Search results for "knocking"
showing 5 items of 5 documents
Analysis of the Combustion Process in a Hydrogen-Fueled CFR Engine
2023
Green hydrogen, produced using renewable energy, is nowadays one of the most promising alternatives to fossil fuels for reducing pollutant emissions and in turn global warming. In particular, the use of hydrogen as fuel for internal combustion engines has been widely analyzed over the past few years. In this paper, the authors show the results of some experimental tests performed on a hydrogen-fueled CFR (Cooperative Fuel Research) engine, with particular reference to the combustion. Both the air/fuel (A/F) ratio and the engine compression ratio (CR) were varied in order to evaluate the influence of the two parameters on the combustion process. The combustion duration was divided in two par…
Preliminary Experimental Study on Double Fuel HCCI Combustion
2015
AbstractThis paper regards an experimental study on a particular internal combustion engine process which combines Double Fuel combustion with Homogeneous Charge Compression Ignition (HCCI) using mixtures of natural gas (NG) and gasoline. The tests performed on a CFR engine demonstrate that HCCI combustion can be achieved using NG-gasoline mixtures without knocking occurrence for low to medium engine load varying the proportion between the two fuels. The main advantage of this new combustion process relies on the noticeable higher engine efficiency obtained with respect to conventional spark ignition operation, and on the strong reduction of NOX emissions.
Calibration of a knock prediction model for the combustion of gasoline-LPG mixtures in spark ignition engines
2015
Gaseous fuels, such as liquefied petroleum gas (LPG) and natural gas (NG), thanks to their good mixing capabilities, allow complete and cleaner combustion than gasoline in spark ignition (SI) engines, resulting in lower pollutant emissions and particulate matter. In a previous work the authors showed that the simultaneous combustion of gasoline and LPG improves an SI engine efficiency with respect to pure gasoline operation with any significant power loss. The addition of LPG to the gasoline-air mixture produces an increase in knock resistance that allows running the engine at full load with overall stoichiometric mixture and better spark advance. In order to predict both performance and ef…
Octane Rating of Natural Gas-Gasoline Mixtures on CFR Engine
2014
In the last years new and stricter pollutant emission regulations together with raised cost of conventional fuels resulted in an increased use of gaseous fuels, such as Natural Gas (NG) or Liquefied Petroleum Gas (LPG), for passenger vehicles. Bi-fuel engines represent a transition phase product, allowing to run either with gasoline or with gas, and for this reason are equipped with two separate injection systems. When operating at high loads with gasoline, however, these engines require rich mixtures and retarded combustions in order to prevent from dangerous knocking phenomena: this causes high hydrocarbon (HC) and carbon monoxide (CO) emissions together with high fuel consumption. With t…
Efficient selection of silenced primary cells by flow cytometry
2007
Background: RNA interference has emerged as a new and potent tool to knockdown the expression of target genes and to investigate their functions. For short time experiments with mammalian cell lines, RNA interference is typically induced by transfecting small interfering RNAs (siRNAs). Primary cells constitute important experimental systems in many studies because of their similarity to their in vivo counterparts; however, transfection of these cells has been found to be difficult. As a consequence, RNA interference of primary cells may result in mixed phenotypes because of the simultaneous presence in the same preparation of transfected and nontransfected cells. This may be particularly in…