Search results for "phosphorus removal"
showing 10 items of 39 documents
Optimisation of sludge line management to enhance phosphorus recovery in WWTP
2008
The management of the sludge treatment line can be optimized to reduce uncontrolled phosphorus precipitation in the anaerobic digester and to enhance phosphorus recovery in WWTP. In this paper, four operational strategies, which are based on the handling of the prefermented primary sludge and the secondary sludge from an EBPR process, have been tested in a pilot plant. The separated or mixed sludge thickening, the use of a stirred contact tank and the elutriation of the thickened sludge are the main strategies studied. Both the reduction of phosphorus precipitation in the digester and the supernatant suitability for a struvite crystallization process were assessed in each configuration. The…
Relating ions concentration variations to conductivity variations in a sequencing batch reactor operated for enhanced biological phosphorus removal
2006
In this paper a deterministic relationship between ionic conductivity and phosphorus concentration variations in an enhanced biological phosphorus removal (EBPR) process is established. Conductivity shows a strong correlation with phosphorus in both anaerobic and aerobic stages, increasing or decreasing when phosphorus is released or taken up, respectively. Since the end of these processes can be detected by examining the conductivity profile in a cycle, useful information on the EBPR performance and stability is available. This information can be used for adjusting the length of the anaerobic and aerobic stages. Therefore, online process control based on inexpensive and easy to maintain se…
Carbon and nutrient biological removal in a University of Cape Town membrane bioreactor: Analysis of a pilot plant operated under two different C/N r…
2016
Abstract The effect of the carbon-to-nitrogen (C/N) ratio variation in a University of Cape Town Membrane bioreactor (UCT-MBR) was investigated. The experimental campaign was divided into two phases, each characterized by a different C/N ratio (namely, 10 and 5, Phase I and Phase II, respectively). The UCT-MBR pilot plant was analysed in terms of carbon and nutrients removal, biomass respiratory activity, activated sludge features and membrane fouling. The results highlighted that the nutrients removal was significantly affected by the decrease of the C/N ratio during the Phase II. The biological carbon removal was also affected by the low C/N value during the Phase II. Indeed, the average …
The metabolic versatility of PAOs as an opportunity to obtain a highly P-enriched stream for further P-recovery
2015
The effects of two sequencing batch reactor operation strategies for phosphorus stream enrichment over the biological phosphorus removal performance have been studied. The objective of both strategies is of performing an extraction cycle in order to obtain a new stream highly enriched with phosphorus. In the 1st strategy the amount of influent volatile fatty acids (VFAs) is the same in each cycle; while in the 2nd strategy the influent VFAs concentration is increased during phosphorus extraction experiments. Despite the strong decrease of the stored poly-P inside the cells in both strategies after the recovery cycles, the ability of the systems to remove phosphorus was not affected. The P-r…
Evaluation of activated sludge model no.2 at high phosphorus concentrations
2001
This paper presents laboratory scale experimentation carried out to study enhanced biological phosphorus removal at high phosphorus concentrations in a sequencing batch reactor. Four series of data obtained in a sequencing batch reactor are examined in light of the Activated Sludge Model No. 2. This model was calibrated using data from the first and second series working at low phosphorus concentrations. The Activated Sludge Model No. 2 successfully characterised the enhanced biological phosphorus removal performance of the sequencing batch reactor at low phosphorus concentrations. The calibrated model was then used to adjust experimental results of the other series working at high phosphor…
Modelling biological and chemically induced precipitation of calcium phosphate in enhanced biological phosphorus removal systems
2011
The biologically induced precipitation processes can be important in wastewater treatment, in particular treating raw wastewater with high calcium concentration combined with Enhanced Biological Phosphorus Removal. Currently, there is little information and experience in modelling jointly biological and chemical processes. This paper presents a calcium phosphate precipitation model and its inclusion in the Activated Sludge Model No 2d (ASM2d). The proposed precipitation model considers that aqueous phase reactions quickly achieve the chemical equilibrium and that aqueous-solid change is kinetically governed. The model was calibrated using data from four experiments in a Sequencing Batch Rea…
Struvite precipitation assessment in anaerobic digestion processes
2008
Struvite precipitation causes important operational problems during the sludge treatment process, especially when EBPR sludge is treated. Predicting struvite formation is critical to be able to design process alternative that best minimises struvite precipitation. With this aim, phosphorus precipitation in an anaerobic digestion pilot plant was studied using experimental data and mass balance analysis. The results obtained showed significant phosphorus precipitation as struvite (58% of the fixed phosphorus) and a low precipitation of calcium phosphates (15%), forming mainly hydroxyapatite (HAP). The rest of the phosphorus fixed in the digester (27%) was attributed to adsorption processes on…
Biological nitrogen and phosphorus removal in membrane bioreactors: model development and parameter estimation
2012
Membrane bioreactors (MBR) are being increasingly used for wastewater treatment. Mathematical modeling of MBR systems plays a key role in order to better explain their characteristics. Several MBR models have been presented in the literature focusing on different aspects: biological models, models which include soluble microbial products (SMP), physical models able to describe the membrane fouling and integrated models which couple the SMP models with the physical models. However, only a few integrated models have been developed which take into account the relationships between membrane fouling and biological processes. With respect to biological phosphorus removal in MBR systems, due to th…
Uncertainty of a biological nitrogen and phosphorus removal model
2010
In the last few years, the use of mathematical models in wastewater treatment plant (WWTP) processes has become a common way to predict WWTP behaviour. However, mathematical models generally demand advanced input for their implementation that must be evaluated by an extensive data gathering campaign, which cannot always be carried out. This fact, together with the intrinsic complexity of the model structure, leads to model results that may be very uncertain. Quantification of the uncertainty is imperative. However, despite the importance of uncertainty quantification, only a few studies have been carried out in the wastewater treatment field, and those studies only included a few of the sou…
Effect of pH on biological phosphorus uptake.
2006
An anaerobic aerobic laboratory scale sequencing batch reactor (SBR) was operated to study the effect of pH on enhanced biological phosphorus removal. Seven steady states were achieved under different operating conditions. In all of them, a slight variation in the pH value was observed during anaerobic phase. However, pH rose significantly during aerobic phase. The increase observed was due to phosphorus uptake and carbon dioxide stripping. When pH was higher than 8.2-8.25 the phosphorus uptake rate clearly decreased. The capability of Activated Sludge Model No. 2d (ASM2d) and Biological Nutrient Removal Model No. 1 (BNRM1) to simulate experimental results was evaluated. Both models success…