Search results for "hydrogel"

Evaluation of the anti-inflammatory and analgesic action of hydrogel in thyroid orbitopathy.

2011

Purpose: To evaluate the analgesic efficacy of applying on the eyelid surface sterile hydrogel dressings containing substances such as pineapple extract which has anti-inflammatory and antioedema properties, and 18 beta-glycyrrhetinic acid. Design: Randomized prospective clinical trial. Methods: 50 patients (16 males and 34 females) affected with thyroid-associated orbitopathy in acute phase equally distributed in two groups. The level of patient satisfaction of the treatment was measured by answering a questionnaire before and after the treatment phase. Results: While 24 patients of study group reported an reduction in the pain only 2 of control group did. In the study group questionnaire’…

Qualitative and quantitative characterization of the in vitro dehydration process of hydrogel contact lenses

2007

Purpose: To investigate the in vitro dehydration process of conventional hydrogel and silicone-hydrogel contact lens materials. Methods: Eight conventional hydrogel and five silicone-hydrogel contact lenses were dehydrated under controlled environmental conditions on an analytical balance. Data were taken at 1-min intervals and dehydration curves of cumulative dehydration (CD), valid dehydration (VD), and dehydration rate (DR) were obtained. Several quantitative descriptors of the dehydration process were obtained by further processing of the information. Results: Duration of phase I (r 2 5 0.921), CD at end of phase I (r 2 5 0.971), time to achieve a DR of � 1%/min (r 2 5 0.946) were stron…

Surface AFM microscopy of unworn and worn samples of silicone hydrogel contact lenses

2008

Abstract: Purpose. To evaluate the qualitative and quantitative topographic changes in the surface of worn contact lenses (CLs) of different materials using atomic force microscopy (AFM). Methods. The topography of five different CL materials was evaluated withAFM over a surface of 25 lm2 according to previously published experimental setup. Average roughness (Ra) and root mean square (Rms) values were obtained for unworn and worn samples. Results. The Ra value increased for balafilcon A (11.62–13.68 nm for unworn and worn samples, respectively), lotrafilcon A (3.67–15.01 nm for unworn and worn samples, respectively), lotrafilcon B (4.08–8.42 nm for unworn and worn samples, respectively), g…

Smart hydrogels with Spheroids of Adipose stem cells for minimally invasive bone and cartilage regeneration

2022

Adipose stem cell spheroids-laden hydrogels for minimally invasive bone and cartilage regeneration interventions

2021

A POLYCARBOXYLIC/AMINO FUNCTIONALIZED HYALURONIC ACID DERIVATIVE FOR THE PRODUCTION OF pH SENSIBLE HYDROGELS IN THE PREVENTION OF BACTERIAL ADHESION …

2014

A graft copolymer derivative of hyaluronic acid bearing pendant amino and short polymethacrylate portions (HA-EDA-BMP-MANa) has been employed for the production of a pH sensible vancomycin releasing hydrogel and studied in vitro to test its potential anti adhesive property against Staphylococcus aureus colonization. The copolymer obtained through atom transfer radical polymerization bears chargeable (carboxyl and amino groups) portions and it could be formulated as a hydrogel at a concentration of 10% w/v. The HA-EDA-BMP-MANa hydrogels, produced at three different pH values (5, 6 and 7, respectively), were formulated with or without the addition of vancomycin (2% w/v). The vancomycin releas…

Microparticles derived from marine sponge collagen (SCMPs): preparation, characterization and suitability for dermal delivery of all-trans retinol.

2002

Abstract Collagen microparticles were prepared using marine sponge collagen. For this purpose a previous method by Rossler et al. (J. Microencapsul. 12 (1995) 49) of emulsification and cross-linking of native calf collagen was modified. The modified method for sponge collagen microparticles (SCMPs) achieved a yield of 10%. Scanning electromicroscopic photographs showed spherical particles with a diameter of 120–300 nm and photon correlation spectroscopic measurements indicated particle size range from 126 (±2.9) to 2179 (±342) nm. This broad size distribution was caused by some agglomerates that could not be destroyed by ultrasonication. The surface charge was measured as a function of pH. …

Photocrosslinkable polysaccharide hydrogel composites based on dextran or pullulan-amylose blends with cytokines for a human co-culture model of huma…

2016

Although a large body of research has been devoted to biomaterial development for bone tissue engineering and related medical disciplines in the last few years, novel and optimized materials especially for bone fractures of critical sizes demand continued development. In this respect, polysaccharide-based hydrogels demonstrate beneficial properties and fulfill the main requirements for a bone tissue scaffold as they are hydrophilic, biocompatible, and biodegradable. The aim of the present study was the development of a natural polysaccharide-based scaffold material that can integrate with the host tissue and support bone regeneration. For this purpose, we prepared and investigated two polym…

Effect of crosslinking strategy on the biological, antibacterial and physicochemical performance of hyaluronic acid and ɛ-polylysine based hydrogels

2022

The design of multifunctional hydrogels based on bioactive hyaluronic acid (HA) and antibacterial cationic polymer ε-poly-L-lysine (ε-PL) is a promising tool in tissue engineering applications. In the current study, we have designed hyaluronic acid and ε-polylysine composite hydrogel systems with antibacterial and cell attractive properties. Two distinct crosslinking approaches were used: the physical crosslinking based on electrostatic at- tractions and the chemical crosslinking of charged functional groups (-NH2 and -COOH). The impact of the crosslinking strategy on fabricated hydrogel molecular structure, swelling behavior, gel fraction, morphology, porosity, visc…

Hydrogels for potential colon drug release by thiol-ene conjugate addition of a new inulin derivative.

2008

Inulin was chosen as a starting polymer for biocompatible, pH-sensitive and biodegradable hydrogels. Three INUDVSA-TT hydrogels were obtained by crosslinking inulin derivatives with trimethylolpropane tris(3-mercaptopropionate) under varying conditions. The resulting hydrogels were cell compatible, as demonstrated by MTS and trypan blue exclusion assays acting on Caco-2 cells, and were biodegraded by inulinase and esterase, thus suggesting their use as colonic drug delivery systems. 2-Methoxyestradiol, an anti-cancer drug, was soaked in INUDVSA-TT hydrogels and its in vitro release and apoptotic effect on Caco-2 cells were evaluated.