Search results for "phantom"
showing 10 items of 196 documents
Eine Kombination niedrig und hochauflösender dynamischer T1-gewichteter Sequenzen zur besseren Beurteilung der Morphologie Kontrastmittel aufnehmende…
2002
Purpose: Presentation of a new protocol for simultaneous acquisition of both low and high resolution T 1 -weighted images of breast lesions for dynamic contrast-enhanced MR mammography. Demonstration of possible diagnostic improvement with representative measurements in patients with suspected breast cancer by adding morphologic parameters from high resolution sequences to the analysis of the signal-time curve. Materials and Methods: Dynamic MR imaging was performed with a 1.5 T system (Magnetom SONATA, Siemens Medical Systems, Germany) and the manufacturer's double-breast coil. Coronal T 1 -weighted 3D FLASH sequences (spatial resolution 1.25 ×1.25 mm 2 ; slice thickness 1.7 mm) were acqui…
Role of ambient light in the detection of contrast elements in digital dental radiography.
2018
Objective This study aimed to evaluate the effect of different ambient light levels on observer detection of small contrast differences in a contrast phantom by using a high-end liquid crystal display (LCD) monitor. Study Design An aluminum step wedge was converted into a contrast phantom by the addition of bore holes. Radiographic images of the contrast elements were presented to 20 observers. Images were displayed in random order under different ambient light levels (0, 50, 200, and 500 lux) twice, and the observers had to determine if contrast elements were visible. Sensitivity and specificity were determined to calculate areas under receiver operating characteristic curves and Friedmann…
209 New Fricke gel with high sensitivity and low diffusion for 3D-MRI dosimetry
2018
Purpose Fricke gel (FG) dosimeters are good candidates for 3D dose assessment in biological materials. Their effective atomic number and density are similar to those of soft tissue. In view of their chemical and morphological characteristics, FG serve as dosimeters and as phantoms at the same time. FG dosimeters are obtained by incorporating an acidic aqueous solution of ferrous ions Fe2+ into a gel matrix. In order to address the limitations of gels based on natural matrices, we have studied FG produced with a matrix of poly-vinyl alcohol (PVA) cross-linked with glutaraldehyde (GTA). Materials and methods The proposed gel contains 10% w/v of PVA and GTA of 1%w/v. A common formulation agaro…
Erratum: “TG-43 U1 based dosimetric characterization of model 67-6520 Cs-137 brachytherapy source”
2012
Purpose: Brachytherapy treatment has been a cornerstone for management of various cancer sites, particularly for the treatment of gynecological malignancies. In low dose rate brachytherapy treatments,C137s sources have been used for several decades. A new C137s source design has been introduced (model 67-6520, source B3-561) by Isotope Products Laboratories (IPL) for clinical application. The goal of the present work is to implement the TG-43 U1 protocol in the characterization of the aforementioned C137s source. Methods: The dosimetriccharacteristics of the IPLC137s source are measured using LiF thermoluminescent dosimeters in a Solid Water™ phantom material and calculated using Monte Carl…
Technique for routine output verification of Leipzig applicators with a well chamber
2005
The H-type Leipzig applicators are accessories of the microSelectron-HDR system (Nucletron, Veenendaal, The Netherlands) for treatment of superficial malignancies. Recently, the dose rate distributions in liquid water for the whole set of applicators using both source models available for the microSelectron-HDR afterloaders have been obtained by means of the experimentally validated Monte Carlo (MC) code GEANT4. Also an output table (cGy/hU) at 3 mm depth on the applicator central axis was provided. The output verification of these applicators by the user, prior to their clinical use, present practical problems: small detectors such as thermoluminescent dosimeters or parallel-plate ionizati…
A concept for a magnetic particle imaging scanner with Halbach arrays
2020
Magnetic particle imaging (MPI) is a new medical imaging technique visualizing the concentration distribution of superparamagnetic nanoparticles used as tracer material. MPI is not yet in clinical routine, since one of the challenges is the upscaling of scanners. Typically, the magnetic fields of MPI scanners are generated electromagnetically, resulting in an immense power consumption but providing high flexibility in terms of adjusting the field strengths and very fast image acquisition rates. Permanent magnets provide high flux densities and do not need any power supply. However, the flux density is not adjustable, and a mechanical movement is slow compared to electromagnetically varying …
Compensation of missing wedge effects with sequential statistical reconstruction in electron tomography.
2014
Electron tomography (ET) of biological samples is used to study the organization and the structure of the whole cell and subcellular complexes in great detail. However, projections cannot be acquired over full tilt angle range with biological samples in electron microscopy. ET image reconstruction can be considered an ill-posed problem because of this missing information. This results in artifacts, seen as the loss of three-dimensional (3D) resolution in the reconstructed images. The goal of this study was to achieve isotropic resolution with a statistical reconstruction method, sequential maximum a posteriori expectation maximization (sMAP-EM), using no prior morphological knowledge about …
Multimodal user interface for a semi-robotic visual assistance system for image guided neurosurgery
2005
Abstract We developed a visual assistance system for image guided neurosurgery, consisting of a stereoscopic digital camera (exoscope) mounted on a semi-robotic manipulator. In order to minimize the operation time, the application-specific multimodal user interface enables hands-free manipulation of the exoscope. The surgeon wears thereby a head-mounted unit with a binocular display, a head tracker, a microphone and earphones. Different modes of view positioning and adjustment can be selected by voice and controlled by head rotation while pressing a miniature confirmation button mounted on a finger ring or suction device. Apart from the development of the mechatronic and software modules of…
Unsupervised tissue classification of brain MR images for voxel-based morphometry analysis
2016
In this article, a fully unsupervised method for brain tissue segmentation of T1-weighted MRI 3D volumes is proposed. The method uses the Fuzzy C-Means (FCM) clustering algorithm and a Fully Connected Cascade Neural Network (FCCNN) classifier. Traditional manual segmentation methods require neuro-radiological expertise and significant time while semiautomatic methods depend on parameter's setup and trial-and-error methodologies that may lead to high intraoperator/interoperator variability. The proposed method selects the most useful MRI data according to FCM fuzziness values and trains the FCCNN to learn to classify brain’ tissues into White Matter, Gray Matter, and Cerebro-Spinal Fluid in …
The effect of body shape and gender on wireless Body Area Network on-body channels
2010
Technological advancements have made possible the emergence of Body Area Networks (BANs). There are numerous on-body channel characterizations in the literature performed on a phantom or a single human subject. In this paper, using multiple subjects, we consider the effect of body shape and gender on the on-body channel. A characterization of a narrowband on-body to on-body channel among different subjects is presented. The paper investigates the relationship between the propagation and the subject's physical characteristics. The investigation is performed at 2360 MHz; the new medical band undergoing FCC approval. Our results show that the path loss in women is less than that in men and the…