Search results for "alkane"
showing 10 items of 162 documents
Lipid hydrophobicity, physical state and distribution effects on the properties of emulsion-based edible films
2000
Abstract Addition of lipids to polysaccharide-based films is necessary to improve water vapor barrier properties but it leads to a decrease of mechanical properties. Model emulsified edible films mainly composed of methylcellulose (film-forming substance) and lipid mixtures (moisture barrier) were prepared. The effect of the physicochemical characteristics of the lipid phase (hydrophobicity and physical state) and of its distribution within the methylcellulose-matrix on the mechanical and water vapor barrier film properties was investigated. The nature of the lipid phase had little influence on mechanical properties of emulsified films, but had a substantial effect on the water vapor barrie…
Lipid hydrophobicity and physical state effects on the properties of bilayer edible films
2000
Abstract Edible bilayer films based on methylcellulose, used as the film-forming substance, and lipid mixtures, as barriers against moisture transfers, were prepared. The thickness of the lipid layer had little influence on film mechanical properties, regardless of the nature and the solid content of the fat layer. Mechanical resistance was mainly attributed to the methylcellulose matrix. The water vapor transfer rate (WVTR) decreased substantially when film thickness increased up to 100 μm. Upwards, transfer seemed to be independent of thickness. The WVTR was 1.5 up to 2.5 higher for triglyceride lipid layers than alkane lipid layers. Also, WVTR increased by a factor of 25–75 when the liqu…
Comparison of the activity, selectivity and decay properties of lay and hyultrastable zeolites during the cracking of alkanes
1984
Abstract The cracking of n-heptane on LaY ultrastable zeolite has been studied in a continuous glass flow reactor, at atmospheric pressure, up to 470°C. The initial selectivity to cracking, isomerization and disproportionation, kinetic rate constants, activation energies and decay parameters have been calculated and compared with those obtained using a HY ultrastable zeolite as a catalyst. It has been found that the HY ultrastable zeolite is about 7 times more active for cracking, and about 10 times more active for isomerization and disproportionation than the LaY ultrastable zeolite. The protolytic to β-cracking ratio is higher for the HY ultrastable zeolite. The deactivation takes place b…
Catalytic cracking of alkanes on MCM-22 zeolite. Comparison with ZSM-5 and beta zeolite and its possibility as an FCC cracking additive
1995
Abstract N-heptane cracking has been carried out on MCM-22, and its kinetic and decay behaviour is compared with that of ZSM-5 and Beta zeolites. In the case of MCM-22 cracking occurs in the 10-member ring channel system, as well as in the large cavities formed by 12-member rings. Product selectivities show that MCM-22, while presenting features which indicate structural similarities with ZSM-5, it also presents characteristics corresponding to pores or cavities larger than ZSM-5. The selectivities to the individual products together with C1 + C2/iC4, C3/C4, C5/C2, iC4/total C4, and alkane/alkene ratios indicate that MCM-22 has good properties to be used as an FCC octane booster additive sp…
Electronic excitations of 1,4-disilyl-substituted 1,4-disilabicycloalkanes: a MS-CASPT2 study of the influence of cage size.
2007
We present a multistate complete active space second-order perturbation theory computational study aimed to predict the low-lying electronic excitations of four compounds that can be viewed as two disilane units connected through alkane bridges in a bicyclic cage. The analysis has focused on 1,4-disilyl-1,4-disilabicyclo[2.2.1]heptane (1a), 1,4-bis(trimethylsilyl)-1,4-disilabicyclo[2.2.1]heptane (1b), 1,4-disilyl-1,4-disilabicyclo[2.1.1]hexane (2a), and 1,4-bis(trimethylsilyl)-1,4-disilabicyclo[2.1.1]hexane (2b). The aim has been to find out the nature of the lowest excitations with significant oscillator strengths and to investigate how the cage size affects the excitation energies and the…
Formation of products responsible for motor and research octane of gasolines produced by cracking The implication of framework Si/Al ratio and operat…
1989
Abstract An alkane in the range of gasoline fraction ( n -heptane) has been used as a reactant to study the influence of zeolite Y catalyst and process variables (i.e., framework Si Al ratio and procedure of dealumination, time on stream, and contact time) on the formation of products responsible for motor and research octane of gasoline during cracking, namely branched, aromatics, and olefins. It is found that the branched isomers in the C 5 and C 6 fractions appear as primary products and are partly produced by disproportionation, since the ratio of iso to normal compounds is above equilibrium. The ratio of branched to linear products strongly decreases when the number of carbon atoms of …
Group contributions to the infinite dilution partial molar volumes of alkanes, alcohols, and glycols in polar organic solvents
1997
Densities of binary mixtures of polar organic solvents with alcohols were measured at 25‡C. The solvents studied were N,N-dimethylformamide, dimethylsulfoxide, and formamide while alcohols were butanol, pentanol, hexanol, and 1,4-butanediol. Density measurements of hydrocarbons (from pentane to dodecane and some heptane isomers) + N,N-dimethylformamide were also performed. From these data the apparent molar volumes of alcohols and hydrocarbons as functions of concentration were calculated. The standard partial molar volumes were obtained by extrapolation to infinite dilution and are discussed in terms of group contributions.
On the influence of the acid-base character of catalysts on the oxidative dehydrogenation of alkanes
1996
Vanadium oxides supported on metal oxide, i.e. Al2O3, MgO and Mg-Al mixed oxide, and V-containing microporous materials (VAPO-5 and MgVAPO-5) have been tested in the oxidative dehydrogenation of C2-C4 alkanes. In all cases, tetrahedral vanadium species (isolated and/or associated) were mainly observed from51V-NMR and diffuse reflectance spectroscopies. The reducibility of V5+-species, determined from the onset-reduction temperature, decreases as follows: VOx/AL > VAPO-5 > MgVAPO-5 =VOx/MG > VOx/MG + AL. The acid character of catalysts, determined from the FTIR spectra of pyridine adsorbed, decreases as: MgVAPO-5 > VOx/AL > VAPO-5 > VOx/MG + AL > VOx/MG. A similar trend between V-reducibilit…
Monolayers of asymmetrical diethylalkanoat disulfides on gold(111):.the influence of chain length difference on atomic force microscope images
1998
Several symmetrical and asymmetrical long-chain diethylalkanoat disulfides were synthesized and character- ized. The differences in the chain lengths of the disul- fides ranged between zero and five methylene units. Self- assembled monolayers of these disulfides formed on Au(111) surfaces were studied by atomic force microscopy (AFM) in order to obtain information about the origin of the image contrast. Domains with hexagonal lattices (lattice constants 5:2- 5:3 A) were detected for all derivatives, independent of the chain length differences. This indicates that the contrast arises roughly at a depth of 4- 8 A in the monolayers at imag- ing forces between 0: 2a nd 3n N. For SAMs of diethyl…
Reaction products and pathways in the selective oxidation of C-2-C-4 alkanes on MoVTeNb mixed oxide catalysts
2010
[EN] The catalytic properties of MoVTeNbO catalysts during the selective oxidation of short chain alkanes and olefins (C-2-C-4) have been comparatively studied The main reaction products have been ethylene from ethane acrylic acid from propane maim anhydride from n-butane and methacrolein from isobutane FTIR studies of the adsorption of the main reaction products i e olefins and aldehydes over MoVTeNbO catalyst has been carried out Accordingly the reaction pathway is explained on the basis of the characteristics of the alkane fed the stability and reactivity of both the intermediates and the reaction products and the nature of the catalytic sites involved in each reaction (C) 2010 Elsevier …