Search results for "aqueous solution"
showing 10 items of 1610 documents
Metals in aqueous solutions and real effluents: biosorption behavior of a hemp-based felt
2018
In this study, a hemp-based material in the form of a felt is used to adsorb metals in individual aqueous solutions and in polycontaminated effluents using the batch method. The factors affecting the biosorption process were initial metal concentration, biosorbent dosage, contact time and pH. In controlled conditions, results showed that: (i) the felt exhibited high adsorption capacities towards metals in the following order: Pb g (ii) no significant differences were observed for the three salts used (sulfate, chloride and nitrate); (iii) the process was rapid: 10 min were sufficient to attain equilibrium ; iv) the biosorption efficiency increased considerably with the increase of the bioso…
Tetraalkylammonium Cations Conduction through a Single Nanofluidic Diode: Experimental and Theoretical Studies
2017
[EN] We describe experimentally and theoretically the concentration-dependent conduction of tetraalkylammonium (TAA+) cations through a nanofluidic diode fabricated in a polymer membrane via asymmetric track-etching techniques. This single-pore membrane exhibits current rectification characteristics because of the ionized carboxylate groups on the pore surface. We use aqueous solutions of potassium (K+ ), ammonium (A+ ), tetramethylammonium (TMA+ ), tetraethylammonium (TEA+ ), and tetrabutylammonium (TBA+ ) ions with concentrations ranging from 50 to 500 mM under acidic (pH 3.5) and physiological (pH 6.5) conditions. Compared with the K+ and A+ ions, the TMA+ , TEA+ , and TBA+ ions show rel…
Characterization of traditional artificial patinas on copper using the voltammetry of immobilized particles
2020
[EN] The voltammetry of immobilized particles methodology (VIMP) is used to characterize the composition of artificial patinas on copper. The voltammetric response of carbonate-, nitrate-, chloride-, sulfate-, and sulfide-based patinas is described using sub-microsamples attached to graphite electrodes in contact with aqueous acetate buffer. Patina-characteristic voltammetric profiles are obtained for the different artificial patinas that can be recognized using the generalized Tafel analysis of the voltammetric curves. VIMP data could also provide layer-by-layer information about composition and compactness/crystallinity of the patinas for which a simplified theoretical modeling is present…
Electrochemical treatment of aqueous solutions containing one or many organic pollutants at boron doped diamond anodes. Theoretical modeling and expe…
2012
The electrochemical oxidation of organics in water at boron doped diamonds (BDD) was experimentally investigated with the aim to discuss the correlations among the conversion of the pollutants and the instantaneous current efficiency ICE with the operative conditions. A simple theoretical model previously developed for the oxidation of oxalic acid accounting for the cases of mass transfer control, oxidation reaction control and mixed kinetic regimes was adopted and extended to challenge its predictive capability in the case of organics of different nature and in systems with more pollutants. A quite good agreement, between theoretical predictions and experimental data pertaining to the elec…
EPR investigations of polymeric and H2O2 -modified C3N4 -based photocatalysts
2019
The C3N4 -based nanopowders prepared by thermal condensation of melamine (MCN) with subsequent thermal etching (MCN-TE) and H2O2 -treatment were investigated by Q- and X-band EPR spectroscopy in dark and upon in situ UVA or visible-light exposure. Lorentzian signal at g = 2.003, more pronounced in the case of the thermally etched material, dominates EPR spectra of MCN and MCN-TE. More complex spectra were found for H2O2 -treated photocatalysts revealing the presence of signals attributed to the radicals produced via H2O2 interaction with C/N sites in the C3N4 polymeric network. The X-band spectra monitored upon in situ irradiation of the C3N4 -based photocatalysts evidenced the intensity gr…
Enhanced one-component spray polyurethane foams via sol-gel microspheres doped with aqueous glycerol
2013
The sol-gel microencapsulation of aqueous glycerol in silica-based microspheres affords functional materials that can be used to cure one-component polyurethane foams (OCF) formulations affording better and greener foam formation. These findings are important and may open the route to more sustainable materials, such as foams, coatings, adhesives, and sealants that are widely utilized in many industrial sectors. © 2013 American Chemical Society.
Functionalization of a polyaspartamide with glycidyl methacrylate: A useful method to prepare hydrogels through gamma irradiation
1999
α-β-Poly(N-2-hydroxyethyl)-DL-aspartamide (PHEA) was derivatized with glycidyl methacrylate (GMA). Aqueous solutions of the obtained copolymer PHEA-GMA (PHG) were irradiated by gamma rays with a dose rate of 0.5 KGy/h and at zero °C in the presence or in the absence of N,N'-methylenebisacrylamide (BIS). New hydrogel systems were obtained and characterized by FT-IR analyses and swelling measurements in aqueous medium at different pH values.
Hydrogels containing 5-Fluorouracil obtained by γ-irradiation. Synthesis, characterization and in vitro release studies
2001
The functionalization of α,β-poly(N-2-hydroxyethyl)-dl-aspartamide (PHEA) with glycidyl methacrylate (GMA) gives rise to a water-soluble copolymer PHEA-GMA (PHG) containing double bonds and ester groups in the side chain. Aqueous solutions of PHG alone or in combination with N,N′ methylenbisacrylamide (BIS) have been exposed to a γ-ray source at different irradiation doses in order to obtain polymeric networks. All samples have been prepared both as water-swellable microparticles and as gel systems. Microparticles have been characterized by FT-IR spectrophotometry and swelling measurements in aqueous media mimicking biological fluids. The effect of irradiation dose and BIS presence on rheol…
New biodegradable hydrogels based on a photo-cross-linkable polyaspartamide and poly(ethylene glycol) derivatives. Release studies of an anticancer d…
2001
The functionalization of α,β-poly(N-2-hydroxyethyl)-dl-aspartamide (PHEA) with glycidyl methacrylate (GMA) gives rise to a water-soluble photosensitive copolymer PHEA-GMA (PHG). Aqueous solutions of PHG alone or in combination with various concentrations of poly(ethylene glycol) dimethacrylate or poly(ethylene glycol) diacrylate (PEGDA) have been exposed to a source of UV rays at 313 nm in order to obtain polymeric networks. All samples have been prepared both as water-swellable microparticles and as gel systems. Microparticles have been characterised by Fourier transform IR spectrophotometry, dimensional analysis and swelling measurements in aqueous media mimicking biological fluids. In vi…
New biodegradable hydrogels based on a photocrosslinkable modified polyaspartamide: synthesis and characterization
1999
Abstract α,β-Poly( N -2-hydroxyethyl)- dl -aspartamide (PHEA), a synthetic water-soluble biocompatible polymer, was derivatized with glycidyl methacrylate (GMA), in order to introduce in its structure chemical residues having double bonds and ester groups. The obtained copolymer (PHG) contained 29 mol% of GMA residues. PHG aqueous solutions at various concentrations ranging from 30 to 70 mg/ml were exposed to a source of UV rays at λ 254 nm in the presence or in the absence of N , N ′-methylenebisacrylamide (BIS); the formation of compact gel phases was observed beginning from 50 mg/ml. The obtained networks were characterized by FT-IR spectrophotometry and swelling measurements which evide…