Search results for "green synthesi"
showing 3 items of 13 documents
N-Doped Anatase/Rutile Photocatalysts for the Synthesis of Aromatic Aldehydes Under Ultraviolet and Solar Irradiation
2015
N-doped anatase/rutile photocatalysts were prepared by a sol-gel method, using TiCl4 as TiO2 precursor and urea as N-dopant source. The catalysts required a thermal treatment at temperature higher than 300 degrees C to achieve actual nitrogen doping; this treatment also allowed obtaining crystalline and hydrophobic samples. Moreover, nitrogen doping modified the surface of samples by increasing the anatase to rutile phase ratio and hydrophilicity. The catalysts were characterized by BET specific surface area, XRD, ESEM, TGA, FT-IR, DRS and XPS measurements, with particular attention to the assessment of the N-doping effect. It was found that XPS analysis should be used together with DRS and…
Hydroxypropylcellulose as a novel green reservoir for the synthesis, stabilization, and storage of silver nanoparticles
2015
Muhammad Ajaz Hussain,1 Abdullah Shah,1 Ibrahim Jantan,2 Muhammad Raza Shah,3 Muhammad Nawaz Tahir,4 Riaz Ahmad,5 Syed Nasir Abbas Bukhari2 1Department of Chemistry, University of Sargodha, Sargodha, Pakistan; 2Drug and Herbal Research Centre, Faculty of Pharmacy, Universiti Kebangsaan Malaysia, Jalan Raja Muda Abdul Aziz, Kuala Lumpur, Malaysia; 3International Center for Chemical and Biological Sciences, University of Karachi, Karachi, Pakistan; 4Institute of Inorganic and Analytical Chemistry, Johannes Guttenberg University, Duesbergweg, Mainz, Germany; 5Centre for Advanced Studies in Physics (CASP), GC University, Lahore, Pakistan Abstract: Polysaccharides are attracting the vigil eye of…
Photoelectrocatalytic selective oxidation of 4-methoxybenzyl alcohol in water by TiO2 supported on titanium anodes
2013
The photoelectrocatalytic partial oxidation of 4-methoxybenzyl alcohol in aqueous solution irradiated by near-UV light was carried out in a three-electrode batch reactor. TiO2 films were either deposited by dip-coating of a TiO2 sol onto a Ti foil and subsequent calcination or generated on Ti plates by thermal oxidation in air at 400-700 degrees C. The effects of the anode preparation method and bias potential values on conversion and selectivity to the corresponding aldehyde were investigated. The photoelectrocatalytic results were compared with the photocatalytic and electrocatalytic ones. The results indicated that no reaction occurred during the electrocatalytic experiments, whereas the…