Search results for "polymerization"

TASK SPECIFIC IONIC LIQUIDS: CATALIZZATORI ECOCOMPATIBILI PER LA DEPOLIMERIZZAZIONE DELLE PLASTICHE

Fluorimetric determination of 1-naphthol and mixtures of carbaryl and 1-naphthol in micellar media

1990

The interaction of 1-naphthol with different types of anionic, cationic and non-ionic surfactants has been studied spectrofluorimetrically in order to obtain a sensitivity enhancement in the determination of this compound. At neutral pH, cetyl trimethyl ammonium bromide (CTAB) provides a 2-fold sensitivity enhancement of 1-naphthol and exhibits a weak interaction with carbaryl. In strong alkaline medium carbaryl is hydrolyzed to 1-naphthol and in the presence of CTAB micells, a 5-fold sensitivity enhancement and a limit of detection of 0.2 μg·ml−1 with a 101±3% percentage of recovery is obtained. These facts permit the development of an accurate method for the fluorimetric analysis of 1-nap…

Interaction of diazepam with surfactants. Spectrophotometric and spectrofluorometric study

1986

Abstract The interaction of diazepam with non-ionic, anionic and cationic surfactants has been studied spectrophotometrically and fluorometrically. It has been verified that the absorption spectrum of diazepam is not modified in micellar medium. However, a dramatic five-fold increase in fluorescence sensitivity is observed in the presence of sodium lauryl sulphate (SDS). The experimental conditions, temperature, pH and surfactant concentration have been optimized to improve the fluorometric determination of diazepam and a detection limit of 0,04 ppmhas been obtained.

Chromium speciation using activated alumina microcolumns and sequential injection analysis-flame atomic absorption spectrometry

2001

Abstract A new procedure has been developed for chromium speciation in water by sequential injection analysis and flame atomic absorption spectrometry. The method involves the online retention of Cr(VI) anionic species and Cr(III) cationic species on alumina microcolumns, prepared by packing activated alumina in polytetrafluoroethylene tubes, followed by selective elution of Cr(VI) with 2 mol l −1 NH 4 OH and of Cr(III) with 0.2 mol l −1 HNO 3 . Studies were carried out on the effect of retention and elution conditions for both Cr species. The limit of detection values, established as the concentration corresponding to three times the standard deviation of blank measurements divided by the …

Development of a molecularly imprinted monolithic polymer disk for agitation-extraction of ecgonine methyl ester from environmental water

2019

Abstract In this study, a new extraction approach based on rotating molecularly imprinted polymer (MIP) disks was developed. The preparation procedure of MIP-disk is simple. Firstly, in order to immobilize MIP onto the surface of polytetrafluoroethylene (PTFE) disk, previous modification and vinylization steps of this fluoropolymer were conducted. Then, MIP synthesis was done by in situ polymerization. The resulting MIP was characterized by Fourier-transform infrared spectroscopy and scanning electron microscopy. Afterwards, two ring magnets were placed in the sides of the MIP-disk to integrate the stirring and preconcentration of sample in just one step. To demonstrate the feasibility of t…

In-tube solid-phase microextraction and liquid chromatography using a monolithic column for the selective determination of residual ethylenediamine i…

2009

The selective determination of the diamine ethylenediamine (EDA) in the presence of a higher amount of residual dimethylamine in cationic polymers has been developed. The strategy uses both a solution derivatization with a selective agent of primary amines such as o-phthaldialdehyde-N-acetyl-L-cysteine (OPA-NAC) and an in-tube solid-phase microextraction (IT-SPME) coupled to liquid chromatography (LC). A 70 cm long, 0.32 mm internal diameter, and 3 microm thick commercially available capillary column coated with 95% polydimethylsiloxane and 5% polydiphenylsiloxane was employed to replace the injection loop of a Rheodyne injection valve. A volume of 1 mL of derivatized sample was passed thro…

Simultaneous homogeneous immunoassay of phenytoin and phenobarbital using a Nafion-loaded carbon paste electrode and two redox cationic labels

1997

Abstract The dual-analyte homogeneous immunoassay of two antiepileptic drugs was carried out simultaneously at physiological pH by square-wave voltammetry at a Nafion-loaded carbon paste electrode. Phenobarbital (PB) and phenytoin (DPH) were labeled by a cobaltocenium salt (Cc+) and a ferroceneammonium salt (N+Fc), respectively, and the corresponding standard redox potentials were −1.05 V and 0.26 V. Detection limits of 0.25 and 0.2 μM were achieved for PB-Cc+ and DPH-N+Fc (S/N = 3) after a 5-minute accumulation step, with linear responses over the 0.25–5 and 0.2–5 μM ranges, respectively. The relative standard deviation was evaluated to be ≥ 11% for 1 μM of each labeled drug. The separate,…

Resorcinol Functionalized Gold Nanoparticles for Formaldehyde Colorimetric Detection

2019

[EN] Gold nanoparticles functionalized with resorcinol moieties have been prepared and used for detecting formaldehyde both in solution and gas phases. The detection mechanism is based on the color change of the probe upon the aggregation of the nanoparticles induced by the polymerization of the resorcinol moieties in the presence of formaldehyde. A limit of detection of 0.5 ppm in solution has been determined. The probe can be deployed for the detection of formaldehyde emissions from composite wood boards.

Assessment of Catalysis by Arene‐Ruthenium Complexes Containing Phosphane or NHC Groups bearing Pendant Conjugated Diene Systems

2015

Two p-cymene-ruthenium complexes 1 and 2 were isolated in high yields by treating the [RuCl2(p-cymene)]2 dimer with new hybrid phosphane- or NHC-linked diene ligands. Both complexes were fully characterized by NMR spectroscopy, and the molecular structure of the ruthenium–p-cymene complex 1, containing the phosphane–diene ligand system, was determined by X-ray diffraction analysis. The catalytic activities of both compounds were probed in atom-transfer radical addition (ATRA) and polymerization (ATRP), in the cyclopropanation of olefins, in the ring-opening metathesis polymerization (ROMP) of norbornene, and in the synthesis of enol esters from hex-1-yne and 4-acetoxybenzoic acid.

Atom Transfer Radical Addition Catalyzed by Ruthenium–Arene Complexes Bearing a Hybrid Phosphine–Diene Ligand

2018

International audience; The synthesis and characterization of a series of arene ruthenium complexes bearing either (3,5-cycloheptadienyl)diphenylphosphine or (cycloheptyl)-diphenylphosphine are reported. Upon irradiation or heating, all these complexes lose their arene ligand but then exhibit a different behavior depending on the nature of the phosphine ligand. (Cycloheptadienyl)phosphine complexes 1 and 3 give a cationic dinuclear Ru complex 5 for which the two Ru atoms are bridged by three chlorido ligands and flanked by two tridendate (cycloheptadienyl)phosphines. (Cycloheptyl)-diphenylphosphine complexes 2 and 4 undergo arene exchange when toluene is used as solvent or degrade in dithlo…