Search results for "reduction"

Tabu search algorithms for an industrial multi-product and multi-objective assembly line balancing problem, with reduction of the task dispersion

2002

This paper presents a real-world industrial application of the multi-product and multi-objective assembly line balancing problem, for a company involved in the production of four models of a white goods product. The problem solved is a GALBP-2, with 10 workstations and multiple objectives (to maximize the production rate in order to deal with an increase of the demand forecasted, to reach an equal cycle time of all the models and an equal workload of the different workstations, and finally, to minimize the dispersion of worker tasks on each one of the different models-the common tasks of the different models at the same workstation). The paper presents an integrated approach based on four h…

Frame Based Equipment Medium Access in LTE-U: Mechanism Enhancements and DTMC Modeling

2017

To address the challenge of ever-growing data rate demand and benefit from the popularity of WiFi capability in mobile phones, 3GPP is studying techniques which enable the coexistence of WiFi and LTE in the unlicensed band, known as LTEU. Two flavors of the listen before talk (LBT) principle, referred to as load based equipment (LBE) and frame based equipment (FBE), are recommended by 3GPP. In this paper, we investigate two enhanced FBE mechanisms, i.e., 1) enhanced FBE (E-FBE); and 2) backoff and idle time reduction FBE (BITR-FBE) for the purpose of improving FBE. After presenting the idea of E-FBE, we propose BITR-FBE which can further improve throughput, shorten delay and reduce energy c…

Tuning the photocatalytic activity of bismuth wolframate: Towards selective oxidations for the biorefinery driven by solar-light

2017

The sol–gel entrapment of nanostructured Bi2WO6 enhances the activity and the selectivity of the short-gap semiconductor in the sunlight-driven photo-oxidation of trans-ferulic and trans-cinnamic acid dissolved in water with air as the primary oxidant. Valuable products such as vanillin, benzaldehyde, benzoic acid and vanillic acid are obtained. This provides the proof of concept that photocatalysis could be a promising technology in tomorrow's solar biorefineries.

Rare-earth ion exchanged Cu-SSZ-13 zeolite from organotemplate-free synthesis with enhanced hydrothermal stability in NH3-SCR of NOx

2019

The relatively low hydrothermal stability of Al-rich Cu-SSZ-13 catalysts hinders their practical application in ammonia selective catalytic reduction (NH3-SCR) reaction. Rare-earth ions were introduced into the Al-rich SSZ-13 zeolite using an organotemplate-free synthesis prior to the exchange of Cu2+ ions. Among the rare-earth ions tested (Ce, La, Sm, Y, Yb), Y shows significant enhancement of the hydrothermal stability and NH3-SCR activities after severe hydrothermal aging at 800 °C for 16 h when compared with Cu-SSZ-13 without Y. Cu–Y-SSZ-13 catalysts with various amounts of Y were prepared, and it is found that with increasing Y content, the low temperature NO conversions can be improve…

A simple model for the calculation of the axial load-carrying capacity of corroded RC columns

2015

In the present paper, a simplified model is used to determine the axial load-carrying capacity of compressed short reinforced concrete columns subjected to corrosion processes. The model considers members with circular and square cross-sections and accounts for—cover spalling, —concrete core confinement induced by transverse steel reinforcement, —buckling of longitudinal reinforcing bars. Strength reduction in concrete cover and core due to cracking induced by rust formation, reduction of steel area in longitudinal bars and transverse stirrups due to general and pitting corrosion and loss of confinement pressure are considered. The load-carrying capacity and load-axial strain curves here ge…

Experimental analysis of acoustical properties of irregular cavities using laser refracto-vibrometry

2018

International audience; In this paper, the Scanning Laser Doppler Vibrometer (SLDV) is used to measure acoustic pressure in small regions of cavities for the study of acoustical localization. It is shown that this optical method leads to interesting information on localized acoustical modes inside irregular cavities, which are very difficult to observe using conventional microphone measurements. Indeed, localization regions are often of comparable size or even smaller than a typical microphone which can make this type of sensor intrusive. The SLDV is used to measure sound pressure after deriving the refracto-vibrometry method from its standard use. Data are obtained in a large area with a h…

Three-ring filters increase the effective NA up to 1.46 in optical sectioning fluorescence microscopy

2003

Single-photon fluorescence confocal microscopy techniques can be combined with the use of specific binary filters in order to increase their optical sectioning capability. We present a novel class of axially super-resolving binary pupil filters specially designed to reach this aim. These filters let us to obtain a relevant compression of the z-response together with the reduction of the photo-bleaching effect typically inherent to apodization techniques. The fact of joining both the three-ring filters we propose in the illumination path, and the confocal detection gives rise to an important effective increase of lenses of effective numerical aperture.

Leaded Bronze Alloy as a Catalyst for the Electroreduction of CO 2

2019

Compressive behavior of FRP externally wrapped R.C. column with buckling effects of longitudinal bars

2018

Abstract In this paper, a calculation model to simulate the compressive behavior of R.C. columns with square cross-sections externally wrapped with FRP, including buckling effects of the longitudinal bars and reduction of the confinement pressure induced by the buckled compressed bars, is presented and discussed. The model distinguishes the cases of corner and side bars, calculating the different critical lengths and the critical loads. The Teng et al. (2009) model was adopted to predict the compressive behavior of FRP-confined concrete, and the Dhakal and Maekawa (2002) model was taken into account to predict the compressive behavior of longitudinal bars. The critical length and critical s…

An Investigation into the Stability of Graphitic C 3 N 4 as a Photocatalyst for CO 2 Reduction

2018

The increasing CO 2 concentration in the atmosphere exerts a significant influence on global warming and climate change. The capture and utilization of CO 2 by conversion to useful products is an area of active research. In this work, the photodriven reduction of CO 2 was investigated using graphitic carbon nitride (g-C 3 N 4 ) as a potential photocatalyst. The photocatalytic reduction of CO 2 was investigated with g-C 3 N 4 powder immobilized on a glass support in a batch gas-phase photoreactor. The experiments were carried out under UV-vis irradiation at 70 °C and an initial pressure of 2.5 bar. The only gas-phase product detected during the irradiation of the g-C 3 N 4 in the presence of…