Search results for "lcsh:TK1-9971"
showing 7 items of 157 documents
Sonication-Induced Modification of Carbon Nanotubes: Effect on the Rheological and Thermo-Oxidative Behaviour of Polymer-Based Nanocomposites.
2018
The aim of this work is the investigation of the effect of ultrasound treatment on the structural characteristics of carbon nanotubes (CNTs) and the consequent influence that the shortening induced by sonication exerts on the morphology, rheological behaviour and thermo-oxidative resistance of ultra-high molecular weight polyethylene (UHMWPE)-based nanocomposites. First, CNTs have been subjected to sonication for different time intervals and the performed spectroscopic and morphological analyses reveal that a dramatic decrease of the CNT's original length occurs with increased sonication time. The reduction of the initial length of CNTs strongly affects the nanocomposite rheological behavio…
Thermo-Mechanical Behaviour of Flax-Fibre Reinforced Epoxy Laminates for Industrial Applications
2015
The present work describes the experimental mechanical characterisation of a natural flax fibre reinforced epoxy polymer composite. A commercial plain woven quasi-unidirectional flax fabric with spun-twisted yarns is employed in particular, as well as unidirectional composite panels manufactured with three techniques: hand-lay-up, vacuum bagging and resin infusion. The stiffness and strength behaviours are investigated under both monotonic and low-cycle fatigue loadings. The analysed material has, in particular, shown a typical bilinear behaviour under pure traction, with a knee yield point occurring at a rather low stress value, after which the material tensile stiffness is significantly r…
Pressure-Dependent Tuning of Photoluminescence and Size Distribution of Carbon Nanodots for Theranostic Anticancer Applications
2020
Carbon nanodots (CDs) have recently attracted attention in the field of nanomedicine because of the biocompatibility, cost-effective nature, high specific surface, good near infrared (NIR) photothermal conversion into heat and tunable fluorescence properties, which have paved the way toward incorporating use of CDs into innovative anticancer theranostic platforms. However, a reliable synthesis of CDs with established and controlled physiochemical proprieties is precluded owing to the lack of full manipulation of thermodynamic parameters during the synthesis, thus limiting their use in real world medical applications. Herein, we developed a robust solvothermal protocol which allow fine contr…
Estimation of the Time-Variant Velocity of a Single Walking Person in Two-Dimensional Non-Stationary Indoor Environments Using Radio-Frequency Techni…
2020
Accurate estimation of the time-variant (TV) velocity of moving persons/objects in indoor spaces is of crucial importance for numerous wireless indoor applications. This article introduces a novel iterative procedure to estimate the TV velocity, i.e., TV speed and TV angle-of-motion (AOM), of a single moving person in 2D indoor environments by using radio-frequency (RF) techniques. The indoor area is equipped with a distributed 2 × 2 multiple-input multiple-output (MIMO) system. The proposed method is divided into two parts. In the first part, we estimate the path gains and the instantaneous Doppler frequencies by fitting the exact spectrograms of the complex channel gains of a 2D no…
Electronic Energy Meter Based on a Tunnel Magnetoresistive Effect (TMR) Current Sensor
2017
In the present work, the design and microfabrication of a tunneling magnetoresistance (TMR) electrical current sensor is presented. After its physical and electrical characterization, a wattmeter is developed to determine the active power delivered to a load from the AC 50/60 Hz mains line. Experimental results are shown up to 1000 W of power load. A relative uncertainty of less than 1.5% with resistive load and less than 1% with capacitive load was obtained. The described application is an example of how TMR sensing technology can play a relevant role in the management and control of electrical energy.
IEEE Access Special Section Editorial: Exploiting the Benefits of Interference in Wireless Networks: Energy Harvesting and Security
2018
Interference used to be viewed as a harmful factor in wireless networks, which can reduce the quality of information transmission. To combat against interference, many interference management techniques have emerged. Due to the latest research advances, interference (or noise) can also be exploited to offer some benefits to wireless networks. The first aspect is that interference in multi-user networks can be collected as a green power supply for the transceivers, known as wireless energy harvesting. Another application is that one can generate artificial noise to disrupt the adversarial eavesdropping, and guarantee the security of wireless networks. Therefore, conventional interference man…
Underwater Multirobot Cooperative Intervention MAC Protocol
2020
This work introduces a Medium Access Control (MAC) protocol designed to allow a group of underwater robots that share a wireless communication channel to effectively communicate with each other. The goal of the Underwater Multirobot Cooperative Intervention MAC (UMCI-MAC) protocol presented in this work is to minimize the end to end delay and the jitter. The access to the medium in UMCI-MAC follows a Time Division Multiple Access (TDMA) strategy which is arbitrated by a master, which also has the capability to prioritize the transmission of some nodes over the rest of the network. Two experiments have been carried out with a team of four Autonomous Underwater Vehicles (AUV) in order to comp…