Search results for "Witch"
showing 10 items of 542 documents
The influence of platform switching in dental implants. A literature review.
2010
Introduction: The platform switching concept involves the reduction of the restoration abutment diameter with respect to the diameter of the dental implant. In 1991, dental implants of 5 and 6 mm diameter platforms were introduced. However, matching-diameter prosthetic abutments were not available. These implants were restored with “standard”-diameter prosthetic components (4,1 mm). Long-term follow up around these wide-platforms showed higher levels of bone preservation. In time, it has been called platform switching. The first case report applying this concept was indexed in MedLine in 2005. Materials and Methods: The aim of this article is to carry out a literature review of articles whi…
The influence of platform switching on the biomechanical aspects of the implant-abutment system. A three dimensional finite element study
2011
Objective: To evaluate the biomechanical scenario of platform switching geometric implant-abutment configuration relative to standard configurations by means of finite element analysis.Study Design: A 3D Finite Element Analysis (FEA) was performed on 3 different implant-abutment configurations: a 3.8 mm implant with a matching diameter abutment (Standard Control Design, SCD), a 5.5 mm implant with matching diameter abutment (Wider Control Design, WCD), and a 5.5mm implant with a 3.8 mm abutment (Experimental Design, ED). All the different experimental groups were discretized to over 60000 elements and 100000 nodes, and 130N vertical (axial) and 90N horizontal loads were applied on the coron…
On-line trace enrichment for the determination of ethacrynic acid in urine by liquid chromatography and column-switching
1993
Abstract A chromatographic method based on liquid chromatography (LC) using column-switching for the determination of ethacrynic acid in urine samples, is described. The proposed system uses a Hypersil ODS-C18, 30 μm (20 mm × 2.1 mm i.d.) pre-column for the pre-concentration and separation of ethacrynic acid from the biological matrix. Polar urinary compounds are removed by flushing the pre-column with purified water, and the enriched analyte is then switched in back-flush mode onto an HP-LiChrospher RP C18, 5 μm (125 × 4 mm i.d.) analytical column, where it is chromatographed using an acetonitrile-acetate buffer gradient elution. The UV detector was set at 275 nm. The recovery of drug was …
Conceptual design of the TRACE detector readout using a compact, dead time-less analog memory ASIC
2015
[EN] The new TRacking Array for light Charged particle Ejectiles (TRACE) detector system requires monitorization and sampling of all pulses in a large number of channels with very strict space and power consumption restrictions for the front-end electronics and cabling. Its readout system is to be based on analog memory ASICs with 64 channels each that sample a View the MathML source window of the waveform of any valid pulses at 200 MHz while discarding any other signals and are read out at 50 MHz with external ADC digitization. For this purpose, a new, compact analog memory architecture is described that allows pulse capture with zero dead time in any channel while vastly reducing the tota…
Single-frequency active Q-switched Distributed Fiber Laser Using Acoustic Waves
2007
This letter presents a single mode, actively Q-switched distributed feedback fiber laser. Acoustic pulses are launched into an erbium-doped fiber Bragg grating, resulting in the introduction of a traveling defect. Thus, a transmission peak appears in the reflection band while the pulse travels along the grating. This effect allows the laser to operate in a Q-switched regime, providing optical pulses which repetition rate was continuously tuned up to 10 kHz. Pulses of 168 mW of peak power and 73 ns of temporal width were obtained at low repetition rate.
Dual-kind Q-switching of erbium fiber laser
2014
Two different regimes of Q-switching in the same implementation of an actively Q-switched erbium-doped fiber laser are demonstrated. Depending on the active fiber length and repetition rate of an intracavity Q-cell (acousto-optic modulator), the laser operates either in the regime of common, rather long and low-power, pulses composed of several sub-pulses or in the one of very short and powerful stimulated Brillouin scattering-induced pulses. The basic physical reason of the laser system to oscillate in one of these two regimes is the existence or absence of CW narrow-line “bad-cavity” lasing in the intervals when the Q-cell is blocked.
All-fiber actively Q-switched Yb-doped laser
2006
Abstract An all-fiber actively Q-switched Yb-doped laser is presented. Q-switching is performed by modulating a fiber Bragg grating via a magnetostrictive rod which is fixed to the fiber at the position of the grating. By exposing the rod to a changing magnetic field, the rod is stretched and relaxed causing the Bragg wavelength of the grating to shift and thereby changes the Q-factor of the cavity. Using Yb-doped fiber, pulses at 1052 nm are obtained at repetition rates from 1 to 200 kHz. At 75 kHz, 0.5 μJ pulses with peak powers of 3 W can be produced when 180 mW of pump power is applied. To the knowledge of the authors, this is the first all-fiber actively Q-switched Yb-doped laser prese…
Q-switched all-fibre laser using a fibre-optic resonant acousto-optic modulator
2007
Abstract We report an actively Q-switched all-fibre laser using a fibre-optic resonant acousto-optic modulator as Q-switching element. The modulator consists of a short-length fibre Bragg grating modulated by a standing longitudinal elastic wave, being the grating length much shorter than the acoustic wavelength. Q-switch pulses were successfully obtained from an Er3+-doped fibre laser at repetition rates of 18 and 37 kHz.
Enhanced Q-switched distributed feedback fiber laser based on acoustic pulses
2009
An acoustically Q-switched distributed feedback fiber laser with enhanced performance is presented. It is based on an FBG written in an erbium doped fiber, in which a dynamic defect is introduced by means of a short acoustic pulse. The performance of the laser depends on the reflectivity of the grating. In this work, we present two different Q-switched distributed feedback fiber lasers realized with active gratings of different reflectivities. Both lasers are characterized at different pump powers and repetition rates. It is shown that the performance of the laser based on the weaker grating was significantly improved with respect to the laser based on the stronger grating. In terms of peak…
Impact of wage penalty on mobility return of French PhDs
2015
International audience; Expatriation of higher-education graduates raises much concern in many countries often in conjunction with talk about the brain drain. It supposedly entails a risk of losing the skills required for a competitive economy. The issue is all the more acute for PhD graduates, who are expected to play a major part in the knowledge economy. However, questions arise as to the causes of such mobility and its consequences for young graduates' individual career paths.