Search results for "on-line"

A narrowband MIMO car-to-car channel model based on the geometrical street scattering model

2012

In this paper, we model a narrowband multiple-input multiple-output (MIMO) car-to-car (C2C) channel model based on the geometrical street scattering model. Starting from the geometrical model, a MIMO reference channel model is derived under the assumption of single-bounce scattering in line-of-sight (LOS) and non-LOS (NLOS) propagation environments. In the proposed channel model, an infinite number of scatterers are uniformly distributed in rectangular grids located on both sides of the street. Analytical solutions are presented for the three-dimensional (3D) space-time cross-correlation function (CCF), the temporal autocorrelation function (ACF), and the two-dimensional (2D) space CCF. An …

LCRT: A ToA Based Mobile Terminal Localization Algorithm in NLOS Environment

2009

©2009 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE. Article also available from publisher: http://dx.doi.org/10.1109/VETECS.2009.5073644 Non line-of-sight (NLOS) propagation in range measurement is a key problem for mobile terminal localization. This paper proposes a low computational residual test (LCRT) algorithm that can identify the number of line-of-sight (LOS) transmissions and reduce the computational com…

NON-LINEAR INDUCTOR CONTRIBUTION TO HARMONIC SPECTRUM IN POWER CONVERTERS

The paper investigates the harmonic content in DC/DC power converters where the inductor is operated in the non-linear region. This operation is often exploited to use lighter and cheaper inductors; as a drawback, an increasing number of harmonics is noticeable. A theoretical analysis is proposed. It is based on a polynomial model of the inductor used in a boost converter. Results are given by the spectra of the output voltage performed on a circuit prototype.

Self-Heating Induced Instability of a Non-Linear Inductor in a SMPS: a Case Study

2023

This paper proposes a case study to show that the non-linear operation of a power inductor in a SMPS can induce instability of the control system leading to overheating of the inductor beyond its allowable temperature and to an excessive peak of the maximum current. The case study is performed by a commercial ferrite inductor employed in a synchronous boost converter encompassing a control system to adjust the duty cycle, assuring a constant output voltage. The thermal transient is described by the time domain waveforms and thermal images.

Sensorless induction machine drive for fly-wheel generation unit based on a TLS-based non-linear observer

2016

This paper proposes a sensorless technique for an induction machine Flywheel Energy Storage System (FESS) based on a non-linear observer integrated with a total least-squares speed estimator taking into consideration the IM (Induction Machine) saturation effects. The nonlinear observer is based on an original formulation of the dynamic model of the IM including the magnetic saturation, rearranged in a space-state form, after assuming as state variables the stator current and the rotor magnetizing current space-vectors in the stator reference frame. The choice of the observer gain has been made by the use of Lyapunov's method. The speed signal needed by the non-linear observer for the flux e…

Dissipative connections of rc frames with prefabricated steel-trussed-concrete beams

2020

In the last thirty years, Hybrid Steel-Trussed Concrete Beams (HSTCBs) have been widely used in civil and industrial constructions and, therefore, their mechanical performance must be evaluated with the aim of guaranteeing adequate dissipation of the seismic energy particularly in the beam-to-column joints. However, one of the most frequent peculiarities of HSTCBs is that of using their own steel joist to cover large spans with reduced depth and, in the case of traditional beam-to-column connections, this requires large amount of steel reinforcement inside the panel zone, often made with large diameter rebars. These characteristics make both the panel zone and the beam end potentially vulne…

The development and status of the IGISOL technique

1997

Abstract The development of the IGISOL technique since its earliest beginnings at the University of Jyvaskyla in the early '80s is reviewed. The processes involved in ion survival in the ion guide are discussed. The design and performance of ion guides for different types of reactions is summarised. The mass-separated beam quality for different skimmer systems is compared.

A collision timing monitor for SuperKEKB

2017

Abstract The analysis of beamstrahlung radiation, emitted from a beam of charged particles due to the electromagnetic interaction with a second beam of charged particles, provides a diagnostic tool that can be used to monitor beam–beam collisions in a e + e − storage ring. In this paper we show that the beamstrahlung time profile is related to the timing of the collisions and the length of the beams, and how its measurement can be used to monitor and optimize collisions at the interaction point of the SuperKEKB collider. The method has a unique passive monitor capability, since it allows to monitor the timing of the collision without disturbing (scanning) the beam–beam timing, which needs t…

A linear radiofrequency ion trap for accumulation, bunching, and emittance improvement of radioactive ion beams

2000

An ion beam cooler and buncher has been developed for the manipulation of radioactive ion beams. The gas-filled linear radiofrequency ion trap system is installed at the Penning trap mass spectrometer ISOLTRAP at ISOLDE/CERN. Its purpose is toaccumulate the 60-keV continuous ISOLDE ion beam with high efficiency and to convert it into low-energy low-emittance ion pulses. The efficiency was found to exceed 10\,\% in agreement with simulations. A more than 10-fold reduction of the ISOLDE beam emittance can be achieved. The system has been used successfully for first on-line experiments. Its principle, setup and performance will be discussed. An ion beam cooler and buncher has been developed fo…

First application of the Laser Ion Source and Trap (LIST) for on-line experiments at ISOLDE

2012

The Laser Ion Source and Trap (LIST) provides a new mode of operation for the resonance ionization laser ion source (RILIS) at ISOLDE/CERN, reducing the amount of surface-ionized isobaric contaminants by up to four orders of magnitude. After the first successful on-line test at ISOLDE in 2011 the LIST was further improved in terms of efficiency, selectivity, and reliability through several off-line tests at Mainz University and at ISOLDE. In September 2012, the first on-line physics experiments to use the LIST took place at ISOLDE. The measurements of the improved LIST indicate more than a twofold increase in efficiency compared to the LIST of the 2011 run. The suppression of surface-ionize…