Search results for "heat"

Time resolved measurements of hydrogen ion energy distributions in a pulsed 2.45 GHz microwave plasma

2017

A plasma diagnostic study of the Ion Energy Distribution Functions (IEDFs) of H+, H+2H2+, and H+3H3+ ions in a 2.45 GHz hydrogen plasma reactor called TIPS is presented. The measurements are conducted by using a Plasma Ion Mass Spectrometer with an energy sector and a quadrupole detector from HIDEN Analytical Limited in order to select an ion species and to measure its energy distribution. The reactor is operated in the pulsed mode at 100 Hz with a duty cycle of 10% (1 ms pulse width). The IEDFs of H+, H+2H2+, and H+3H3+ are obtained each 5 μs with 1 μs time resolution throughout the entire pulse. The temporal evolution of the plasma potential and ion temperature of H+ is derived from the d…

Polarity reversal in HVDC joints - The effect of the axial thermal conduction

2020

It has been shown that the establishment of a thermal gradient over the radius of HVDC cables involves the accumulation of space charge within the dielectric layer. High thermal gradients over the insulation thickness of loaded cables can lead to the inversion of the radial electric field pattern. In this scenarios, transient overvoltages and polarity reversal can lead to local and transitory peaks of electric field. Since the temperature distribution plays an important role in reaching critical values of the electric field, it has been considered interesting to have a more in-depth view of the thermal behavior of HVDC systems close the discontinuities of the geometry along the cable axis. …

Multiphysical Modeling of Transport Phenomena During Laser Welding of Dissimilar Steels

2016

Abstract The success of new high-strength steels allows attaining equivalent performances with lower thicknesses and significant weight reduction. The welding of new couples of steel grades requires development and control of joining processes. Thanks to high precision and good flexibility, laser welding became one of the most used processes for joining of dissimilar welded blanks. The prediction of the local chemical composition in the weld formed between dissimilar steels in function of the welding parameters is essential because the dilution rate and the distribution of alloying elements in the melted zone determines the final tensile strength of the weld. The goal of the present study i…

Single Enantiomer’s Urge to Crystallize in Centrosymmetric Space Groups: Solid Solutions of Phenylpiracetam

2017

A detailed thermochemical and structural study of the phenylpiracetam enantiomer system was performed by characterizing the solid solutions, rationalizing the structural driving force for their formation, as well as identifying a common structural origin responsible for the formation of solid solutions of enantiomers. Enantiomerically pure phenylpiracetam forms two enantiotropically related polymorphs (enant–A and enant–B). The transition point (70(7) °C) was determined based on isobaric heat capacity measurements. Structural studies revealed that enant–A and enant–B crystallize in space groups P1 (Z′ = 4) and P212121 (Z′ = 2), respectively. However, pseudoinversion centers were present res…

Geographic and temporal variations in turbulent heat loss from lakes : A global analysis across 45 lakes

2018

Heat fluxes at the lake surface play an integral part in determining the energy budget and thermal structure in lakes, including regulating how lakes respond to climate change. We explore patterns in turbulent heat fluxes, which vary across temporal and spatial scales, using in situ high-frequency monitoring data from 45 glob- ally distributed lakes. Our analysis demonstrates that some of the lakes studied follow a marked seasonal cycle in their turbulent surface fluxes and that turbulent heat loss is highest in larger lakes and those situated at low latitude. The Bowen ratio, which is the ratio of mean sensible to mean latent heat fluxes, is smaller at low lati- tudes and, in turn, the rel…

2019

Urban Heat Islands (UHIs) at the surface and canopy levels are major issues in urban planification and development. For this reason, the comprehension and quantification of the influence that the different land-uses/land-covers have on UHIs is of particular importance. In order to perform a detailed thermal characterisation of the city, measures covering the whole scenario (city and surroundings) and with a recurrent revisit are needed. In addition, a resolution of tens of meters is needed to characterise the urban heterogeneities. Spaceborne remote sensing meets the first and the second requirements but the Land Surface Temperature (LST) resolutions remain too rough compared to the urban o…

A coronal explosion on the flare star CN Leonis

2008

We present simultaneous high-temporal and high-spectral resolution observations at optical and soft X-ray wavelengths of the nearby flare star CN Leo. During our observing campaign a major flare occurred, raising the star's instantaneous energy output by almost three orders of magnitude. The flare shows the often observed impulsive behavior, with a rapid rise and slow decay in the optical and a broad soft X-ray maximum about 200 seconds after the optical flare peak. However, in addition to this usually encountered flare phenomenology we find an extremely short (~2 sec) soft X-ray peak, which is very likely of thermal, rather than non-thermal nature and temporally coincides with the optical …

Comment on “Rill erosion processes on steep colluvial deposit slope under heavy rainfall in flume experiments with artificial rain by F. Jiang et al.”

2020

Abstract Since rill flows are characterized by small water depths and steeply sloping channels, the corresponding hydraulic conditions are very different to those which are typically found in channels of streams and rivers. Furthermore, limited information is currently available on the effect of rainfall on flow resistance. The objective of this comment was to investigate the applicability of a recently theoretically deduced rill flow resistance equation, based on a power-velocity profile, using measurements carried out by Jiang et al. for both different slope steepness conditions and rainfall intensity. The relationship between the velocity profile parameter Γ, the channel slope and the fl…

Testing a theoretical resistance law for overland flow on a stony hillslope

2020

Overland flow, sediments, and nutrients transported in runoff are important processes involved in soil erosion and water pollution. Modelling transport of sediments and chemicals requires accurate estimates of hydraulic resistance, which is one of the key variables characterizing runoff water depth and velocity. In this paper, a new theoretical power–velocity profile, originally deduced neglecting the impact effect of rainfall, was initially modified for taking into account the effect of rainfall intensity. Then a theoretical flow resistance law was obtained by integration of the new flow velocity distribution. This flow resistance law was tested using field measurements by Nearing for the …

Estimating high resolution evapotranspiration from disaggregated thermal images

2016

Abstract Accurate evapotranspiration (ET) estimations based on surface energy balance from remote sensing require information in the thermal infrared (TIR) domain, normally provided with an insufficient spatial resolution. In order to estimate ET in heterogeneous agricultural areas, we inspect in this paper the use of disaggregation techniques applied to two different sensors, such as MODIS (daily revisit cycle and 1 km spatial resolution in the TIR domain) and Spot 5 (5 days revisit cycle and 10 m spatial resolution in the VNIR bands but no TIR band). Spot 5 images were used as a proxy for upcoming Sentinel-2. The Simplified Two-Source Energy Balance (STSEB) model was used for the estimati…