Search results for "ZINC OXIDE"
showing 10 items of 80 documents
One-pot synthesis of ZnO nanoparticles supported on halloysite nanotubes for catalytic applications
2020
Abstract A versatile catalyst based on halloysite and zinc oxide (HNT@ZnO) was prepared, for the first time, starting from ZnO commercial bulk form as Zn precursor source, in a one-pot procedure. This strategy gives the possibility to obtain small ZnO nanoparticles loaded on the HNT surface without the use of inorganic salts which envisage the removal of undesired anions and therefore a calcination process at high temperature. It was found that the presence of halloysite improved the UV–vis spectral absorption ability of ZnO. The hybrid was successful used as photocatalyst for the methylorange and rhodamine B degradation. In addition, after eight consecutive cycles for the methylorange phot…
ZnO-latex hybrids obtained by polymer-controlled crystallization: a spectroscopic investigation.
2007
Micro- and submicrosized ZnO-polymer hybrid materials were synthesized by precipitating zinc oxide from an aqueous medium in the presence of poly(styrene-acrylic acid) latex nanoparticles, prepared by miniemulsion polymerization. Up to 10 wt % of the latex becomes incorporated into the crystals. Although the long-range order of the inorganic material is essentially not altered by the polymer, studies by photoluminescence (PL) spectroscopy and electron paramagnetic resonance (EPR) show that the latex particles influence the optical and paramagnetic properties of the hybrids, which can be correlated with changes in the defect structure. Typical PL emission spectra showed a narrow UV peak and …
Optical, structural, and morphological characterisation of epitaxial ZnO films grown by pulsed-laser deposition
2013
We report on ZnO epitaxial growth by pulsed-laser deposition (PLD) on different substrates, such as quartz, sapphire, and GaN template. Approximately 1 mu m-thick films were grown under different substrate temperatures and background oxygen conditions. X-ray diffraction analysis indicated preferential growth along the c-axis direction with a full-width at half maximum(FWHM) of the rocking curve as narrow as 230 arcs in the case of the GaN template. Low-temperature photoluminescence showed A-excitonic emission near 3.36 eV and a FWHM of (DXA)-X-0 emission as small as 2.89 meV at 9 K. Atomic force microscope measurements showed that roughness as low as 18 nm could be obtained. These results p…
Cellulose-inorganic hybrids of strongly reduced thermal conductivity
2022
Abstract The employment of atomic layer deposition and spin coating techniques for preparing inorganic-organic hybrid multilayer structures of alternating ZnO-CNC layers was explored in this study. Helium ion microscopy and X-ray reflectivity showed the superlattice formation for the nanolaminate structures and atomic force microscopy established the efficient control of the CNCs surface coverage on the Al-doped ΖnO by manipulating the concentration of the spin coating solution. Thickness characterization of the hybrid structures was performed via both ellipsometry and X-ray reflectivity and the thermal conductivity was examined by time domain thermoreflectance technique. It appears that ev…
Antimicrobial Bilayer Nanocomposites Based on the Incorporation of As-Synthetized Hollow Zinc Oxide Nanotubes
2020
© 2020 by the authors.
Hydroformylation of 1-Hexene over Rh/Nano-Oxide Catalysts
2013
The effect of nanostructured supports on the activity of Rh catalysts was studied by comparing the catalytic performance of nano- and bulk-oxide supported Rh/ZnO, Rh/SiO₂ and Rh/TiO₂ systems in 1-hexene hydroformylation. The highest activity with 100% total conversion and 96% yield of aldehydes was obtained with the Rh/nano-ZnO catalyst. The Rh/nano-ZnO catalyst was found to be more stable and active than the corresponding rhodium catalyst supported on bulk ZnO. The favorable morphology of Rh/nano-ZnO particles led to an increased metal content and an increased number of weak acid sites compared to the bulk ZnO supported catalysts. Both these factors favored the improved catalytic performan…
Room-temperature plasma-enhanced atomic layer deposition of ZnO: Film growth dependence on the PEALD reactor configuration
2017
Room-temperature plasma-enhanced atomic layer deposition (PEALD) of ZnO was studied by depositing the films using diethylzinc and O2 plasma from inductively-coupled plasma (ICP) and capacitively-coupled plasma (CCP) plasma source configurations. The CCP-PEALD was operated using both remote and direct plasma. It was observed that the films deposited by means of remote ICP and CCP were all highly oxygen rich, independently on plasma operation parameters, but impurity (H, C) contents could be reduced by increasing plasma pulse time and applied power. With the direct CCP-PEALD the film composition was closer to stoichiometric, and film crystallinity was enhanced. The ZnO film growth was observe…
Anti-bacterial activity of graphene oxide as a new weapon nanomaterial to combat multidrug-resistance bacteria.
2016
Antibiotic resistance in microbial pathogens has become a serious health problem in the world. The increasing spread of hospital acquired infections especially in immunocompromised and cancer patients caused by multidrug-resistant (MDR) microbial pathogens is restricting the choices for impressive antibiotic therapy. So many efforts have been made to develop new compounds with antimicrobial activity. In recent years, nanoparticles, particularly graphene oxide (GO) nanoparticles have found many applications in various fields, including antibacterial action, pathogens bio detection, cancer therapy, and drug and gene delivery. The use of graphene oxide as an antibacterial agent for the treatme…
A zinc-doped endodontic cement facilitates functional mineralization and stress dissipation at the dentin surface
2018
Objective: The purpose of this study was to evaluate nanohardness and viscoelastic behavior of dentin surfaces treated with two canal sealer cements for dentin remineralization. Material and Methods: Dentin surfaces were subjected to: i) 37% phosphoric acid (PA) or ii) 0.5 M ethylenediaminetetraacetic acid (EDTA) conditioning prior to the application of two experimental hydroxyapatite-based cements, containing sodium hydroxide (calcypatite) or zinc oxide (oxipatite), respectively. Samples were stored in simulated body fluid during 24 h or 21 d. The intertubular and peritubular dentin were evaluated using a nanoindenter to assess nanohardness (Hi). The load/displacement responses were used f…
Laser irradiation of ZnO:Al/Ag/ZnO:Al multilayers for electrical isolation in thin film photovoltaics
2013
Laser irradiation of ZnO:Al/Ag/ZnO:Al transparent contacts is investigated for segmentation purposes. The quality of the irradiated areas has been experimentally evaluated by separation resistance measurements, and the results are complemented with a thermal model used for numerical simulations of the laser process. The presence of the Ag interlayer plays two key effects on the laser scribing process by increasing the maximum temperature reached in the structure and accelerating the cool down process. These evidences can promote the use of ultra-thin ZnO:Al/ Ag/ZnO:Al electrode in large-area products, such as for solar modules. © 2013 Crupi et al.; licensee Springer.