Search results for "Wind Power"
showing 10 items of 178 documents
Technological and legislative status point of stationary energy storages in the EU
2019
Abstract European renewable generation has been supported through several policy instruments in the last decades, and this has caused a significant growth of the renewable energy sector, spurred by the ambitious climate and energy policy targets. Despite this impetuous growth, the electricity infrastructure is not yet ready to accept increasing shares of variable renewable energy sources (RES) generation, and this is causing grid balance challenges, due to the inherently variable nature of the PV and wind energy. In order to overcome this issue, allowing higher shares of renewable generation in the energy sector, energy storage (ES) systems are becoming increasingly competitive in the globa…
Weather sensor fault detection in meteorological masts
2020
Wind power has become the world’s fastest growing renewable technology. The world-wide wind power installed capacity has exceeded 597 GW, and the new installations during the last three years was an average of 50 GW per year. A major issue with wind power system and with meteorological masts is the relatively high cost of operation and maintenance (OM). Wind turbines and sensor towers are hard-to-access structures, and they are often located in remote areas. That’s why continuous monitoring of wind turbine health using automated failure detection algorithms can improve turbine reliability and reduce maintenance costs by detecting failures before they reach a catastrophic stage and by elimin…
Analysis and modeling of wind directions time series
2013
This work aims at studying some aspects of wind directions in Italy and supplying appropriate models. A comparison is presented between independent mixture and Hidden Markov models, which seem to be appropriate as far as the series we studied.
Wind speed spatial estimation for energy planning in Sicily: introduction and statistical analysis
2008
Abstract The exploitation of the renewable energy sources plays a key role for achieving the CO 2 emissions reduction targets established by the Kyoto Protocol, as well as for facing the shortage of world fossil fuels reserves. In countries like Italy, with an high potential in terms of wind power generation, an efficient energy planning based on renewables is a very complex task. It encompasses many aspects: the resource availability assessment, the compliance with environmental and legislative constraints and last, but not least, the technical aspects linked to the safe integration to the grid of the intermittent power generated by the wind farms. This paper is the first part of a study a…
The formation of feed-in tariffs and the emergence of wind power in Finnish routine corporatism: favoring the economics of large-scale energy product…
2021
We explore the role and influence of the Finnish energy elite’s inner circle in the process of transition to renewable energy. Finland is a corporatist country where economic interest groups have p...
Buckling strength of steel tube for lifting telescopic wind steel tower
2021
Abstract A telescopic pole for wind energy production with low environmental impact and its lifting system for a 60–250 kW turbine and a height of 30 m have been designed and manufactured. The tower, was raised and lowered by automation or by remote control, that allows one to differentiate the presence of the generator within the landscape over time. The jacking systems acting on the legs had a combination of holes (on the legs) and pegs actuated by hydraulic pistons. The aim of the paper was the experimental and the analytical verification of the stability condition of the steel piston as a lifting system of the prototype. An experimental investigation was carried out on small-scale speci…
Active heave compensation of floating wind turbine installation using a catamaran construction vessel
2021
Abstract The application of floating wind turbines is limited by the high cost that increases with the water depth. Offshore installation and maintenance continue to consume a high percentage of the project budget. To improve the installation efficiency of the floating offshore wind turbine, a novel concept is proposed by the SFI MOVE project. Several wind turbine superstructure components are preassembled onshore and carried to the installation site by a catamaran construction vessel. Each assembly can then be installed using only one lift, and the concept is less sensitive to weather conditions. In this paper, a control algorithm of the proposed hydraulic active heave compensator system i…
Hybrid Energy System for Rural Electrification in Sri Lanka: Design Study
2015
Off-grid hybrid renewable energy based power system for rural electrification has become an attractive solution for areas where grid electricity is not feasible. Depending on the availability of the resources, single energy source or a combination of several sources, including an energy storage system is used in an off-grid hybrid energy system. As there can be several candidates, the optimum sizing of the components against resource potential, cost and reliability is a vital issue. This chapter presents a study of optimum sizing of a renewable sources based off-grid hybrid energy system that is designed for electrifying a rural community in the Siyambalanduwa area in Sri Lanka. The communi…
Diagnostics of stator winding failures in wind turbine pitch motors using Vold-Kalman filter
2019
Pitch systems are among the most failure-prone components in wind turbines. Winding failures in pitch motors are common due to high start-up loads and poor ventilation. This article presents a diagnostics scheme that can detect the stator winding failures in the pitch motors under time-varying speed and load conditions. The proposed approach based on three-phase motor currents can be directly integrated into the motor drive and can be used for induction as well as permanent magnet synchronous machines. The extended Park's vector calculated on the motor currents is order tracked based on the supply frequency from the drive using Vold-Kalman filter. The approach is shown to be robust under ar…
Optimizing the generation system in a microgrid with power, thermal energy and mobility demands
2021
Microgrids are widely known to be the future of generation and distribution systems. This paper presents a method to optimize the size of the main components in a microgrid to supply the demands for electricity, heating and hydrogen for mobility through an Energy Hub model. The electricity production from a wind turbine, a CHP and a fuel cell satisfies the local electricity demand. The green hydrogen produced in the hub from renewable power in off-peak hours is used to feed the fuel cell or to meet the mobility demand. The heating power from CHP and fuel cell is used to feed the local district heating network.