Search results for "magnetic materials"
showing 9 items of 4679 documents
2-Methylresorcinarene: a very high packing coefficient in a mono-anion based dimeric capsule and the X-ray crystal structure of the tetra-anion
2016
Mono- and tetra-deprotonated 2-methylresorcinarene anions (1 and 2) as their trans-1,4-diammoniumcyclohexane (TDAC)2+ inclusion complexes are reported. The mono-anion forms a fully closed dimeric capsule [1·H2O·MeOH]22− with a cavity volume of 165 Å3 and (TDAC)2+ as the guest with an extremely high packing coefficient, PC = 84.2%, while the tetra-anion forms a close-packed structure with two structurally isomeric tetra-anions 2a and 2b with a 50 : 50 ratio in the crystal lattice. peerReviewed
Feasibility of conductive embroidered threads for I 2 C sensors in microcontroller-based wearable electronics
2023
Abstract In recent years, the importance of flexible and textile electronics in the field of wearable devices has continuously increased, as they are expected to replace conventional wires that exhibit limited resistance to the mechanical stress occurring in on-body applications. Wearable health devices (WHDs) can provide physiological information about various body parts and employ distributed sensor networks. Among the sensors typically integrated within WHDs, those based on the I2C communication protocol are very common and exploit signals transmitted at frequencies up to hundreds of kilohertz. Therefore, robust communication is required to guarantee a proper transmission of the signal a…
Gold Au(I)6 Clusters with Ligand-Derived Atomic Steric Locking: Multifunctional Optoelectrical Properties and Quantum Coherence
2023
Funding Information: This work was supported by the ERC Advanced grant (DRIVEN, ERC‐2016‐AdG‐742829), the ERC grant (834742), the EU H2020‐MSCA‐RISE‐872049 (IPN‐Bio), the Academy of Finland's Centre of Excellence in Molecular Engineering of Biosynthetic Hybrid Materials Research (HYBER, 2014–2019), and Life‐Inspired Hybrid Materials (LIBER, 346108), Academy of Finland project fundings (No. 352900, 314810, 333982, 336144, 352780, 352930 and 353364), FinnCERES and Photonics Research and Innovation (PREIN) flagship programs. The authors acknowledge the provision of facilities and technical support by Aalto University OtaNano – Nanomicroscopy Center (Aalto‐NMC). | openaire: EC/H2020/834742/EU//…
Lidar detection of carbon dioxide in volcanic plumes
2015
Volcanic gases give information on magmatic processes. In particular, anomalous releases of carbon dioxide precede volcanic eruptions. Up to now, this gas has been measured in volcanic plumes with conventional measurements that imply the severe risks of local sampling and can last many hours. For these reasons and for the great advantages of laser sensing, the thorough development of volcanic lidar has been undertaken at the Diagnostics and Metrology Laboratory (UTAPRAD-DIM) of the Italian National Agency for New Technologies, Energy and Sustainable Economic Development (ENEA). In fact, lidar profiling allows one to scan remotely volcanic plumes in a fast and continuous way, and with high s…
Waste heat recovery from a marine waste incinerator using a thermoelectric generator
2012
Published version of an article published in the journal: Journal of Electronic Materials. Also available from the publisher at: http://dx.doi.org/10.1007/s11664-012-2009-6 A marine waste incinerator has been evaluated for waste heat harvesting using thermoelectric generators (TEG). The application has been evaluated using mathematical modeling to optimize the heat exchanger and some vital design parameters of the TEG. The calculation shows that it is possible to extract 58 kW el at a price of 6.6 US$/W from an 850-kW th incinerator when optimizing for maximum power. However, minimizing the cost, it is possible to get 25 kW el at a price of 2.5 US$/W. A trade-off between the two targets lea…
Synergistic effect of W incorporation and pulsed current mode on wear and tribocorrosion resistance of coatings grown by plasma electrolytic oxidatio…
2019
Ceramic coatings were grown by plasma electrolytic oxidation on 7075 Al alloy using unipolar and bipolar pulsed current waveforms with 20 and 40% cathodic duty cycles, from a silicate-based bath without and with the addition of Na2WO4. Pancake-like morphology was dominant on the coatings grown by unipolar waveform, while the bipolar waveforms promoted volcano-like morphology, increased the roughness of the coating surface and the formation of more compact layers. The coatings produced using the bipolar waveforms provided higher resistances toward both tribocorrosion and dry sliding conditions, while further improvement was achieved by the presence of tungsten. The coatings produced in tungs…
The Large Observatory For x-ray Timing
2014
The Large Observatory For x-ray Timing (LOFT) was studied within ESA M3 Cosmic Vision framework and participated in the final down-selection for a launch slot in 2022-2024. Thanks to the unprecedented combination of effective area and spectral resolution of its main instrument, LOFT will study the behaviour of matter under extreme conditions, such as the strong gravitational field in the innermost regions of accretion flows close to black holes and neutron stars, and the supra-nuclear densities in the interior of neutron stars. The science payload is based on a Large Area Detector (LAD, 10 m 2 effective area, 2-30 keV, 240 eV spectral resolution, 1 deg collimated field of view) and a WideFi…
Experimental study of MMI structures in a switchable continuous-wave thulium-doped all-fiber laser
2022
Switchable multi-wavelength laser emission from a thulium-doped all-fiber laser is reported by implementing a tapered and a non-tapered multi-modal interference (MMI) filters. The MMI structure relies on a coreless optical fiber spliced in between two single-mode optical fibers. For the non-tapered case, a minimum insertion loss of 12.60 dB is achieved around the 2-μm region, from which stable generation of commutable dual-wavelength emission at 1986.34 nm and 2017.38 nm is obtained. On the other hand, the tapered MMI structure performs a minimum insertion loss of 8.74 dB at the 2-μm region, allowing a stable triple-wavelength emission at 1995.4 nm, 2013.3 nm, and 2038.3 nm. In addition, co…
Narrowband Monolithic Perovskite-Perovskite Tandem Photodetectors
2022
Narrowband photodetectors (PDs) are sought after for many applications requiring selective spectral response. The most common systems combine optical bandpass filters with broadband photodiodes. This work reports a method to obtain a narrowband response in a perovskite PD by the monolithic integration of a perovskite photoconductor and a perovskite photodiode. The spectral response of the tandem PD is determined by the bandgap energy difference of the two perovskites, and exhibits a full width at half maximum below 85 nm, an external quantum efficiency up to 68% and a high specific detectivity of ≈1012 Jones in reverse bias, enabling the device to detect weak light signals. The absorption p…