Search results for "bioengineering"

Wastewater treatment and reclamation : A review of pulp and paper industry practices and opportunities

2016

The pulp and paper (P&P) industry worldwide has achieved substantial progress in treating both process water and wastewater, thus limiting the discharge of pollutants to receiving waters. This review covers a variety of wastewater treatment methods, which provide P&P companies with cost-effective ways to limit the release of biological or chemical oxygen demand, toxicity, solids, color, and other indicators of pollutant load. Conventional wastewater treatment systems, often comprising primary clarification followed by activated sludge processes, have been widely implemented in the P&P industry. Higher levels of pollutant removal can be achieved by supplementary treatments, which…

Influence of Welding Time on Tensile-Shear Strength of Linear Friction Welded Birch (Betula pendula L.) Wood

2015

Linear friction welding of wood is a bonding process applied to wood and during which a stiff bond line is formed by the softening and rehardening of wood components to form a composite material composed mainly of wood fibres embedded in a modified lignin matrix. Unfortunately, the bonds tend to spontaneously delaminate or lose their strength when exposed to moist conditions. Some approaches were previously applied to overcome this problem, but so far a suitable solution has not been found. This paper presents results of applying post-welding thermal modification to reduce the moisture sensitivity of welded wood. The experiments included welding of birch wood, thermal modification under sup…

2018

Reactivity is an important parameter when considering the chemical modification or dissolution of cellulose. Different pretreatment methods affect cellulose reactivity by decreasing its degree of polymerization (DP) and crystallinity. In this study, the molar mass of cellulose was decreased via enzymatic pretreatment. Three commercial endoglucanase-rich products were tested. The target was to reduce the viscosity of the pulp to below 200 mL/g and, thus, increase the reactivity of the cellulose. For comparison, cellulose was also pretreated with ozone, and the effects of each pretreatment method on crystallinity and monosaccharide composition of the resulting pulps were investigated. Both en…

Hydrolysis rates, methane production and nitrogen solubilisation of grey waste components during anaerobic degradation.

2005

Abstract Municipal grey waste (i.e. the remaining fraction in municipal waste management systems in which putrescibles (biowaste) and other recyclables (paper, metals, glass) are source-segregated) was manually sorted into six main fractions on the basis of composition and also separated by sieving (100 mm mesh size) into two fractions, oversized and undersized, respectively. In practice, in waste management plant the oversized fraction is (or will be) used to produce refuse-derived fuel and the undersized landfilled after biological stabilisation. The methane yields and nitrogen solubilisation of the grey waste and the different fractions (all studied samples were first milled to 5 mm part…

Leachate and gaseous emissions from initial phases of landfilling mechanically and mechanically-biologically treated municipal solid waste residuals.

2008

In this study, the behaviour, and leachate and gaseous emissions during the initial phases of landfilling mechanically (M) and mechanically-biologically (MB) treated municipal solid waste residuals in northern climatic conditions was compared using two landfill lysimeters (112 m3). The results demonstrate that the strong acid phase of M residuals degradation lasts at least 2 years, while in the MB residuals the acid phase lasts only a few months. The SCOD and NH4-N concentrations varied 20-100g/l and 600-1800 mg/l in M leachate and 1-4 g/l and 100-400mg/l in MB leachate, respectively. The leaching of SCOD was approximately 40-fold (24.2 and 0.6 kg/t TS) and leaching of NH4-N approximately 5…

Greenhouse gases from membrane bioreactors: Mathematical modelling, sensitivity and uncertainty analysis

2017

In this study a new mathematical model to quantify greenhouse gas emissions (namely, carbon dioxide and nitrous oxide) from membrane bioreactors (MBRs) is presented. The model has been adopted to predict the key processes of a pilot plant with pre-denitrification MBR scheme, filled with domestic and saline wastewater. The model was calibrated by adopting an advanced protocol based on an extensive dataset. In terms of nitrous oxide, the results show that an important role is played by the half saturation coefficients related to nitrogen removal processes and the model factors affecting the oxygen transfer rate in the aerobic and MBR tanks. Uncertainty analysis showed that for the gaseous mod…

Pilot scale experiment with MBR operated in intermittent aeration condition: analysis of biological performance.

2014

The effect of intermittent aeration (IA) on a MBR system was investigated. The study was aimed at ana- lyzing different working conditions and the influence of different IA cycles on the biological performance of the MBR pilot plant, in terms of organic carbon and ammonium removal as well as extracellular poly- meric substances (EPSs) production. The membrane modules were placed in a separate compartment, continuously aerated. This configuration allowed to disconnect from the filtration stage the biological phenomena occurring into the IA bioreactor. The observed results highlighted good efficiencies, in terms of organic carbon and ammonium removal. It was noticed a significant soluble micr…

Composting of bio-waste, aerobic and anaerobic sludges – Effect of feedstock on the process and quality of compost

2011

In-vessel composting of three stocks with originally different degree of organic matter degradation was conducted for: (1) kitchen source-separated bio-waste (BW), (2) aerobic (AS) as well as (3) anaerobic sludges (AnS) from municipal wastewater treatment plant. Composting experiment lasted over a year. The highest activity of the process was in the BW compost. It was implied by the highest temperature, CO(2) release, ammonification and nitrification, intensive accumulation and removal of low-weight carboxylic acids (water- and NaOH-extractable). Between the sludges higher mineralization and CO2 release was in AnS, while ammonification and nitrification were higher in AS compost; no signifi…

Effects of solid–liquid separation on recovering residual methane and nitrogen from digested dairy cow manure

2006

The feasibility of optimizing methane and nitrogen recovery of samples obtained from farm biogas digester (35 degrees C) and post-storage tank (where digested material is stored for 9-12 months) was studied by separating the materials into different fractions using 2, 1, 0.5 and 0.25 mm sieves. Mass-balances revealed that digested material mainly consists of0.25 mm (60-69%) and2 mm (18-27%) fractions, while fractions between 2 and 0.2 mm made the rest. Incubation of solid fractions0.25 mm of digester material at 35 degrees C resulted in specific methane yields of 0.060-0.085 m(3)kg(-1) volatile solids (VS) during initial 30-50 d and 0.16-0.18 m(3)kg(-1)VS at the end of 340 d incubation. Sim…

Simultaneous nitrogen and organic carbon removal in aerobic granular sludge reactors operated with high dissolved oxygen concentration

2013

Simultaneous nitrification and denitrification (SND) together with organic removal in granules is usually carried out without Dissolved Oxygen (DO) concentration control, at ‘‘low DO’’ (with a DO 7–8 mg/L, during feast and famine conditions respectively). In particular, different strategies of cultivation and several organic and nitrogen loading rate have been applied, in order to eval- uate the efficiencies in SND process without dissolved oxygen control. The results show that, even under conditions of high DO concentration, nitrogen and organic matter can be simultaneously removed, with efficiency >90%. Nevertheless, the biological conditions in the inner layer of the granule may change sig- …