Search results for "Wireless"
showing 10 items of 879 documents
Partial discharge detection and localization along medium voltage cables
2017
In the last years different partial discharge (PD) measuring techniques have been developed because PD diagnostic is the most widely tool to evaluate the insulation condition of a power cable. Recently non-conventional methods and sensors have been used in order to reach improved results in PD measurements. The purpose of this work is to perform measurements that allow to study the variation of pulses when they travel along a MV cable and to locate the pulse source through the time arrival difference of the pulses obtained from two sensors installed separately.
Critical issues in the PD testing methodology for XLPE-insulated MV cables: An experimental case
2017
This paper describes some critical issues arising during the partial discharge (PD) testing of a 500m delivery length of an XLPE-insulated MV cable. At first, conventional PD measurements were performed on the whole length by using a standard acquisition system; PDs activity was detected, but the system allowed the operator to localize the PDs only on a length of 70 m. A visual inspection of this section highlighted the presence of an excoriation in the outer sheet. Aiming at a more accurate pin-pointing of the defect, more measurements were carried out in the proximity of the outer defect using a portable PD detection system. These measurements showed PDs activity, whose source was located…
Potential of Automated Digital Hemispherical Photography and Wireless Quantum Sensors for Routine Canopy Monitoring and Satellite Product Validation
2021
To better characterize the temporal dynamics of vegetation biophysical variables, a variety of automated in situ measurement techniques have been developed in recent years. In this study, we investigated automated digital hemispherical photography (DHP) and wireless quantum sensors, which were installed at two sites under the Copernicus Ground Based Observations for Validation (GBOV) project. Daily estimates of plant area index (PAI) and the fraction of absorbed photosynthetically active radiation (FAPAR) were obtained, which realistically described expected vegetation dynamics. Good correspondence with manual DHP and LAI-2000 data (RMSE = 0.39 to 0.90 for PAI, RMSE = 0.07 for FAPAR) provid…
Performance analysis of Alamouti-coded OFDM systems over spatio-temporally correlated underwater acoustic channels
2017
In this paper, we analyze the performance of Alamouti-coded orthogonal frequency division multiplexing (OFDM) systems over time-varying underwater acoustic (UWA) channels. A realistic UWA channel model has been considered, which can be correlated in either time or space or simultaneously in both domains. An exact analytical expression for the bit error probability (BEP) is necessary to analyze accurately the performance of Alamouti-coded OFDM systems over the spatio-temporally correlated UWA channel model. Hence, by using this UWA channel model, an expression has been derived for the BEP of Alamouti-coded OFDM systems assuming that the receiver knows perfectly the channel state information.…
Communication cost of channel estimation interpolation for group-based vehicular communications in cellular networks
2020
Las comunicaciones inalámbricas para aplicaciones vehiculares en sistemas celulares de quinta generación (5G) deben ser de baja latencia y alta fiabilidad. Entre otros factores, la cantidad de información de control que debe intercambiarse entre cada vehículo y la estación base puede penalizar la latencia de la comunicación. Varios casos de uso vehicular 5G implican comunicaciones dentro de grupos de vehículos, por ejemplo el pelotón de vehículos. Este trabajo se centra en explotar la estructura y características de este servicio vehicular particular basado en grupos para disminuir el intercambio de información de control relacionado con la etapa de estimación del canal necesaria para las c…
Peer-to-peer cooperative GNSS-based localization for stationary reference nodes in wireless sensor networks
2017
Most localization algorithms in wireless sensor networks rely on a few reference nodes with known locations to estimate the locations of unknown nodes. The locations of reference nodes can be either manually configured or, more practically, obtained by means of some satellite-based positioning system(s). However, satellite-based locations may be inaccurate and imprecise, which results in reduced location accuracy of localization algorithms. This paper proposes a peer-to-peer cooperative GNSS-based localization algorithm for stationary reference nodes to improve their relative location accuracy and precision. The algorithm applies simple statistical methods and GNSS-based information from mu…
Wireless NoC for Inter-FPGA Communication: Theoretical Case for Future Datacenters
2020
Integration of FPGAs in datacenters might have different motivations from acceleration to energy efficiency, but the goal of better performance tops all. FPGAs are being utilized in a variety of ways today, tightly coupled with heterogenous computing resources, and as a standalone network of homogenous resources. Open source software stacks, propriety tool chain, and programming languages with advanced methodologies are hitting hard on the programmability wall of the FPGAs. The deployment of FPGAs in datacenters will neither be sustainable nor economical, without realizing the multi-tenancy in multiple FPGAs. Inter-FPGA communication among multiple FPGAs remained relatively less addressed p…
Security and Privacy in Wireless IoT
2018
The 13 articles in this special section focus on security and privacy in wireless Internet of Things (IoT). IoT is a paradigm that involves networked physical objects with embedded technologies to collect, communicate, sense, and interact with the external environment through wireless or wired connections. With rapid advancements in IoT technology, the number of IoT devices is expected to surpass 50 billion by 2020, which has also drawn the attention of attackers who seek to exploit the merits of this new technology for their own benefits. There are many potential security and privacy threats to IoT, such as attacks against IoT systems and unauthorized access to private information of end u…
Thorough analysis of Raspberry Pi devices in outdoor/indoor communications in terms of QoS
2020
The proliferation of commercial low-cost Small Board Computers (SBC) devices have allowed the deployment of many Wireless Sensor Networks (WSN) focused on different applications, mainly based on monitoring issues. These networks are characterized by a set of these SBCs devices working in a collaborative way where each device is sensing, processing and later sending out the data to the sink. These devices are equipped with power supply, a processing unit and communications capabilities (in particular WiFi), making themselves very interesting to fit in many topologies. However, their performance in terms of communications basically depends on the environment and usually heuristic techniques a…
Experimental trade-offs between different strategies for multihop communications evaluated over real deployments of wireless sensor network for envir…
2018
Although much work has been done since wireless sensor networks appeared, there is not a great deal of information available on real deployments that incorporate basic features associated with these networks, in particular multihop routing and long lifetimes features. In this article, an environmental monitoring application (Internet of Things oriented) is described, where temperature and relative humidity samples are taken by each mote at a rate of 2 samples/min and sent to a sink using multihop routing. Our goal is to analyse the different strategies to gather the information from the different motes in this context. The trade-offs between ‘sending always’ and ‘buffering locally’ approac…