Search results for "acids"

Self-Ordering Secondary Structure of d- and l-Arginine-Derived Polyamidoamino Acids

2017

This paper reports on synthesis, acid–base properties and pH-dependent structuring in water of d-, l- and d,l-ARGO7, bioinspired polymers obtained by polyaddition of the corresponding arginine stereoisomers with N,N′-methylenebis(acrylamide). The circular dichroism spectra of d- and l-ARGO7 showed a peak at 228 nm and quickly and reversibly responded to pH changes, but were nearly unaffected by temperature, ionic strength, and denaturating agents. Theoretical modeling studies of L-ARGO7 showed that it assumed a folded structure. Intramolecular interactions led to transoid arrangements of the main chain reminiscent of the protein hairpin motif. Torsion angles showed a quite similar distribut…

Tuning the photocatalytic activity of bismuth wolframate: Towards selective oxidations for the biorefinery driven by solar-light

2017

The sol–gel entrapment of nanostructured Bi2WO6 enhances the activity and the selectivity of the short-gap semiconductor in the sunlight-driven photo-oxidation of trans-ferulic and trans-cinnamic acid dissolved in water with air as the primary oxidant. Valuable products such as vanillin, benzaldehyde, benzoic acid and vanillic acid are obtained. This provides the proof of concept that photocatalysis could be a promising technology in tomorrow's solar biorefineries.

Selective Implantation of Diamines for Cooperative Catalysis in Isoreticular Heterometallic Titanium–Organic Frameworks

2021

[EN] We introduce the first example of isoreticular titanium-organic frameworks, MUV-10 and MUV-12, to show how the different affinity of hard Ti(IV) and soft Ca(II) metal sites can be used to direct selective grafting of amines. This enables the combination of Lewis acid titanium centers and available -NH, sites in two sizeable pores for cooperative cycloaddition of CO2 to epoxides at room temperature and atmospheric pressure. The selective grafting of molecules to heterometallic clusters adds up to the pool of methodologies available for controlling the positioning and distribution of chemical functions in precise positions of the framework required for definitive control of pore chemistr…

Calculations on solvents and co-solvents of single-wall carbon nanotubes: Cyclopyranoses

2005

Abstract (10,10) single-wall carbon nanotube (SWNT) presents consistency between relatively small solubility, and great partition coefficients and kinetic stability. Solubility of SWNTs is investigated in a variety of solvents, finding a class of non-hydrogen-bonding Lewis bases that provides good solubility. Electron affinity of d -glucopyranoses ( d -Glcpn) suggests colloids of negatively charged SWNTs in water.

Modified arabinoxylan-based films. Part B. Grafting of omega-3 fatty acids by oxygen plasma and electron beam irradiation.

2003

Arabinoxylans (AXs) are byproducts of the cereal milling industry. To obtain high-value products, AXs have been used as a film-forming agent. Hence, AX-based films are poor water vapor barriers. The objectives of this study were to graft omega-3 (omega3) fatty acids onto AX polymeric chains by using two new technologies: cold plasma and electron beam (EB) irradiation. Results show that the surface hydrophobicity of the modified films is higher than that of a waxy coating or a low-density polyethylene (LDPE) film. In addition, FTIR spectroscopy analysis reveals vibration bands attributed to new chemical functions. Finally, a decrease in water vapor permeability (WVP) is obtained for the film…

Comparative study of the lubricant performance of Compritol 888 ATO either used by blending or by hot melt coating.

2003

Compritol 888 ATO is used as a lubricant in oral solid dosage formulations. It can also be used as a hot melt coating agent sprayed onto a powder. In this study, we compare the lubricant performance of Compritol 888 ATO either used by classical blending or by hot melt coating onto Lactopress by compression tests. In physical mix, the Compritol concentration does not affect the compressibility. The same compressibility is obtained with lactose coated by 0.5 or 1% of Compritol, but a higher compressibility can be observed with 2 and 3%. Cohesiveness of lactose depends on the process: hot melt coating induces a decrease of tablet tensile strength. In terms of forces transmission during compres…

Heterogeneous photo-assisted catalytic hydration/dehydration reactions based on Keggin and Wells-Dawson type heteropolytungstates

2021

Polyoxometalates (POMs) are a wide class of metal-oxygen clusters that can be applied in acid and oxidation catalysis, medicine, electrochemistry, materials design, or models for self-assembling nanoscale systems as long as green and cheap photocatalysts. Heteropolyacids (HPAs) are a POM subclass extensively used as homogeneous photocatalysts for the oxidation of organic substrates. Dispersing HPAs onto solid supports with a high surface area increases their specific surface area and hence (photo)catalytic activity. This chapter reports the use of selected HPAs, heteropolytungstates, immobilized on different supports as heterogeneous photocatalysts.

POSITIONING SELF-ETCHING ADHESIVES: VERSUS OR IN ADDITION TO PHOSPHORIC ACID ETCHING?

2004

Structural and optical properties of Fe and Zn substituted CuInS2 nanoparticles synthesized by a one-pot facile method

2015

We substitute indium present in the CuInS2 ternary compound by iron and zinc using a facile one-pot synthesis method. The quaternary compound of CuIn1−xMxS2 (M = Fe and Zn) was synthesized by dissolving CuCl, InCl3, FeCl3, Zn(ac)2 and SC(NH2)2 as precursors in 1-octadecene, oleylamine and oleic acid as non-coordinating, coordinating and capping agent solvents, respectively. Oleic acid, oleylamine and thiourea were used respectively as a hard Lewis base, borderline Lewis base (in comparison with oleic acid) and soft Lewis base to form appropriate complexes. The complex formation, structure, and optical properties of CuIn1−xMxS2 (M = Fe and Zn) nanoparticles were studied by Fourier transform …

Immobilization and controlled release of prostaglandin E2 from poly-L-lactide-co-glycolide microspheres.

2009

Prostaglandin E(2) (PGE(2)) is an arachidonic acid metabolite involved in physiological homeostasis and numerous pathophysiological conditions. Furthermore, it has been demonstrated that prostaglandins have a stimulating effect not only on angiogenesis in situ and in vitro but also on chondrocyte proliferation in vitro. Thus, PGE(2) represents an interesting signaling molecule for various tissue engineering strategies. However, under physiological conditions, PGE(2) has a half-life time of only 10 min, which limits its use in biomedical applications. In the present study, we investigated if the incorporation of PGE(2) into biodegradable poly-L-lactide-co-glycolide microspheres results in a …