Search results for "nuclear energy"
showing 10 items of 614 documents
Performance improvement of a novel combined water turbine
2020
Abstract Nowadays, industrials and researchers are looking for renewable energy resources due to the increase of energy demand. Recently, the ability of combined turbines in harnessing energy from water current has increased their renewed interest. However, there still exist a big knowledge gap to select the optimal design of these turbines. In this paper, systematic studies of stand-alone helical Savonius and delta bladed Darrieus turbines were carried out using experimental methods as a precursor to analyze their roles in hybrid configuration. By varying the attachment angle, two hybrid configurations were tested experimentally. Using the optimal attachment angle, six hybrid configuration…
Determination of a pre-heating sequence for the DONES Target Assembly
2021
Abstract Within the activities promoted by the EUROfusion consortium in support of the design and construction of the DEMO Oriented NEutron Source (DONES), a mock-up of its Target Assembly (TA), based on the configuration with a “bayonet” Back-Plate (BP) and available at ENEA Brasimone labs, is being adopted for the execution of experimental activities aiming at the validation of specific aspects of the target design. Despite the “integral”-TA concept is the current reference, experimental tests concerning the TA pre-heating phase are not significantly affected by the TA concept and are still representative even though conducted on the bayonet-TA concept. Indeed, the main objective of the p…
Matching Economical, Energetic and Environmental Benefits: An Analysis for Hybrid CHCP-Heat Pumps Systems
2006
Abstract The optimization of design and operation of combined heat, cooling and power systems usually leads to select different plant lay-outs and size of components, depending on the adopted optimization criterion (maximum profit or energy saving or minimum environmental impact). This occurs when the current energy prices and the normative provisions supporting cogeneration are not able to coincide with the specific customer’s interest and the overall “social interest” for a reduction in energy consumption and in pollutants’ emissions. At EU level, polygeneration is considered to have a large potential for residential and commercial buildings district network, for the tertiary sector and f…
Multiphysics Optimization for First Wall Design Enhancement in Water-Cooled Breeding Blankets
2021
Abstract The commercial feasibility of the first fusion power plant generation adopting D-T plasma is strongly dependent upon the self-sustainability in terms of tritium fuelling. Within such a kind of reactor, the component selected to house the tritium breeding reactions is the breeding blanket, which is further assigned to heat power removal and radiation shielding functions. As a consequence of both its role and position, the breeding blanket is heavily exposed to both surface and volumetric heat loads and, hence, its design requires a typical multiphysics approach, from the neutronics to the thermo-mechanics. During last years, a great deal of effort has been put in the optimization of…
Optimization of trigeneration systems by Mathematical Programming: Influence of plant scheme and boundary conditions
2015
Abstract The large potential for energy saving by cogeneration and trigeneration in the building sector is scarcely exploited due to a number of obstacles in making the investments attractive. The analyst often encounters difficulties in identifying optimal design and operation strategies, since a number of factors, either endogenous (i.e. related with the energy load profiles) and exogenous (i.e. related with external conditions like energy prices and support mechanisms), influence the economic viability. In this paper a decision tool is adopted, which represents an upgrade of a software analyzed in previous papers; the tool simultaneously optimizes the plant lay-out, the sizes of the main…
Exergetic and exergoeconomic analysis of a novel hybrid solar-geothermal polygeneration system producing energy and water
2016
Abstract A dynamic simulation model of a novel solar–geothermal polygeneration system and the related exergetic and exergoeconomic analyses are presented in this paper. The plant is designed in order to supply electrical, thermal and cooling energy and fresh water for a small community, connected to a district heating and cooling network. The hybrid system is equipped with an Organic Rankine Cycle fueled by medium-enthalpy geothermal energy and by a Parabolic Trough Collector solar field. Geothermal brine is also used for space heating and cooling purposes. Finally, geothermal fluid supplies heat to a Multi-Effect Distillation unit, producing also desalinized water from seawater. Dynamic si…
Erosion and screening of tungsten during inter/intra-ELM periods in the JET-ILW divertor
2020
Abstract Intra-ELM tungsten sources, which dominate the total W source, are quantified in the inner and outer divertor of JET-ILW. The amount of the sputtered W atoms for individual ELMs demonstrates a clear dependence on the ELM frequency. It decreases when the pedestal temperature is lower and, correspondingly, the ELM frequency is higher. Nevertheless, the entire gross erosion W source (the number of eroded W atoms per second due to ELMs) increases initially with ELM frequency and reaches its maximum at fELM ≈ 50–55 Hz followed by its reduction in the high frequency range. The in/out asymmetry of the intra-ELM W sources during ELMs is a critical issue and is investigated in this contribu…
Applications of the X-ray fluorescence analysis to the cultural patrimony of the Comunidad Valenciana (Spain): Painting, metal and paper
1999
We present examples of the application of the X-ray fluorescence (XRF) to the study of the artistic and cultural patrimony of the Comunidad Valenciana in the following areas: a) Valencian paintings of the XV and XVI centuries; b) silver ornaments coming from Iberian towns (s. III b.C.); c) ink and paper samples in manuscripts and engravings of the XVII and XIX centuries. The non destructive analyses are carried out “in situ” using a XRF system that consists of a tube of X-rays of 50 kV and 1 mA, and a detector of Si(Li) with an energy resolution 140 eV (FWHM at 5.9 keV).
Impurity analysis of JET DiMPle pulses
2021
Divertor monitoring pulses (DiMPle) have been run in JET from the C35 campaign onwards. They provide an opportunity to study the impurity contamination of the plasma when it is limited by different surfaces within the machine, as well as the longer term behaviour of the impurities. In these discharges the plasma is first limited on the outer wall, then on the inner wall and, subsequently, in the X-point configuration the outer strike point is positioned on the horizontal tile 5 of the machine followed by tile 6 and then the vertical tile 7. The present study details the impurity behaviour in the DiMPle pulses from JET-ILW campaigns C35 to C38, which ran from 2015 to 2019. The impurities can…
On thermo-mechanical issues induced by irradiation swelling inside the back-plate of the IFMIF target assembly
2011
Abstract Within the framework of the IFMIF R&D program and in close cooperation with ENEA-Brasimone, at the Department of Nuclear Engineering of the University of Palermo a research campaign has been launched to investigate the thermo-mechanical issues potentially induced by irradiation swelling in the threaded connections between frame and back-plate of IFMIF target assembly. The main aim of the research campaign has relied in the assessment of the maximum swelling-induced volumetric strain that may be accepted in order to allow screws to withstand thermo-mechanical stresses and work in safe conditions or to avoid unduly high unscrewing torques during back-plate remotely handled maintenanc…