Search results for "reduction"
showing 10 items of 2058 documents
An optimal dimensioning method of a green wall structure for noise pollution reduction
2021
International audience; This paper concern the optimization of a multilayered green wall structure including substrate and foliage in order to reduce as much as possible backward noise reflection and forward transmission from the wall. Each component involved in the wall structure is fully characterized experimentally to get its transfer matrix. Simulation demonstrated that foliage layer superimposed to substrate layer doesn’t affect the transmission losses but contributes greatly to the increase of return losses of the green wall structure. To achieve the best performances in terms of return and forward losses as well as frequency bandwidth, the methods of optimization are discussed inclu…
Deep oxidation of pollutants using gold deposited on a high surface area cobalt oxide prepared by a nanocasting route.
2011
Gold deposited on a cobalt oxide with high surface area (138 m2 g−1), obtained through a nanocasting route using a siliceous KIT-6 mesoporous material as a hard template, has demonstrated high activity for the total oxidation of propane and toluene, and ambient temperature CO oxidation. The addition of gold promotes the activity when compared to a gold-free Co3O4 catalyst prepared using the same nanocasting technique. The enhanced catalytic activity when gold is present has been explained for the deep oxidation of propane and toluene in terms of the improved reducibility of cobalt oxide when gold is added, rather than to the intrinsic activity of metallic gold particles. The improved behavi…
Methane oxidation in a boreal climate in an experimental landfill cover composed from mechanically–biologically treated waste
2007
The present study evaluated microbial methane (CH4) oxidation in a boreally located outdoor landfill lysimeter (volume 112 m3, height 3.9 m) filled with mechanically-biologically treated waste (MBT residual) and containing a cover layer made from the same MBT residual. The calculations based on gas emission and pore gas measurements showed that, between April and October 2005, a significant proportion (96%) of the methane produced (23 l CH4 m(-2) d(-1)) in the lysimeter was oxidized. Methane was oxidized mainly at the depths of 35-75 cm, as indicated by the upward decrease both in the methane concentration and in the methane-to-carbon dioxide ratio in the pore gas. Lower methane oxidation (…
Treatment of leachate from MSWI bottom ash landfilling with anaerobic sulphate-reducing process
2007
Abstract Removal of sulphate and toxic elements from the leachate of a field landfill lysimeter ( 112 m 3 ) , containing municipal solid waste incineration (MSWI) bottom ash, was studied. The leachate was treated in two parallel laboratory upflow anaerobic sludge blanket (UASB) reactors without and with ethanol as additional carbon source. With ethanol more than 65% of sulphate was removed, while without ethanol removal was negligible. The treatment removed Ba, Ca, Cu, Mn, Mo, Ni, Pb, Tl, Sb, Se, Sr, and Zn of the studied 35 trace and other elements. The sequential extraction of the reactor sludge at the end of runs confirmed that with a few exceptions (Ba, Ca, and Cu) the main mechanism by…
Azo-Dyes Photocatalytic Degradation in Aqueous Suspension of TiO2 Under Solar Irradiation
2002
Abstract The photodegradation of two common and very stable azo-dyes, i.e. methyl-orange (C14H14N3SO3Na) and orange II (C16H11N2SO4Na), is reported. The photocatalytic oxidation was carried out in aqueous suspensions of polycrystalline TiO2 irradiated by sunlight. Compound parabolic collectors, installed at the “Plataforma Solar de Almeria” (PSA, Spain) were used as the photoreactors and two identical reacting systems allowed to perform photoreactivity runs for the two dyes at the same time and under the same irradiation conditions. The disappearance of colour and substrates together with the abatement of total organic carbon content was monitored. The main sulfonate-containing intermediate…
Reliable method for assessing the COD mass balance of a submerged anaerobic membrane bioreactor (SAMBR) treating sulphate-rich municipal wastewater
2012
The anaerobic treatment of sulphate-rich wastewater causes sulphate reducing bacteria (SRB) and methanogenic archaea (MA) to compete for the available substrate. The outcome is lower methane yield coefficient and, therefore, a reduction in the energy recovery potential of the anaerobic treatment. Moreover, in order to assess the overall chemical oxygen demand (COD) balance, it is necessary to determine how much dissolved CH4 is lost in the effluent. The aim of this study is to develop a detailed and reliable method for assessing the COD mass balance and, thereby, to establish a more precise methane yield coefficient for anaerobic systems treating sulphate-rich wastewaters. A submerged anaer…
Toward a New Plant-Wide Experimental and Modeling Approach for Reduction of Greenhouse Gas Emission from Wastewater Treatment Plants
2019
Mechanisms causing greenhouse gas (GHG) emission in wastewater treatment plants are of great interest among researchers, encouraging the development of new methods for wastewater management. Wastewater treatment plants (WWTPs) emit three major greenhouse gases during the treatment processes: CO2, CH4, and N2O. Additional amounts of CO2 and CH4 are produced during energy consumption, which can be considered an indirect source of GHGs. Recently, several efforts have been undertaken to assess GHGs from WWTPs, with particular attention paid to the N2O assessment due to its high warming potential (300 times stronger than CO2). This study proposes an integrated model platform for WWTP simulation,…
Uncertainty in urban flood damage assessment due to urban drainage modelling and depth-damage curve estimation
2010
Due to the increased occurrence of flooding events in urban areas, many procedures for flood damage quantification have been defined in recent decades. The lack of large databases in most cases is overcome by combining the output of urban drainage models and damage curves linking flooding to expected damage. The application of advanced hydraulic models as diagnostic, design and decision-making support tools has become a standard practice in hydraulic research and application. Flooding damage functions are usually evaluated by a priori estimation of potential damage (based on the value of exposed goods) or by interpolating real damage data (recorded during historical flooding events). Hydrau…
LUMINESCENCE STUDY OF DETERGENT OPTICAL BRIGHTENERS IN THE CONTEXT OF DEVELOPING OPTICAL ENVIRONMENTAL SENSORS FOR WATER QUALITY CONTROL
2006
Water quality and anthropogenic loads in many, but not all, cases are related. Some water quality monitoring programs analyse samples for the presence of Escherichia coli. These bacteria can come from humans and animals. Human‐attributable effluent contains optical brighteners (OBs) from detergents. A convenient and affordable optical quantitative method giving a linear luminescence outcome over several orders of detergent concentrations in the water solution is demonstrated. The proposed method uses the common presence of OBs in detergents. Detergent concentration in water can be used as a surrogate indicator of resultant anthropogenic loads in water bodies. The proposed optical method wit…
Assessment of computational methods for the analysis of single-cell ATAC-seq data
2019
Abstract Background Recent innovations in single-cell Assay for Transposase Accessible Chromatin using sequencing (scATAC-seq) enable profiling of the epigenetic landscape of thousands of individual cells. scATAC-seq data analysis presents unique methodological challenges. scATAC-seq experiments sample DNA, which, due to low copy numbers (diploid in humans), lead to inherent data sparsity (1–10% of peaks detected per cell) compared to transcriptomic (scRNA-seq) data (10–45% of expressed genes detected per cell). Such challenges in data generation emphasize the need for informative features to assess cell heterogeneity at the chromatin level. Results We present a benchmarking framework that …