Search results for "kinematics"
showing 10 items of 481 documents
Relativistic kinematic approach to the classical ideal gas
2019
he necessary and sufficient conditions for a unit time-like vector field to be the unit velocity of a classical ideal gas are obtained. In a recent paper [Coll, Ferrando and S\'aez, Phys. Rev D {\bf 99} (2019)] we have offered a purely hydrodynamic description of a classical ideal gas. Here we take one more step in reducing the number of variables necessary to characterize these media by showing that a plainly kinematic description can be obtained. We apply the results to obtain test solutions to the hydrodynamic equation that model the evolution in local thermal equilibrium of a classical ideal gas. \end{abstract}
Software tools for using a personal computer as a timer device to assess human kinematic performance: a case study.
1995
Frequently, the assessment of the physical condition of a sportsman depends on the evaluation of different tests, based on biomechanical performance. The data acquisition in these tests is usually hand made, because its automatization is difficult. But when movements are constrained by means of their specific nature, simple tools can be used to achieve that data acquisition. In this paper, a simple and inexpensive system is described to make use of the timing capabilities of a personal computer (PC) to use it as a timer, with applications in biomechanics and sport training. The data acquisition method is based on a PC that, using a specific programming dealing with event timing, gets signal…
Variational formulations and extra boundary conditions within stress gradient elasticity theory with extensions to beam and plate models
2016
Abstract The principle of minimum total potential energy and the primary principle of virtual power for stress gradient elasticity are presented as kinematic type constructs dual of analogous static type principles from the literature (Polizzotto, 2014; Polizzotto, 2015a). The extra gradient-induced boundary conditions are formulated as “boundary congruence conditions” on the microstructure’s deformation relative to the continuum, which ultimately require that the normal derivative of the stresses must vanish at the boundary surface. Two forms of the governing PDEs for the relevant boundary-value problem are presented and their computational aspects are discussed. The Timoshenko beam and th…
An analytical solution for multilayered beams subjected to ends loads
2014
An alternative model for multilayered beams undergoing axial, shear and bending loads applied at the beam's ends is developed. It is based on a layer-wise kinematics, which inherently fulfills the equilibrium equations at layer level and the interface continuity conditions. This kinematics is suitably expressed by introducing a set of generalized variables representative of the beam midline displacement field, which become the primary variables of the problem governing equations. As a consequence, the proposed beam model exhibits the computational characteristics of an equivalent single layer model and possesses the accuracy of layer-wise beam theories, as well. Closed form solutions for di…
Measurement of thett¯production cross section inpp¯collisions ats=1.96 TeVusing soft electronb-tagging
2010
The authors present a measurement of the t{bar t} production cross section using events with one charged lepton and jets from p{bar p} collisions at a center-of-mass energy of 1.96 TeV. A b-tagging algorithm based on the probability of displaced tracks coming from the event interaction vertex is applied to identify b quarks from top decay. Using 318 pb{sup -1} of data collected with the CDF II detector, they measure the t{bar t} production cross section in events with at least one restrictive (tight) b-tagged jet and obtain 8.9{sub -1.0}{sup +1.0}(stat.){sub -1.0}{sup +1.1}(syst.) pb. The cross section value assumes a top quark mass of m{sub t} is presented in the paper. This result is cons…
Combined Forward-Backward Asymmetry Measurements in Top-Antitop Quark Production at the Tevatron
2018
The CDF and D0 experiments at the Fermilab Tevatron have measured the asymmetry between yields of forward- and backward-produced top and antitop quarks based on their rapidity difference and the asymmetry between their decay leptons. These measurements use the full data sets collected in proton-antiproton collisions at a center-of-mass energy of √s=1.96 TeV. We report the results of combinations of the inclusive asymmetries and their differential dependencies on relevant kinematic quantities. The combined inclusive asymmetry is At¯tFB=0.128±0.025. The combined inclusive and differential asymmetries are consistent with recent standard model predictions.
Effect of 5% body weight forward pulling on dynamics of treadmill running
2003
Forward pulled running on a treadmill is known to increase mechanical and decrease metabolic constrains relative to normal running. This experimental situation was used to investigate the variations of the mechanical parameters induced by the pulling. Ten subjects ran during 3 min at individually predetermined constant speeds of 16.4 ± 1.4 km · h-1 on a treadmill while being forward pulled by a load equal to 5% of their body weight. Ground reaction forces were recorded during the last 30 s of the run. Kinematic parameters of the stride as well as impulses and mechanical work were then calculated. Stride frequency did not change, while horizontal impulses were highly modified (+38% and -28%,…
On Holditch's theorem and related kinematics
2019
El teorema de Holditch es un resultado clásico sobre áreas de curvas planas generadas por el movimiento de segmentos. Esta construcción está estrechamente relacionada con otros tipos de curvas como, por ejemplo, curvas paralelas, curvas de anchura constante o curvas de bicicletas. Se compilan las propiedades básicas de este tipo de curvas y se da una revisión histórica sobre el teorema de Holditch y teoremas relacionados de cinemática. Primero, la situación plana de Holditch se define rigurosamente y se consideran ciertos problemas como la existencia de dicha construcción o el modo de evitar movimientos retrógrados en el segmento que se va moviendo. En el enunciado del teorema de Holditch a…
Design of the stabilization control system of a high-speed craft
2016
In this paper, the main causes of technical malfunction of a hydrofoil was analyzed. In particular, a preliminary analysis evaluates the economic impact for the navigation company of the periodical maintenance related to the keeping of the vessel in dry dock. The study demonstrated that the main critical points are focused on the fragility of the stabilization control system. The increasing of operating costs has motivated the realization of a study aimed at redesigning the stabilization system. The continuing failure of the stabilization system (usually in water-immersed) severely limits the use of the high-speed craft. The proposed design solution considers the positioning of the control …
Mathematical modeling of a vehicle crash test based on elasto-plastic unloading scenarios of spring-mass models
2011
Published version of an article in the journal: The International Journal of Advanced Manufacturing Technology. Also available from the publisher on SpringerLink: htp://dx.doi.org/10.1007/s00170-010-3056-x This paper investigates the usability of spring which exhibit nonlinear force-deflection characteristic in the area of mathematical modeling of vehicle crash. We present a method which allows us to obtain parameters of the spring-mass model basing on the full-scale experimental data analysis. Since vehicle collision is a dynamic event, it involves such phenomena as rebound and energy dissipation. Three different spring unloading scenarios (elastic, plastic, and elasto-plastic) are covered…