Search results for "force"

Nanoscale Mapping of the Physical Surface Properties of Human Buccal Cells and Changes Induced by Saliva

2019

International audience; The mucosal pellicle, also called salivary pellicle, is a thin biological layer made of salivary and epithelial constituents, lining oral mucosae. It contributes to their protection against microbiological, chemical, or mechanical insults. Pellicle formation depends on the cells’ surface properties, and in turn the pellicle deeply modifies such properties. It has been reported that the expression of the transmembrane mucin MUC1 in oral epithelial cells improves the formation of the mucosal pellicle. Here, we describe an approach combining classical and functionalized tip atomic force microscopy and scanning microwave microscopy to characterize how MUC1 induces change…

Cellular basis of abnormal tissue hardening in lung fibrosis examined with atomic force microscopy

2010

Correlation between surface forces and surface reactivity in the setting of plaster by atomic force microscopy

2000

Abstract The setting of mineral binders (cement, plaster, etc.) arises as a direct consequence of surface reactivity by a process of dissociation and rehydration. This transformation induces a complete change of surface forces, of which the nature remains still unknown. The general process of the setting has been studied by means of plaster (CaSO 4 ·0.5H 2 O) crystals, chosen for an experimental convenience. The surface alteration (growth, dissolution, atomic resolution) of the plaster crystal with respect to the introduction of the calcium sulfate solution has been followed by using atomic force microscopy (AFM. Alternatively, this apparatus has been adapted by gluing a plaster microcrysta…

Experimental results of RC columns strengthnened with Fiber Reinforced Cementitious Mortars

2012

The structural behaviour of reinforced concrete columns strengthened with a system made up of fibre nets embedded in an inorganic stabilized cementitious matrix was investigated. Specimens with circular and square cross-section were cast and subjected to monotonic uniaxial compression to investigate the efficiency of a Polypara-phenylene-benzo-bisthiazole (PBO) Fibre Reinforced Cementitious Mortars (FRCM) system in increasing both carrying capacity and ductility. The experimental results show that confinement with PBO fibre produced a noticeable increment in strength and ductility, though the low mechanical ratios of fibre considered were not always able to ensure hardening behaviour up to …

Physical modelling of Czochralski crystal growth in horizontal magnetic field

2017

Abstract This study addresses experimentally the heat transfer, the temperature azimuthal non-uniformity and the onset of oscillations in a low temperature physical model of a medium-sized Czochralski crystal growth process with a strong horizontal magnetic field (HMF). It is observed that under certain conditions the integral heat flux may decrease with increasing magnetic field strength at the same time as the flow velocity increases. The azimuthal non-uniformity of the temperature field in the melt near the crystal model rim is only little influenced by its rotation rate outside of a narrow range where the centrifugal force balances the buoyant one. The flow oscillation onset has been ob…

Variational approach to the mechanics of metal V-belt systems

2005

The mechanical behaviour of metal V-belt drives is strongly dependent on the elastic properties of both the belt and the pulley, which influence the belt penetration into the groove and the sliding on the pulley wall. The distribution of tension and penetration is quite different from the rubber belts, which may be dealt with in the assumption of perfectly rigid pulleys. The restoring effect of the centrifugal forces of the plate elements has also to be taken into account. The present analysis considers the combination of all those effects, choosing a three parameter deformation function to describe the plate bending and applying the principle of virtual work for the calculation of the unkn…

Theoretical study on travelling web dynamics and instability under non-homogeneous tension

2013

Problems of dynamics and stability of a moving web, travelling between two rollers at a constant velocity, are studied using analytical approaches. Transverse vibrations of the web are described by a partial differential equation that includes the centrifugal force, in-plane tension, elastic reaction and nonstationary inertial terms. The model of a thin elastic plate subjected to bending and non-homogeneous tension is used to describe the bending moment and the distribution of membrane forces. The stability of the plate is investigated with the help of studies of small out-of-plane vibrations. The influence of linearly distributed in-plane tension on the characteristics of the web vibration…

Static instability analysis for travelling membranes and plates interacting with axially moving ideal fluid

2010

The out-of-plane instability of a moving plate, travelling between two rollers with constant velocity, is studied, taking into account the mutual interaction between the buckled plate and the surrounding, axially flowing ideal fluid. Transverse displacement of the buckled plate (assumed cylindrical) is described by an integro-differential equation that includes the centrifugal force, the aerodynamic reaction of the external medium, the vertical projection of membrane tension, and the bending force. The aerodynamic reaction is found analytically as a functional of the displacement. To find the critical divergence velocity of the moving plate and its corresponding buckling mode, an eigenvalue…

Nanoscale Chemical Interaction Enhances the Physical Properties of Bioglass Composites

2013

Bioglasses are favorable biomaterials for bone tissue engineering; however, their applications are limited due to their brittleness. In addition, the early failure in the interface is a common problem of composites of bioglass and a polymer with high mechanical strength. This effect is due to the phase separation, nonhomogeneous mixture, nonuniform mechanical strength, and different degradation properties of two compounds. To address these issues, in this study a nanoscale interaction between poly(methyl methacrylate) (PMMA) and bioactive glass was formed via silane coupling agent (3-trimethoxysilyl)propyl methacrylate (MPMA). A monolith was produced at optimum composition from this hybrid …

Cerebellar learning of bio-mechanical functions of extra-ocular muscles: modeling by artificial neural networks

2003

A control circuit is proposed to model the command of saccadic eye movements. Its wiring is deduced from a mathematical constraint, i.e. the necessity, for motor orders processing, to compute an approximate inverse function of the bio-mechanical function of the moving plant, here the bio-mechanics of the eye. This wiring is comparable to the anatomy of the cerebellar pathways. A predicting element, necessary for inversion and thus for movement accuracy, is modeled by an artificial neural network whose structure, deduced from physical constraints expressing the mechanics of the eye, is similar to the cell connectivity of the cerebellar cortex. Its functioning is set by supervised reinforceme…