Search results for "fuel"
showing 10 items of 986 documents
Financial measures for supporting wind power systems in Europe: A comparison between green tags and feed’in tariffs
2008
Distributed Generation demonstrates to be able to significantly influence the electric power system, bringing considerable benefits to the quality of service and improving the energetic efficiency of the distribution network. In particular, in the last few years, Distributed Generation from renewable energy sources is considerably increased thanks to the many support policies promoted worldwide with the aim of facing the environmental issue and the problem of the permanent rise of prices of the fossil energy. In this contest, after a brief review on the financing strategies carried out in Europe in the last decade for promoting the recourse to renewable energy, the paper presents a comparis…
A ROOT-based analysis tool for measurements of neutron-induced fission products at the IGISOL facility
2012
For the sustainable development of nuclear energy, the handling of used nuclear fuel is a key issue. Innovative fuel cycles are being developed for the transmutation of minor actinides and long-lived fission products. In view of these developments, accurate knowledge of the fuel inventory is necessary. The IGISOL facility with JYFLTRAP, at the accelerator laboratory of the University of Jyvaskyla, will be used to measure independent fission yield distributions from neutron-induced fission on different actinides. In this paper, an analysis tool is developed, using the CERN-based ROOT Data Analysis Framework, with the objective of performing full data analysis within the same code. The analys…
Development and validation of a 5 stroke engine for range extenders application
2014
International audience; A 5-stroke turbo-charged port-injection spark-ignition engine has been developed in the present study for use as a range extender or series-hybrid main power source. The development and the design of the engine are based on 0D/1D model and experimental results have been compared with the engine model. The 5-stroke engine is a three-cylinder in which two cylinders perform a four-stroke cycle and alternatively a second expansion of the burnt gases is performed in the third cylinder. The boost pressure delivered by the turbocharger is controlled by a particular innovative system called “smart wastegate”, different from a conventional wastegate, consisting in a variable …
Determination of insolubles in diesel lubricating oil by FIA-visible spectrometry
2003
Insolubles determination is one of the parameters usually recommended to evaluate the residual life of oil because their presence at elevated levels in diesel lubricating oil changes the viscosity, prematurely clogs filters and is one of the major factors in causing abrasive engine wear. The proposed method employs visible spectrophotometric detection in association with flow injection analysis. The results obtained by this method were compared with the ones obtained by Fourier transform infrared spectrometry (FT-IR) since this is the most employed method for insolubles determination. The proposed method presented a linear response from 0 to 3% (w/w) of insolubles in pentane (ASTM D-893). T…
Electric Field Effect on the Thermal Decomposition and Co-combustion of Straw with Solid Fuel Pellets
2019
The aim of this study was to provide more effective use of straw for energy production by co-firing wheat straw pellets with solid fuels (wood, peat pellets) under additional electric control of the combustion characteristics at thermo-chemical conversion of fuel mixtures. Effects of the DC electric field on the main combustion characteristics were studied experimentally using a fixed-bed experimental setup with a heat output up to 4 kW. An axisymmetric electric field was applied to the flame base between the positively charged electrode and the grounded wall of the combustion chamber. The experimental study includes local measurements of the composition of the gasification gas, flame tempe…
Urea as a PCDD/F inhibitor in municipal waste incineration.
2001
Emissions of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) from municipal waste incineration have been widely studied because of their extensive toxicity, and many efforts have been made to restrict their emissions. Although a number of chemical compounds have been shown in laboratory-scale tests to inhibit the formation of PCDD/Fs, few have been tested in pilot- or full-scale plants. This work evaluates the effect of urea as a PCDD/F inhibitor in a pilot-scale incinerator that uses refuse-derived fuel (RDF). The decomposition of urea under the test conditions was also studied using detailed kinetic modeling. An aqueous solution of urea was injected into the flue gas stream …
Conversion of peat and coal nitrogen through HCN and NH3 to nitrogen oxides at 800 °C
1993
The conversion of fuel nitrogen through HCN and NH3 to nitrogen oxides (N2O, NO and NO2) was studied using an entrained-flow reactor at 800 °C with one coal and four peats at 5 and 1% O2. The ON ratios of the fuels were between 7 and 20. A clear dependence was found between the HCNNH3 ratio measured just after the vigorous pyrolysis step and the N2ONO ratio in the flue gas when these were plotted as a function of the initial ON ratio of the fuel.
Towards controlling PCDD/F production in a multi-fuel fired BFB boiler using two sulfur addition strategies. Part I: Experimental campaign and results
2014
Abstract Levels of PCDD/F production in a 140 MW th bubbling fluidized bed boiler were measured. The boiler uses solid recovered fuel, bark and sludge. Homologue distribution patterns suggest the de novo mechanism is the main pathway for the generation of dioxin and furans in the post combustion zones of the boiler. Two modes of sulfur addition were tested to induce the deactivation of Cu which has been identified as the prime catalyst of this mechanism. First, S-pellet promoted Cu sulfation as supported by aerosol sampling data and resulted in a decrease in PCDD/F levels. The second approach was adding sulfur through peat; this resulted in an increase in PCDD/F concentration. Factors such …
CHARACTERIZATION OF IRON COMPOUNDS FROM URBAN AND RURAL AEROSOL SOURCES
2000
Abstract Iron plays an important role in the chemistry and physics (by varying the hygroscopicity) of the atmosphere. Bulk samples were taken from an air-conditioning device, from the electrofilter of a gas–oil power station of the Technical University of and from rural sites near Darmstadt, situated between medium-altitude mountains and with a climate dominated by air masses from the west. Samples were collected in urban and rural (meadow) air, from different waste incineration power stations, from the exhausts of a gasoline and from a diesel motor car, and from a private gas fired heating system. The samples were characterized for elemental composition by total reflection X-ray fluorescen…
Recent advances in the preparation of zeolites for the selective catalytic reduction of NOx in diesel engines
2019
Metal-exchanged zeolites with small pore sizes have attracted much attention in recent years due to their application in the selective catalytic reduction (SCR) of NOx in diesel engines. Typically, copper-chabazite (e.g. Cu-SSZ-13) has been gradually used as an SCR catalyst in heavy-duty diesel vehicles over the last decade due to its relatively excellent catalytic performance and stability. However, most SSZ-13 zeolites are still prepared via the traditional hydrothermal process in the presence of organic templates, requiring consecutive solid separation and thermal treatment steps to achieve the final zeolite products. In recent years, several strategies for the environmentally friendly p…