Search results for "limiter"

A symmetric nonlocal damage theory

2003

The paper presents a thermodynamically consistent formulation for nonlocal damage models. Nonlocal models have been recognized as a theoretically clean and computationally efficient approach to overcome the shortcomings arising in continuum media with softening. The main features of the presented formulation are: (i) relations derived by the free energy potential fully complying with nonlocal thermodynamic principles; (ii) nonlocal integral operator which is self-adjoint at every point of the solid, including zones near to the solid's boundary; (iii) capacity of regularizing the softening ill-posed continuum problem, restoring a meaningful nonlocal boundary value problem. In the present app…

Circuit proposals for high-voltage latching current limiters

2019

This work discusses some ideas to adapt existing low voltage Latching Current Limiter (LCL) circuits to high voltage operation to provide a basis for future designs. Component selection, driver and ancillary power supply are key issues discussed which eventually provides a high-voltage LCL proposal. Experimental validation of two different prototypes (380Vdc and 1kVdc) is included as well as some digital techniques to enhance LCL capabilities.

Currents Distribution During a Fault in an MV Network: Methods and Measurements

2016

When a single line to ground fault happens on the MV side of a HV/MV system, only a small portion of the fault current is injected into the ground by the ground-grid of the faulty substation. In fact the fault current is distributed between grounding electrodes and MV cables sheaths. In systems with isolated neutral or with resonant earthing this may be sufficient to provide safety from electric shock. Experimental measurements were performed on a real MV distribution network: a real single line to ground fault was made and fault currents were measured in the faulty substation and in four neighboring substations. In this paper the problem of fault current distribution is introduced, the tes…

Arc Fault Detection Method Based on CZT Low-Frequency Harmonic Current Analysis

2017

This paper presents a method for the detection of series arc faults in electrical circuits, which has been developed starting from an experimental characterization of the arc fault phenomenon and an arcing current study in several test conditions. Starting from this, the authors have found that is it possible to suitably detect arc faults by means of a high-resolution low-frequency harmonic analysis of current signal, based on chirp zeta transform, and a proper set of indicators. The proposed method effectiveness is shown by means of experimental tests, which were carried in both arcing and nonarcing conditions and in the presence of different loads, chosen according to the UL 1699 standard…

Reducing DC Link Voltage Unbalance in a Fault-Tolerant Inverter

2014

Today, continuous working of power inverter drives is mandatory for several applications. Damages to materials, machines or even risks to human life have to be absolutely avoided. In the literature, fault-tolerant algorithms and architectures to achieve a successful fault handling are investigated. Researchers aim at reducing the number and cost of additional components, improving at the same time the inverter performances under postfault conditions. Cost, post-fault power derating and increasing distortion are usually conflicting requirements. In this paper, a fault-tolerant three phase inverter is presented. A reconfigurable architecture and a novel fault-tolerant algorithm is designed to…

Control of solid-state fault current limiter for DG-integrated distribution systems

2017

Fault current limier (FCL) is a device that limits the system current under fault conditions without disconnecting the system and affecting the power system protection components such as circuit breakers. Many types of FCLs have been proposed to limit the magnitude of the fault current. Solid-state fault current limiters (SSFCLs) can limit the peak value of the fault current by applying several methods, such as controlling the system impedance or controlling the voltage that appears across the fault. In this paper, a new control scheme for the SSFCL circuit is presented. The control method is based on controlling the duty cycle of solid state switches to control the rms value of the system …

Current and Voltage Behaviour During a Fault in a HV/MV System: Methods and Measurements

2015

When a single line to ground fault happens on the MV side of a HV/MV system, only a small portion of the fault current is injected into the ground by the ground-grid of the faulty substation. In fact the fault current is distributed between grounding electrodes and MV cables sheaths. In systems with isolated neutral or with resonant earthing this may be sufficient to provide safety from electric shock. Experimental measurements were performed on a real MV distribution network: a real single line to ground fault was made and fault currents were measured in the faulty substation and in four neighbouring substations. In this paper the problem of fault current distribution is introduced, the te…

Studio termomeccanico del modulo Limiter del reattore ITER-FEAT

2002

First Results of the Testing of the Liquid Gallium Jet Limiter Concept for ISTTOK

2006

The use of liquid metals as plasma facing components in tokamaks has recently experienced a renewed interest stimulated by their advantages to the development of a fusion reactor. Liquid metals have been proposed to solve problems related to the erosion and neutronic activation of solid walls submitted to high power loads allowing an efficient heat exhaustion from fusion devices. Presently the most promising materials are Lithium and Gallium. ISTTOK, a small size tokamak, will be used to test the behavior of a liquid Gallium jet in the vacuum chamber and its influence on the plasma. This paper presents a description of the conceived setup as well as experimental results. The liquid Gallium …

Interaction of a liquid gallium jet with the tokamak ISTTOK edge plasma

2008

Abstract The interaction of a liquid gallium jet with plasma has been investigated in the tokamak ISTTOK. This paper presents a description of the conceived experimental setup, a detailed characterization of the produced jets and the first experimental results related to the gallium–plasma interaction. A stable jet has been obtained, which was not noticeably affected by magnetic field transients. ISTTOK has been successfully operated with the gallium jet without degradation of the discharge or a significant plasma contamination by liquid metal. This observation is supported by spectroscopic measurements showing that gallium radiation is limited to the region around the jet. Furthermore, the…