Search results for "flowability"
showing 4 items of 4 documents
Optimización de las propiedades de emulsión de betún para la estabilización de balasto
2017
Ballasted track, while providing economical and practical advantages, is associated with high costs and material consumption due to frequent maintenance. More sustainable alternatives to conventional ballasted trackbeds should therefore aim at extending its durability, particularly considering ongoing increases in traffic speed and loads. In this regard, the authors have investigated a solution consisting of bitumen stabilised ballast (BSB), designed to be used for new trackbeds as well as in reinforcing existing ones. This study presents the idea behind the technology and then focuses on a specific part of its development: the optimisation of bitumen emulsion properties and dosage in relat…
On the use of a powder rheometer to characterize the powder flowability at low consolidation with torque resistances
2017
The Anton Paar Powder Cell was used to measure the torque necessary to rotate an impeller in beds of glass beads, sand and alumina powders aerated between no aeration to the minimum for fluidization. Measured torque values depend on the material tested, on the air flow rate applied, on the impeller depth and on the height of the impeller blade. The effect of the impeller depth is linear for low impeller depth and is less than linear at high depth values. A model was developed for the interpretation of the experimental results based on the idea that the material is shearing on the surface described by the impeller rotation. The model allows to estimate an effectiveness of the impeller in the…
Comparison between a Uniaxial Compaction Tester and a Shear Tester for the Characterization of Powder Flowability
2014
The complete characterization of powder flow properties with shear cells is a long and time-consuming process that requires specially trained operators or costly automated instruments. For these reasons, in industrial practice, the use of simpler and less extensive measurement by uniaxial compaction testers is often preferred. However, previous studies in the literature indicate that the results of the two techniques are not directly comparable due to the different stress state conditions achieved in the two testers.In this study, an experimental campaign to measure the flow function of five different powders with a ring shear tester (RST) and a uniaxial compaction tester (UCT) was performe…
Characterization of the bulk flow properties of industrial powders from shear tests
2020
Bulk flow properties from shear analysis of compacted powders can be evaluated following different approaches. Experimental values of shear stresses obtained by conventional shear cells are traditionally used to build yield loci, from which the most relevant flow properties could be found. Such flow properties play an important role in determining their performance under fluidization conditions. In this work, a useful app, named cYield, was developed by using the new Matlab&rsquo