Search results for "paper industry"
showing 10 items of 413 documents
Improvement of Biomass Gasification/Combustion Characteristics by Microwave Pretreatment of Biomass Pellets
2021
Treatment of high strength industrial wastewater with membrane bioreactors for water reuse: Effect of pre-treatment with aerobic granular sludge on s…
2019
Abstract In this study, the treatment of citrus wastewater with membrane bioreactors (MBRs) under different configurations was investigated for water reuse. In particular, one MBR and one aerobic granular sludge MBR (AGS + MBR) bench scale plants were operated for 60 days. The experimental campaign was divided into two periods. In Phase I, a conventional hollow fiber MBR was employed for the treatment of the raw high strength wastewater, whereas in Phase II a combination of in-series reactors (AGS + MBR) was adopted for the treatment of the high strength citrus wastewater The results demonstrated that both plant configurations enabled very high COD removal, with average values close to 99%.…
Struvite precipitation assessment in anaerobic digestion processes
2008
Struvite precipitation causes important operational problems during the sludge treatment process, especially when EBPR sludge is treated. Predicting struvite formation is critical to be able to design process alternative that best minimises struvite precipitation. With this aim, phosphorus precipitation in an anaerobic digestion pilot plant was studied using experimental data and mass balance analysis. The results obtained showed significant phosphorus precipitation as struvite (58% of the fixed phosphorus) and a low precipitation of calcium phosphates (15%), forming mainly hydroxyapatite (HAP). The rest of the phosphorus fixed in the digester (27%) was attributed to adsorption processes on…
Technological Transformation in the Global Pulp and Paper Industry : Concluding Remarks
2018
The volume has provided us with illustrative, well-documented case studies of technological transformation in the global pulp and paper industry. The research has focused on the roles played by the availability of technology, knowledge, investments, and raw materials on the one hand and demand characteristics on the other, within local, regional, national and transnational organisational frameworks. It has dealt with the relationships between technology transfer, technology leadership, raw material dependence, and product variety on a global scale. The investigation has followed the tradition of in-depth and rich historical descriptions based on primary sources and secondary literature. The…
Technological Transformation in the Global Pulp and Paper Industry : Introduction
2018
At a high level of abstraction, the evolution of any industry is a function of changes in product market demand, availability and supply of capital, energy resources, raw materials knowledge and technology, the surrounding institutional framework and organisational solutions. New technological innovations emerge because of changes in product market demand or institutional framework that encourage entrepreneurs and firms to take advantage of new business opportunities. This contributed volume provides illustrative, well documented case studies of technological transformation in the global pulp and paper industry from the inception of mechanical papermaking in early nineteenth century Europe …
NMR Study of Kraft Pulp Mill Waste and Natural Humic Substances
1988
High field proton NMR spectroscopy in DMSO-d6 solution is applied for structural analysis of main high molecular fractions of natural humus and waste lignin from kraft pulp mill. The spectra are similar in great part. Main differences appear in p-disubstituted benzene proton and -CH2 -CO-proton signals which are absent in spectrum of waste lignin obviously due to chlorination. A new observation of 51 Hz 1:1:1 triplet in both spectra is discussed.
Alkylated dibenzothiophenes in pine needles from pulp and paper mill environment
1998
Abstract Concentrations of alkylated dibenzothiophenes (C n DBTs) in pine needles in a recipient area of the emissions from a pulp and paper mill where also waste combustion was done were measured. The concentrations (ng/g dry weight) of C 1 DBTs were in the range of 2 DBTs in the range of 3 DBTs in the range of 3 DBTs] > [C 2 DBTs] > [C 1 DBTs]. The pulp mill could not be shown to be the source of C 1 C 3 DBTs in the pine needles. Other possible sources are situated in the vicinity of the pulp and paper mill. Long-range transport, either, cannot be excluded as a possible source.
Transport of high molecular mass lignin material in the receiving water system of a mechanical pulp mill
1998
High molecular mass material (HMM) of water samples collected from the receiving water system of a mechanical pulp mill was characterized applying cupric oxide oxidation combined with GC and HPLC analysis of the oxidation products. This qualitative method was used to follow the transport of organic HMM discharged by the mill. The interpretation of results was complicated by degradation reactions of HMM in the water system and the assimilation of HMM produced by the mill to natural humic compounds. The analytical data was subjected to the principal component analysis (PCA) to verify the results obtained.
The Evolution of Pulp and Paper Industries in Finland, Sweden, and Norway, 1800–2005
2012
In this chapter, we study Finland, Sweden and Norway as examples of countries with small firm populations without intense domestic competition. This has enabled firms to build certain organizational capabilities while neglecting others. The basic story-line in the Nordic paper industry evolution is that a few firms that emerged as industrial populations were (a) built on to exploit abundant raw materials (timber, water, labor); (b) focused to a large extent on exporting their products; and (c) relied on cooperation between competitors to success in competition with the large firms populations of Britain and Germany – the two main markets for Nordic paper industry products.
Changes in water quality in Lake Päijänne following decrease of effluent load from the pulp and paper industry in 1969–1989
1992
Lake Paijanne, the second largest lake in Finland, has been seriously polluted since the 1960s due to the effluents from pulp and paper mills, notably the Aanekoski sulphate and sulphite pulp mills situated about 50 km north of the lake, and the sulphite pulp mill and paper mills of Jamsankoski and Kaipola on Central Lake Paijanne.