Search results for "detector"
showing 10 items of 3491 documents
Search for lepton flavour number violating Z°-decays
1997
A search for lepton flavour number violating $Z^0$ decays in the channels \begin{center} $Z^0\rightarrow \mu\tau$,\\ $Z^0\rightarrow e\tau$, \\ $Z^0\rightarrow e\mu$, \\ \end{center} using the DELPHI detector with data collected during the 1991--94 LEP runs, is described. No signal was found. Upper limits at 95\% confidence level for the respective branching fractions of $1.2\times 10^{-5}$, $2.2\times 10^{-5}$, and $0.25\times 10^{-5}$, were obtained.
Measurement of gamma(b(b)over-bar)/gamma(had) using impact parameter measurements and lepton identification
1995
The partial decay width of theZ to bb¯quark pairs has been measured by the DELPHI detector at LEP.b-hadrons, containingb-quarks, were tagged by leptons with high transverse momentum relative to the hadron or by tracks with large impact parameters to the primary vertex.The ratio of the numbers of events with a single such tag to those with two tags was used to estimate the efficiency of the method and to reduce the systematic uncertainty. Combining all methods, the value: Γbb¯Γhad=0.2210±0.0033±0.0003(model)±0.0014(Γcc¯) was found, where the third error corresponds to a±8% uncertainty on the cc production width. A maximum likelihood in to the single and di-lepton distributions gave the branc…
IAXO - The International Axion Observatory
2013
The International Axion Observatory (IAXO) is a next generation axion helioscope aiming at a sensitivity to the axion-photon coupling of a few 10^{-12} GeV^{-1}, i.e. 1-1.5 orders of magnitude beyond sensitivities achieved by the currently most sensitive axion helioscope, the CERN Axion Solar Telescope (CAST). Crucial factors in improving the sensitivity for IAXO are the increase of the magnetic field volume together with the extensive use of x-ray focusing optics and low background detectors, innovations already successfully tested at CAST. Electron-coupled axions invoked to explain the white dwarf cooling, relic axions, and a large variety of more generic axion-like particles (ALPs) along…
Streuung von mittelschnellen Elektronen an Kunststoff-Folien mit eingelagerten Schwermetallatomen
1962
Scattering has been observed of 70-keV electrons by Kollodium-foils containing elements of high atomic number (lead). The contents of lead are determined and the kind of distribution of lead in the foil is described. The differential cross-section as a function of the angle of scattering approximates the cross-section calculated by Sherman with lower contents of lead of the foils. Remaining deviations can be explained by screening-effects of the electron cloud.
Measurement of Event Shape and Inclusive Distributions at $\sqrt{s} =$ 130 and 136 GeV
1997
Inclusive charged particle and event shape distributions are measured using 321 hadronic events collected with the DELPHI experiment at LEP at effective centre of mass energies of 130 to 136 GeV. These distributions are presented and compared to data at lower energies, in particular to the precise Z data. Fragmentation models describe the observed changes of the distributions well. The energy dependence of the means of the event shape variables can also be described using second order QCD plus power terms. A method independent of fragmentation model corrections is used to determine $\alpha_s$ from the energy dependence of the mean thrust and heavy jet mass. It is measured to be: % %\alpha_s…
Initial results on energy resolution of the NEXT-White detector
2018
One of the major goals of the NEXT-White (NEW) detector is to demonstrate the energy resolution that an electroluminescent high pressure xenon TPC can achieve for high energy tracks. For this purpose, energy calibrations with 137Cs and 232Th sources have been carried out as a part of the long run taken with the detector during most of 2017. This paper describes the initial results obtained with those calibrations, showing excellent linearity and an energy resolution that extrapolates to approximately 1% FWHM at Q$_{\beta\beta}$.
The ATLAS Data Acquisition and High Level Trigger system
2016
Journal of Instrumentation 11(06), P06008 (2016). doi:10.1088/1748-0221/11/06/P06008
Development and Study of a Micromegas Pad-Detector for High Rate Applications
2015
In this paper, the design and the performance of two prototype detectors based on Micromegas technology with a pad readout geometry is discussed. In addition, two alternative implementations of a spark-resistent protection layer on top of the readout pads have been tested to optimize the charge-up behavior of the detector under high rates. The prototype detectors consist of 500 pads with a size of 5x4 mm, each connected to one independent readout channel, and cover an active area of 10x10 cm. The design of these prototypes and its associated readout infrastructure was developed in such a way that it can be easily adapted for large-size detector concepts.
Anode current saturation of ALD-coated Planacon MCP-PMTs
2018
We have measured and compared the characteristics of ALD-coated Planacon MCP-PMTs (XP85112/A1-Q-L) with their non-ALD counterparts (XP85012/A1-Q). While the later show excellent performance, the ALD-coated sensors have surprisingly low current saturation levels (~two orders of magnitude lower than expected) and extremely high gain recovery time (more than 7 orders of magnitude higher than expected). We suspect that these problems might be caused by the unexpected side-effects of the ALD process. To make a definite conclusion, more samples need to be tested, preferably from different production runs. If our observation were confirmed, it would mean a serious technological setback for ALD-coa…
Improving point matching on multimodal images using distance and orientation automatic filtering
2016
International audience; Speed Up Robust Features SURF is one of the most popular and efficient methods used for image registration task. In order to achieve a correct registration, a good matching of feature point is required. However in the case of multimodal images, the high and non-linear intensity changes between different modalities led to many outliers (mismatching of detected points) and consequently a fail in the registration. Therefore, in this paper we introduce an efficient method devoted to the detection and removal of such outlier. It's based on an automatic filtering of outliers on both distance and orientation between features points. We tested our proposed method on a set of…