Search results for "meter"

Differences in estimates of change of bone accrual and body composition in children because of scan mode selection with the prodigy densitometer.

2004

Abstract Girls of age 10–13 yr with Tanner stage I–III maturation status ( n = 155) were measured using the Prodigy (GE Lunar) densitometer. Bone area (BA), bone mineral content (BMC), and bone mineral density (BMD) were assessed for the whole body, lumbar spine, and proximal femur using the Thin (T) and Standard (S) scan modes at years 1 and 3 of the study. The differences obtained between the T and S mode at year 1 were 1–2% for the lumbar spine and proximal femur and 5–11% for the whole body. For those girls whose default mode changed from T at year 1 to S mode at year 3, the estimated gain in BA, BMC, and BMD was 3.4%, 7.6%, and 3.1% respectively, lower than that obtained when scanning …

Muscle deficits persist after unilateral knee replacement and have implications for rehabilitation.

2009

BackgroundKnee joint arthritis causes pain, decreased range of motion, and mobility limitation. Knee replacement reduces pain effectively. However, people with knee replacement have decreases in muscle strength (“force-generating capacity”) of the involved leg and difficulties with walking and other physical activities.Objective and DesignThe aim of this cross-sectional study was to determine the extent of deficits in knee extensor and flexor muscle torque and power (ability to perform work over time) and in the extensor muscle cross-sectional area (CSA) after knee joint replacement. In addition, the association of lower-leg muscle deficits with mobility limitations was investigated.Methods…

Use of accelerometers and gyros for hip and knee angle estimation

2013

In this paper a wearable sensor system, consisting of accelerometers and gyros, has been studied to estimate hip and knee angles. The proposed algorithm, developed in order to avoid the error accumulation due to gyroscopes drift, has been tested on angle measurement of the hip and knee of a commercial device for assisted gait. The results have shown a good accuracy of the angles estimation, also in high angle rate movement

CCDC 863441: Experimental Crystal Structure Determination

2012

Related Article: P.Svec, R.Olejnik, Z.Padelkova, A.Ruzicka, L.Plasseraud|2012|J.Organomet.Chem.|708|82|doi:10.1016/j.jorganchem.2012.02.022

CCDC 1922191: Experimental Crystal Structure Determination

2019

Related Article: Julian Radtke, Kai Schickedanz, Marcel Bamberg, Luigi Menduti, Dieter Schollmeyer, Michael Bolte, Hans-Wolfram Lerner, Matthias Wagner|2019|Chemical Science|10|9017|doi:10.1039/C9SC03115D

Elemental and microbiota content in indoor and outdoor air using recuperation unit filters

2021

Detection and quantification of engineered nanomaterials in environmental systems require precise knowledge of the elemental composition, association, and ratios in homologous natural nanomaterials (NNMs). Here, we characterized soil NNMs at the single particle level using single particle-inductively coupled plasma-time of flight-mass spectrometer (SP-ICP-TOF-MS) in order to identify the elemental purity, composition, associations, and ratios within NNMs. Elements naturally present as a major constituent in NNMs such as Ti, and Fe occurred predominantly as pure/single metals, whereas elements naturally present at trace levels in NNMs occurred predominantly as impure/multi-metal NNMs such as…

Comparison of different theory models and basis sets in the calculation of 13C NMR chemical shifts of natural products.

2004

The influence of the calculation method in mimicking experimental 13C NMR chemical shifts of 15 low-polarity natural products singularly containing 10–20 carbon atoms was investigated by employing different quantum chemistry approaches and basis sets, both in the preliminary geometry optimizations and in the following single-point 13C GIAO calculations of the NMR chemical shifts. The geometries of the involved species were optimized at the PM3, HF, B3LYP and mPW1PW91 levels whereas the 13C NMR parameters were determined at the HF, B3LYP and mPW1PW91 levels. Different combinations of basis sets were also tested. The consistency and efficiency of the considered combinations of geometry optimi…

Tietäjiä, taikojia, hautausmaita : taikuus Suomessa 1700-luvun jälkipuoliskolla

2016

Increasing the Astrophysical Reach of the Advanced Virgo Detector via the Application of Squeezed Vacuum States of Light

2019

Current interferometric gravitational-wave detectors are limited by quantum noise over a wide range of their measurement bandwidth. One method to overcome the quantum limit is the injection of squeezed vacuum states of light into the interferometer's dark port. Here, we report on the successful application of this quantum technology to improve the shot noise limited sensitivity of the Advanced Virgo gravitational-wave detector. A sensitivity enhancement of up to 3.2±0.1 dB beyond the shot noise limit is achieved. This nonclassical improvement corresponds to a 5%-8% increase of the binary neutron star horizon. The squeezing injection was fully automated and over the first 5 months of the thi…

The advanced Virgo longitudinal control system for the O2 observing run

2020

Following a successful period of data-taking between 2006 and 2011, the Virgo gravitational-wave detector was taken offline for a major upgrade. The changes made to the instrument significantly increased the complexity of the control systems and meant that an extended period of commissioning was required to reach a sensitivity appropriate for science data-taking. This commissioning period was completed in July of 2017 and the second-generation Advanced Virgo detector went on to join the Advanced LIGO detectors in the O2 science run in August of the same year. The upgraded detector was approximately twice as sensitive to binary neutron star mergers as the first-generation instrument. During …