Search results for "eccentric"

Experimental and analytical response of masonry elements under eccentric vertical loads

2005

The flexural behaviour of masonry rectangular cross-sections is studied in order to characterize the mechanical behaviour of structural elements under axial eccentric loads by means of a proper law. First the experimental response of walls under vertical centred loads is observed and a stress-strain law depending on two parameters is given in order to fit the experimental results. Subsequently the behaviour of walls nominally equal to the walls mentioned before is investigated under eccentric vertical loads, and the response is observed in terms of moment-curvature relation. To this point a comparison is made between the moment-curvature response obtained experimentally and the moment-curva…

Behavior of fiber-reinforced concrete columns under axially and eccentrically compressive loads

2010

An experimental investigation into the behavior of 16 short, confined, reinforced concrete columns with and without steel fibers was carried out. The columns with square sections had a concrete core 165 x 165 mm (6.49 x 6.49 in.) at the midsection and were hunched at the ends to apply eccentric loading and prevent boundary effects. The specimens were tested to failure at different strain rates under two loading schemes: concentric compression and eccentric compression with a constant eccentricity. The axial load and axial strains were obtained to evaluate the effects of the presence of steel fibers, the thickness of the cover concrete, and the eccentricity of the applied axial load. The com…

Compressive behaviour of eccentrically loaded slender masonry columns confined by FRP

2018

Abstract Fibre Reinforced Polymer (FRP) confinement represents an effective tool for retrofitting masonry piers or columns enhancing their structural performance. This technique has been widely studied in the literature mainly with reference to short columns, while no extensive information is available on the influence of second order effects on its efficacy in case of slender members. Within this framework, the presented study concerns a simplified method able to assess the effects of FRP confinement on the compressive behaviour of slender masonry columns. A proper constitutive law of FRP confined masonry in compression is adopted for performing a sectional analysis, in which also consider…

Size Effect in Compression of High Strength Fibre Reinforced Concrete Cylinders Subjected to Concentric and Eccentric Loads

2005

Perception of Biological Motion in Central and Peripheral Visual Fields

2017

Abstract Studies analysing biological motion perception based on reduced number of dots have demonstrated that biological motion can be perceived even when only the lower part of the body is visible or when the number of dots representing the object is reduced. What is the minimal amount of information that enables biological motion to be distinguished from its scrambled version? The results of the current experiment demonstrate that biological motion can be distinguished from its scrambled version when the object is formed of approximately 5 (4.7 ± 0.1) dots. Additionally, we also investigated whether the threshold value for biological motion perception differs in central and peripheral vi…

Does ankle joint power reflect type of muscle action of soleus and gastrocnemius during walking in cats and humans?

2013

The main objective of this paper is to highlight the difficulties of identifying shortening and lengthening contractions based on analysis of power produced by resultant joint moments. For that purpose, we present net ankle joint powers and muscle fascicle/muscle-tendon unit (MTU) velocities for medial gastrocnemius (MG) and soleus (SO) muscles during walking in species of different size (humans and cats). For the cat, patterns of ankle joint power and MTU velocity of MG and SO during stance were similar: negative power (ankle moment×angular velocity<0), indicating absorption of mechanical energy, was associated with MTU lengthening, and positive power (generation of mechanical energy) w…

Dépendance de la fatigue à la longueur musculaire : approche mécanique et neurophysiologique

2006

The objective of this work is to evaluate the fatigue dependency on the knee extensor muscles length. Exercises varying the type of contraction (isometric and eccentric) and intensity of contraction (maximal and sub-maximal) are performed in order to disrupt the neuromuscular system by different factors of fatigue: central and peripheral. These exercises are performed at two muscular lengths (S and L, corresponding respectively to 40 and 100° of knee flexion). Neuromuscular parameters (maximal torque, muscular twitch, voluntary activation level, electromyographic activity, etc.) are analyzed in pre- and post-fatigue conditions in the type of contraction required by the fatiguing exercise. I…

Sul controllo del meccanismo di collasso di controventi eccentrici

2007

The effectiveness of different non-linear static procedures, for the detection of the collapse mechanism of eccentric braced frames, is investigated. EBFs introduced into truss frame structures are considered. For such a typology of structures, plastic deformations are concen-trated in a single resistant element at each floor, greatly increasing the risk of the formation of soft storey mechanisms, even if the structure is designed according to the capacity design. The results of different non-linear static procedures are compared to those obtained by incremental dynamic non-linear analysis, considering a meaningful set of artificially generated stationary accelerograms, compatible with a ta…

Hot spots and gluon field fluctuations as causes of eccentricity in small systems

2021

We calculate eccentricities in high energy proton-nucleus collisions, by calculating correlation functions of the energy density field of the Glasma immediately after the collision event at proper time tau = 0. We separately consider the effects of color charge and geometrical hot spot fluctuations, analytically performing the averages over both in a dilute-dense limit. We show that geometric fluctuations of hot spots inside the proton are the dominant source of eccentricity whereas color charge fluctuations only give a negligible correction. The size and number of hot spots are the most important parameters characterizing the eccentricities.

Estimation of errors in mechanical efficiency

1990

Errors in measurements of mechanical work, net energy expenditure and mechanical efficiency (ME) were calculated, when subjects performed isolated eccentric or concentric muscle actions and combinations of these actions [stretch-shortening cycle (SSC) exercises] with a special sledge apparatus. The relative error of mechanical work was 6.1%. When estimating the error of energy metabolism from oxygen consumption the error would be about 4% (McArdle et al. 1981). The maximum error of ME was the sum of these two values (10.1%). Obviously the error of ME was less than 5%, because 30 muscle actions were averaged and, in addition, the errors of mechanical work and energy expenditure were not in t…