Search results for "photovoltaic"
showing 10 items of 646 documents
Higher PV Module Efficiency by a Novel CBS Bypass
2011
There is an increasing focus on reducing costs and improving efficiency for photovoltaic (PV) cells and modules as well as finding a more efficient approach to the product manufacturing. This letter introduces an innovative solution to bypass shaded PV cells instead of a traditional Schottky diode, in order to avoid overheating of cells in the case of partial shading. The goal is to reduce the power dissipation and improve the general efficiency of a PV generator. A novel device called cool bypass switch is then presented. It is made up of a Power MOS driven by a controller with the task to charge a storage capacitor. Tests and comparisons with standard Schottky diodes are then performed an…
A photovoltaic system suitable for the battery pack charging of an electrically power assisted velocipede
2012
The paper describes the designing, sizing, realization and setting up of a complete system suitable for the management of an electrically power assisted velocipede using a photovoltaic module for the charging of the batteries. In the work an overview on the sustainable mobility needs and on the commercial electrically power assisted velocipedes is presented and the "Ecolapa" prototype, set up in the SDELab laboratory of Palermo University, is precisely described underlining the designing, implementation and setting up phases of the photovoltaic charging system settled up on the velocipede. Moreover tests oriented on the setting up of the whole system and validation tests on the prototype ar…
Technical, Environmental and Economical Aspects of Hybrid Systems Including Renewables and Fuel Cells
2006
In this paper, some configurations including renewables and fuel cells are studied. Technical, environmental and economical aspects are treated in the frame of the EU regulations concerning the ‘emission trading’ issue and the way in which Italy has implemented the relevant EU directive. The study has been carried out considering some architectures including renewables such as photovoltaic and wind with a back up system to increase continuity of supply based on the application of fuel cells and of a hydrogen storage system. Performing several runs with different values of the cost of energy (COE) bought from the network and produced with traditional fuel, it has been observed that, for some…
A DC-DC power converter for PV module characterization
2014
In this paper, a standard-compliant electronic load setup for PV module curve detection which features high accuracy, low cost and components count is proposed. The proposed device is based on a DC-DC power converter in open-loop configuration. The proposed system is designed according to regulation constraints in order to achieve high performances in curve detection. Design criteria are discussed. The model is implemented in PSIM environment. Simulation based on data input of a commercial PV Conergy E215P module are carried out under several environmental conditions to show the accuracy of the proposed electronic load. Simulation results are reported.
Numerical Analysis of Medium Scale PV Plants and Their Power-Flow Control System With a Simple Three Phase Inverter
2012
This paper presents a mathematical analysis of a medium scale Photovoltaic (PV) power generation system connected to the distribution network and of its control system, in which the conversion stage is unique thanks to the absence of a boost chopper. Boost choppers are usually used as actuator for maximum power point tracking (MPPT). The conducted analysis leads to the conclusion that the used inverter presents two degrees of freedom that can be easily exploited in a control system in which the inverter simultaneously realizes the interconnection to the grid and at the same time realizes the MPPT control. The structure of the control system is then presented, discussed and then validated by…
Dynamics photovoltaic generators: Technical aspects and economical valuation
2010
The strategy adopted from many European nations and not, to entrust the electric energy production to differently energetic sources has determined an increment of the scientific research for the solar resource exploitation. These scientific community activities follows with attention from the entrepreneurial world have concentrated on the innovative techniques and methodologies of the source conversion, solar concentration and the direction's device optimization. This job focuses its attention on the simple application of solar-track device, based on consolidated technologies. The diffused application of these dispositive, could be, shortly, an important increment of electricity generation …
Survey on power increase of power by employment of PV reconfigurator
2015
This paper shows the performance of a PV system under shadow projection on PV panels. The reconfiguration techniques, employing a microprocessor-based system, modifies the layout of the PV plant by physically changing the connections among modules, in order to recover the loss of power due to the shadows. Different cases have been considered to evaluate the increase of power.
Distribution grid analysys through PSAT open source tools
2015
In this paper a study of an electrical distribution grid with presence of renewable energy sources performed using the Power System Analysis Tool is presented. The paper describes the load flow analysis of a real existing grid owned by the Italian DSO “ENEL Distribuzione SpA” and located in an urban area.
Green Data Centres providing ancillary services to power grid
2015
This work investigates the possibility for a Data Centre to provide services to the Grid. In particular, the paper simulates a sudden shift of frequency because of a power decrease and estimates how a real-life Data Centre can contribute the secondary frequency regulation.
Nanotechnology for Photovoltaic Cells and Energy Efficiency
2015
Abstract. The intent of this paper is to connect science and technology in order to demonstrate how, in the field of on photovoltaic technologies, thin film solar cells have been the focus of many research facilities in recent years that are working to decrease manufacturing costs and increase cell efficiency. New research suggests that it might be possible to add a nanoscopic relief pattern to the surface of solar cells that makes them non-reflective significantly boosting efficiency and at the same time making them highly non-stick and self-cleaning. The paper presents the challenges and approaches to engineer the active layer of the cell, in order to obtain cells made up of components as…