonal part of the collisional–rotational relaxation matrix were used. This matrix was choosen am…
Experimental observation of the spectral Gouy phase shift
2013
We experimentally observe and measure the spectral phase shift of a pulse subjected to spectral focusing. We find a phase shift of π/2, reaffirming the Gouy phase shift as a general consequence of wave confinement whether in space/momentum or frequency/time coordinates.
All-Fibered High-Quality 20-GHz and 40-GHz Picosecond Pulse Generator
2011
International audience; In this work, we investigate the generation of 20 and 40 GHz pulse trains by nonlinear compression of an initial beating in a cavity-less optical-fiber-based configuration. High temporal stability is obtained by generating the sinusoidal beating by means of an intensity modulator driven by an external clock. The residual timing jitter induced by the RF phase modulation is then reduced by managing the cumulated dispersion of the compression line whereas complete polarization stabilization is obtained thanks to a modified setup including a Faraday rotator mirror. Finally a high-quality 160 Gbit/s signal is generated from our low duty-cycle 40 GHz pulse source thanks to…
Elastic Metasurfaces for Deep and Robust Subwavelength Focusing and Imaging
2021
International audience; Metasurfaces are planar metamaterials with a flat surface and a subwavelength thickness that are able to shape arbitrary wave fronts such as focusing or imaging. There is a broad interest in the literature about subwavelength focusing and imaging based on bulk metamaterials while the utilization of metasurfaces for elastic waves has rarely been reported. Here, we present a type of elastic metasurface consisting of a line of gradient resonant pillars for robust deep subwavelength focusing and imaging of elastic waves in a plate. Numerical approaches supported by analytic Huygens-Fresnel demonstrations show that the subwavelength full width at half maximum (FWHM) behav…
Phase Noise and Frequency Stability of the Red-Pitaya Internal PLL
2019
In field-programmable gate array platforms, the main clock is generally a low-cost quartz oscillator whose stability is of the order of $10^{-9}$ to $10^{-10}$ in the short term and $10^{-7}$ to $10^{-8}$ in the medium term, with the uncertainty of tens of ppm. Better stability is achieved by feeding an external reference into the internal phase-locked loop (PLL). We report the noise characterization of the internal PLL of Red-Pitaya platform, an open-source embedded system architected around the Zynq 7010 System on Chip, with analog-to-digital and digital-to-analog converters. Our experiments show that, providing an external 10-MHz reference, the PLL exhibits a residual frequency stability…
Dielectric metalenses with engineered point spread function
2017
High-index silicon nanoblocks support excitation of both electric and magnetic resonance modes at telecommunication wavelengths. At frequencies where both electric and magnetic resonance modes are excited simultaneously, changing the geometrical dimensions of the silicon cubes creates a 2π full span over the phase of the transmitted light in different amplitude ranges. We take advantage of the additional power-flux modulation of the scattered signal to focus the incident light with desired full width at half maximum (FWHM) and side lobe levels (SLLs) in both the lateral and axial directions. By implementing proper amplitude filters within the telecommunication working wavelength (1.55 μm), …
Sodium vapor cell laser guide star experiments for continuous wave model validation
2016
Recent numerical simulations and experiments on sodium Laser Guide Star (LGS) have shown that a continuous wave (CW) laser with circular polarization and re-pumping should maximize the fluorescent photon return flux to the wavefront sensor for adaptive optics applications. The orientation and strength of the geomagnetic field in the sodium layer also play an important role affecting the LGS return ux. Field measurements of the LGS return flux show agreement with the CW LGS model, however, fluctuations in the sodium column abundance and geomagnetic field intensity, as well as atmospheric turbulence, induce experimental uncertainties. We describe a laboratory experiment to measure the photon …
Broadband printed dipole with integrated via-hole balun for WiMAX applications
2010
A broadband balanced printed dipole antenna for WiMAX applications (2.5/3.6 GHz) is presented. An integrated via-hole balun is used to feed the antenna and a Yagi-like scheme is proposed to improve the gain. The design has been optimized by means of parametric FDTD simulations. The antenna was fabricated and measured, giving a bandwidth higher than 50% and a gain higher than 4 dBi. © 2010 Wiley Periodicals, Inc. Microwave Opt Technol Lett 53:52–55, 2011; View this article online at wileyonlinelibrary.com. DOI 10.1002/mop.25671
High-rate x-ray spectroscopy in mammography with a CdTe detector: A digital pulse processing approach
2010
Purpose:Direct measurement of mammographic x-ray spectra under clinical conditions is a difficult task due to the high fluence rate of the x-ray beams as well as the limits in the development of high resolution detection systems in a high counting rate environment. In this work we present a detection system, based on a CdTe detector and an innovative digital pulse processing (DPP) system, for high-rate x-ray spectroscopy in mammography. Methods: The DPP system performs a digital pile-up inspection and a digital pulse height analysis of the detector signals, digitized through a 14-bit, 100 MHz digitizer, for x-ray spectroscopy even at high photon counting rates. We investigated on the respon…