Search results for "engineering.material"
showing 10 items of 2352 documents
Effect of superplasticizers on the rheological properties of fly ash suspensions containing activators of the pozzolanic reaction
2000
Rheological studies have been carried out on the effect of a superplasticizer from the sulphonated melamine formaldehyde (SMF) group upon the properties of fly ash suspensions containing a small quantity of mineral admixtures such as cement, lime and gypsum. The superplasticizers' efficiency has appeared to depend greatly on the admixture used. The highest liquefaction degree was found in fly ash suspensions containing both cement and gypsum together and the next it was, when only cement was added. These suspensions exhibit features of a newtonian fluid of low plastic viscosity, when the water to solid ratio (w/s) is 0.3 and a superplasticizer has been used. However, fly ash suspensions wit…
Characterization of hydraulic mortars by means of simultaneous thermal analysis
2008
The properties of hydraulic mortars were studied by means of simultaneous thermal analysis (STA), according to a procedure proposed in the literature. Hydraulic limes, cement and/or slaked lime were mixed using different proportions of both inert and reactive aggregates, in order to test the effectiveness of such procedure in distinguishing the different degree of hydraulicity of such samples. The use of the normalized coordinates suggested in the literature results in overlapping of the clusters of different kinds of mortars. Modified coordinates are proposed, which give promising results in view of outlining a 'master curve' of hydraulicity.
Physico-chemical parameters determining hydration and particle interactions during the setting of silicate cements
1997
Abstract Hydration of tricalcium silicate (Ca 3 SiO 5 ), the pure phase used as a model of the portland cements, is the chemical process leading to the formation of hydrates, while setting is a definite time event corresponding to the change of the paste from the soft to the hard state. Setting results from interactions between anhydrous or very partially hydrated particles. The analysis of these interactions leads to the identification of two fundamental steps: the coagulation of cement grains during the first minutes following the mixing and the rigidification of the coagulated structure which arises simultaneously with the acceleration of the calcium silicate hydrates (CSH) formation. …
Experimental investigation of calcium silicate hydrate (C-S-H) nucleation
1999
Due to the importance of calcium silicate hydrate (C-S-H) in cement chemistry, its nucleation mode and parameters influencing it were investigated. It has been observed that the C-S-H nucleation follows the general laws governing the nucleation. The degree of supersaturation has been found to be the main parameter controlling homogeneous nucleation rates. The lime concentration in solution, well known to be the most important parameter determining the kinetic, morphological and structural features of C-S-H, also controls the nucleation characteristics of heterogeneous nucleation, i.e. during hydration of cement. The correlation between heterogeneous nucleation of C-S-H and possible final me…
Saturated Solutions of Anhydrous Phases in the System Lime-Silica-Water: Example of beta-C2S
1990
Saturated solutions rerely form when the anhydrous constituents of aluminous and portland cement are stirred in water or in lime solutions of increasing concentrations. Apart from monocalcium aluminate, concentration of ions in solution cannot exceed maximum supersaturation with respect to the hydrate most likely to precipitate. The present work shows such a behavior for β-C2S suspended in water and in lime solutions at low concentration. In more concentrated lime solutions, a short lifetime saturation state with respect to β-C2S seems to be reached.
Magnetic susceptibility and heavy metal content in dust from the lime plant and the cement plant in Opole Voivodeship
2012
Magnetic Susceptibility and Heavy Metal Content in Dust From the Lime Plant and the Cement Plant in Opole Voivodeship Until now, dust arising from lime manufacture has been considered harmless to the environment so it has been investigated marginally from the standpoint of environmental protection, especially when it came to magnetic properties and heavy metal content. The aim of the research was filling the gap in this area. The research comprised measurements of magnetic susceptibility, the content of heavy metals, reaction (pH) and specific conductivity of lime dust and also raw material and fuel used for lime production. The samples were taken from one of the lime plants located in Opol…
Distinctive features of diffusion-controlled radiation defect recombination in stoichiometric magnesium aluminate spinel single crystals and transpar…
2020
This work has been performed within the framework of the EUROfusion Enabling Research project: ENR-MFE19.ISSP-UL-02 “Advanced experimental and theoretical analysis of defect evolution and structural disordering in optical and dielectric materials for fusion application”. The views and opinions expressed herein do not necessarily reflect those of the European Commission. Research of A.L, E.F.,, V.S and E.S has been partly supported by the Estonian Research Council grant (PUT PRG619); has been also carried out within the framework of the EUROfusion Consortium and has received funding from the Euratom research and training programme 2014–2018 and 2019–2020 under grant agreement No 633053. The …
Electrosynthesis of Ce–Co Mixed Oxide Nanotubes with High Aspect Ratio and Tunable Composition
2008
Cerium oxide and cobalt oxides have attracted the interest of several researchers due to their potential application in several technological fields electrochromism, lithium batteries, catalysis, etc.. Ceria has been used as a promoter in the so-called “three-way catalyst” for the control of toxic emission from automobile exhaust. The promotion consists of the enhancement of the noble metal dispersion, as well as stabilization of the supporting medium toward thermal sintering. 1,2 A direct catalytic effect of CeO2 in chemical processes such as water–gas shift reaction or NOx decomposition has been also evidenced. 3,4
Experimente zur Zeolithbildung durch hydrothermale Umwandlung
1974
The formation of zeolites by hydrothermal alteration has been investigated by taking trass from the Laach volcanic area as a sample. Zeolites to be found are chabazite, phillipsite and analcime, all of which originated from the same phonolitic glass. This paper aims at explaining the formation of zeolites by means of experimental alteration of the pumice with various solutions. NaOH and KOH solutions were used in the experiments, these limited the formation conditions of chabazite, phillipsite, analcime in alkaline environments. Moreover, experiments were carried out with H2O dist and with solutions that formed during the alteration of pumice by reacting with H2O. These experiments were con…
The structure of charoite, (K,Sr,Ba,Mn)(15-16)(Ca,Na)(32)[(Si-70(O,OH)(180))](OH,F)(4.0)center dot nH(2)O, solved by conventional and automated elect…
2010
AbstractCharoite, ideally (K,Sr,Ba,Mn)15–16(Ca,Na)32[(Si70(O,OH)180)](OH,F)4.0·nH2O, a rare mineral from the Murun massif in Yakutiya, Russia, was studied using high-resolution transmission electron microscopy, selected-area electron diffraction, X-ray spectroscopy, precession electron diffraction and the newly developed technique of automated electron-diffraction tomography. The structure of charoite (a= 31.96(6) Å,b= 19.64(4) Å,c= 7.09(1) Å, β = 90.0(1)°,V= 4450(24) Å3, space groupP21/m) was solvedab initioby direct methods from 2878 unique observed reflections and refined toR1/wR2= 0.17/0.21. The structure can be visualized as being composed of three different dreier silicate chains: a d…